粘度

Results:⑴Animals made into models turned to polyuric, overeating, polydipsic, and appeared dejected.

4中药治疗组和培哚普利组血液粘度和纤维蛋白原在2周和4周时都低于模型组(P﹤0.05，P﹤0.01)。

The applications of mechanochemical effects of polymer solids during pulverization in self-compatibilization of immiscible polymer blends, effective mixing of polymers with unmatched viscosities, self-plasticization of polymeric resins, property tailoring between polymer components as well as the recovery of single and commingled postconsumer or preconsumer polymeric wastes were reviewed.

综述了聚合物固体粉碎过程中产生的力化学效应在不相容聚合物混合物增容、高分子树脂的自增塑、粘度不匹配聚合物体系的有效混合、高分子废弃物循环回收利用等方面的应用。

Compositions containing additions of SiO2 and Y2O3 did not show any densification after pressureless sintering, due to the high viscosity and extensive volatilisation of the liquids formed at the sintering temperature.

成分含增补的二氧化硅和氧化钇没有出示任何致密化后，无压烧结，由于高粘度和广泛挥发的液体形成于烧结温度。

The research of polymer/layered silicate nanocomposite was introduced detailedly, including the classify, property and the latest research advance. On the basis of consulting the document and the exploratory experiment, the experimental method which first creative preparing poly (acrylonitrile-vinyl acetate)/raontmorillonite nanocomposite by emulsion intercalation copolymerization was established; the structure and property of polyacrylonitrle different molecule weight with inorganic mineral super fine nanocomposite was reseached. The reaction principle of PMMA by photo-initution was explored. The mixture principle with productor condition, property of PE/Clay nanocomposite milt insert was seal prived. By PS/Clay nanocomposite munufacture, the monomer ins-polymerization and polymerial solution was proved.

在查阅文献和探索性实验的基础上，确定采用乳液原位插层聚合方法首先创制了聚/蒙脱土纳米复合材料，利用正交实验得出了最佳实验条件，通过X射线衍射和红外光谱对纳米复合材料的结构进行表征，研究了复合材料的溶解性能，并测定了其溶液的绝对粘度；研究了不同相对分子质量的聚丙烯腈与不同的无机矿物超细粉复合材料的结构与性能；探讨了在蒙脱土中光引发聚甲基丙烯酸甲酯的反应机理；通过聚乙烯与粘土的纳米复合材料制备，探讨了热塑性树脂熔融插层复合机理与最佳工艺条件和复合材料性能关系；通过聚苯乙烯与蒙脱土纳米复合材料制备，验证了单体原位聚合插层和聚合物溶液插层机理。

It is also found that the temperatures at which the CO2 density, thermal conductivity and viscosity possesses the maximum change are very closer to the pseudocritical temperature.

CO2的密度、导热系数以及粘度变化最大时的温度与准临界温度相当接近。

At constant viscosity, by increasing the liquid flow rate, the liquid film's velocity is increased; at the same experiment condition, the frequency of the liquid film is same at the same radial direction; the air current has minimum effect on liquid film bottom flow velocity, while it has an obvious effect on liquid film surface flow velocity. The longer the distance between liquid film and the inlet, the lower the pulsatory frequency and longer the wavelength.

在粘度基本不变的情况下，随着液体质量流率的增加，液膜流动速度随之增加；在同一个实验条件下，沿圆管径向各质点的频率基本保持不变；气流场速度对液膜底层流动速度影响很小，对于液膜表面流动速度有着较大的影响；沿液膜流动方向，液膜的脉动速度逐渐增加，脉动频率降低，脉动波长变长，与报道的通过快速摄像得到的液膜发展趋势一致，证实用PDA研究液膜流动是可行的。

The pharmacological mechanism is that it may reduce the"pathogenic pyretic factors"by means of"expelling heat to promote the production of body fluid", but it cannot eliminate the existent blood stasis (3) The blood stasis was stopped in QHR.

白虎汤能明显改善血浆比粘度、血沉、ET、TXB〓、PT等血瘀相关性实验指标，其机理可能是该方通过清热生津，减少血瘀形成的基本诱因&热毒&而发挥作用，但该方不能防止气分证微观血瘀的形成。

The results of intrinsic viscosity,elemental content and gel permeation chromatographic analyses showed the extent of biodegradation during the biological treatment increased with the content of pyridinium group in the polymer.

生物耗氧处理过程中该阳离子聚体片材的特性粘度、元素含量和凝胶渗透色谱分析的结果表明：聚合物中吡啶盐含量越大者，其生物降解性就越显著。

15Pm: Final submissions for time-spreads, Viscosity, Regrade spreads.

下午4点15分提交时间价差，粘度以及航煤/柴油价差的最后时间

The enhancement of water and oil repellency and the lowering of surface energy for those films formed by the modified dispersions were observed.

与环氧树脂水分散液相比，两类改性水分散液的粘度上升，粒径减小，液体表面张力基本不变。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐