粘性流

Finally it analyzes the feasibility that using hydromechanics to analyze traffic flow by contrasting various characters between traffic flow and fluid flow. It analyzes influence of road alignment to basic expressway segment capacity by hydromechanics, and obtains viscous resistance and viscous movement differential equation when the vehicle drives on circular curve segment of expressway. And it infers that viscous resistance is correlated with sideway force coefficient, slope of crown and radius of circular curve. Radius of circular curve, sideway force coefficient and slope of crown are bigger, viscous resistance is smaller, the influence to capacity is smaller when the vehicle is running on nearside lane of circular curve; but radius of circular curve and sideway force coefficient are bigger, slope of crown is smaller, viscous resistance is smaller, the influence to capacity is smaller when the vehicle is running on fast lane of circular curve.

最后通过对比交通流与流体流的相似性，运用流体力学分析了道路线形对快速路基本路段通行能力的影响，求出了车辆在曲线路段的粘性阻力，建立了车辆在曲线路段的粘性运动微分方程，并由此推知，粘性阻力与横向力系数、路拱横坡度和圆曲线半径都有关系，当车辆在圆曲线外侧车道上行驶时，圆曲线半径、横向力系数和路拱横坡度越大，粘性阻力就越小，对道路的通行能力影响就越小；而当车辆在圆曲线内侧车道上行驶时，圆曲线半径和横向力系数越大，路拱横坡度越小，粘性阻力就越小，对道路的通行能力影响就越小。

The results show that the increasing Marangoni number will lead to more nonlinear distribution of temperature field, but streamfunction of the cell center; vorticity on the wall and peak value of velocity diminish first, then increase, finally lose stability. The thermocapillary convection in the whole liquid zone appears to get stronger along with the augmentation of Prantal number. The effect of increasing of Biot number on temperature and flow fields is not obvious although the convection is strengthened a little. As increasing the aspect ratio A, thermocapillary convection induced by temperature gradient and liquid viscosity becomes stronger.

结果表明：温度场的非线性分布随着Ma数的增大而加剧，但对流涡胞中心流函数、壁面涡量和轴向、径向速度峰值并不象温度场随着Ma数的增大而单调增大，而是先减小，然后增大，最后失稳，表明Ma数对热毛细对流的影响比较复杂，针对不同的物理模型，会导致完全不同的流态；Pr数愈大，流体的热扩散能力在粘性扩散与热扩散能力之比中愈占支配地位，当Ma数一定时，热毛细对流随Pr数的增大在整个液体区域内有增强的趋势；Bi数增大，热毛细对流有所增强，但不甚明显；A的增大使得由温度梯度和流体粘性诱导的热毛细对流随之增强。

Computational fluid dynamics method was utilized to the fiowfield numerical simulation of ultrafine stirred mill, the flowfield characters(velocity gradient, shear rate dispersion of flowfield and the dissipative force of viscosity and so on) of three kinds of stirrer(disc type, stick type and spiral type) were analyzed.

利用计算流体力学方法对超细搅拌磨机进行了流场仿真数值模拟，分析了盘式、棒式、螺旋式三种搅拌器的流场特性(速度梯度、流场的剪切率分布和粘性耗散率等)。

The results show that the fluidization characteristics of scrap printed circuit board particles depend on the average size and type of particles. The scrap printed circuit boards particles, belonging to Geldart A group with strong viscous force, whose fluidization was similar to fluidization of Geldart C, was difficult to fluidize. Whereas, the scrap printed circuit board particles belonging to Geldart B can be fluidized smoothly.

实验结果表明，电路板塑料颗粒为Geldart A类颗粒时，粘性力大，塌落特性明显，流化性能较差，具有拟C类颗粒的流化特性；电路板塑料颗粒为B类颗粒时，塌落特征不明显，并且随着粒径的增大，最小流化速度也增大。

FEM equation of fluid-solid coupled vibration was consisted by analyzing FEM equation of incompressible viscosity fluid and elastomer.

通过对弹性体振动的有限元方程和不可压缩粘性流体的有限元方程的分析，建立了弹性体与粘性流体流固耦合的有限元方程。

Rumjantsev used Hamilton's principle with Lagrange's multipliers to generate the dynamical equations of a rigid-fluid coupled system in 1954 and the dynamical equations and their dynamical boundary conditions of a fluid-elastic coupled system in 1969, where the fluid is incompressible and inviscid. In 1990, Liu used Jourdain's principle with Lagrange's multipliers to generate the dynamical equations of a rigidfluid coupled system, where the fluid is incompressible and viscid.

Rumjantsev利用带Lagrange乘子Hamilton变分原理于1954年建立了刚—流耦合系统的动力方程，于1969年建立了流—弹耦合系统的动力方程及其动力边界条件，其中所考虑的流体是不可压无粘液体；Liu利用带Lagrange乘子Jourdain变分原理于1990年建立了刚—流耦合系统的动力方程，其中所考虑的流体是不可压粘性液体。

It is good at both high resistance and low resistance area of debris flows. It is good consistent for the measuring velocity of otherwise field observation data of debris flow and viscous mudflow by this empirical equation.

由一系列野外观测资料得到的由泥石流不均匀系数、泥石流运动底部纵比降和水力半径计算的粘性泥石流运动平均速度经验公式，能适应各种类型的泥石流沟，与其它系列的观测资料对比有很好的一致性，与粘性泥流的观测资料对比也很接近。

In chapter II,the preliminary knowledgefor accomplishing this research is presented,and the well-posed problem ofthe thin-plate flow of non-Newtonian viscous fluids is testified.By using themonotone operator theory and Schauder's fixed point theorem,the generalizedsolution's existence and uniqueness theorem for the thin-plate flow problem ofnon-Newtonian viscous fluids is obtained under reasonable conditions.

第二章给出了进行本项研究所需的一些预备知识，对非牛顿粘性流体薄板流问题广义解的适定性进行了研究，应用单调算子理论和不动点定理，在合理的条件下，证明了非牛顿粘性流体薄板流问题广义解的存在性，唯一性定理。

The fluidization characteristics of ultrafine particles are reviewed and the agglomerating process is analyzed.

首先阐述了超细颗粒的流化特性(初始流化速度、床膨胀等)及团聚流化过程，然后重点对近年来国内外在改善粘性颗粒流化质量方面所作的研究工作进行了总结。

In this paper, the commercial software FLUENT is used to calculate the viscous flow field around a ship with Twin-skeg, without taking into account the impact of wave-making resistance.

文中利用商业软件FLUENT，在不考虑兴波影响下，对各航速下的双尾船粘性流场进行数值模拟。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐