粘度

The software can be well fluid viscosity and emulsifying analysis correction.

软件可以进行井液粘度和乳化度分析校正。

The experimental results indicated that the viscosities of all the products were lower than 100 mPa·s.

根据这种低粘度特性，将其开发用作水泥分散剂，其中以原淀粉为原料、取代度为0.51的产品的分散性能最好。

The inhibition action of chitosan quaternary ammonium was studied for carbon steel in sulfuric acid.

研究了壳聚糖季铵盐作为单组分缓蚀剂对碳钢在硫酸溶液中的缓蚀性能，以及缓蚀剂浓度、温度、时间和特性粘度、取代度等因素对缓蚀效果影响。

In order to reduce the bleaching stage, the two stage bleaching of chlorine dioxide and hydrogen peroxide boosted by an activator was studied in this paper and the sequences were optimized with mathematic model.

本文探讨了蔗渣浆二氧化氯和添加活化剂的H2O2两段漂白，在有效氯用量12kg/t，H2O2用量12kg/t，活化剂A用量1.5kg/t的情况下，D两段漂白可以达到DD三段漂白(有效氯、NaOH和H2O2用量分别为30kg/t、13kg/t和1kg/t)相同的白度和粘度。

Activation of heavy calcium carbonate with aluminates and other modification agents was studied, and the activation degree of calcium carbonate and the viscosity of its mixture with paraffin were characterized.

研究了铝酸酯等复合处理剂对重质碳酸钙的活化处理方法，对制得的活性重质碳酸钙的活化度及石蜡油/碳酸钙混合物的粘度行为进行了表征。

The paper summrized lubrication technology and the selection of lubricant for rotary kiln, grate cooler, mill, conveyor mechanical equipment and large scale fan as following,(1)in rotary kiln, apply oil spoon of circulatory lubrication or pump forced oil supply system in the roller supporting mechanism and use (superscript #)680 high load industrial gear oil, and use lubrication method of idle oil wheel or spray in drive gear wheel and select solid lubricant which has high viscosity, strong adsorbability, good abrasion resistance in utmost pressure and lattic crystal structure,(2) in grate cooler, use immersion oil lubrcation in reducer and boiled oil centralized lubrication method in supporting roller and guide roller bearing, choose (superscript #)1 limit pressure lithium lubrcant grease,(3) in mill, use circulatory lubrication with fluxing oil station in drive mechanism and circulatory lubrication with high-low pressure fluxing oil station in main bearing and sliding shoe bearing and select N320 industrial gear oil.

文章全面总结了回转窑、篦冷机、磨机、输送机械及大型风机的润滑技术和润滑剂的选择。其中，(1)回转窑的托轮支承装置一般采用油勺供油的连续循环润滑方式或油泵强制供油系统，润滑油选用680重负荷工业齿轮油；传动大小齿轮的润滑一般采用带油轮或喷雾的润滑方式，润滑剂宜选用粘度高、吸附性强、极压耐磨性好、具有点阵晶体结构的固体润滑剂；(2)篦冷机中传动减速机的润滑一般采用浸油飞溅润滑；托轮，挡轮轴承的润滑一般采用干油集中润滑的方式，润滑脂一般选用锥入度310~340的1极压锂基润滑脂；(3)磨机中传动装置一般采用稀油润滑站循环润滑和冷却的方式；主轴承或滑履轴承的润滑一般采用高低压稀油润滑站循环润滑和冷却的方式，润滑油一般选用N320工业齿轮油。

The structure of an improved pin gate ,called twin-gate,was described,and the rheological behavior of polymer melt passing through the gate was studied.

介绍了一种改进的点浇口———孪浇口的结构，讨论了聚合物熔体流经该浇口时的流变性能，在浇口的长度、总截面积以及流量一致的条件下，与常用点浇口相比，孪浇口使熔体温度升高和使熔体粘度降低的程度要大，但压力降增加的幅度也大。

General Yanghuai bean gum in cold water, only part of solution, heated to 85 degrees for 10 minutes or more can be fully hydrated, so that after the cooling maximum viscosity.

普通洋槐豆胶在冷水中只有部分溶液，加热至85度保持10分钟以上才能充分水化，使冷却后达到最大粘度。

General Huai bean gum in cold water, only part of dissolution, heated to 85 degrees for 10 minutes so that it can fully hydrated; greatly improved cooling after the viscosity.

普通槐豆胶在冷水中只有部分溶解，加热至85度保持10分钟以上可以使其充分水化；大大提高冷却后的粘度。

If the ink as a secondary material added too much, can reduce the ink, ink, viscostty and innovativeink for decocting and pine oily largening from cataplasm.

如果油不朱洋增入的补助料太多，能贬矮油不朱的粘度、不朱度变紧而且使油不朱的油性增不小，也会变不败糊版。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。