粘度
- 与 粘度 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Film or paper surface dirty, and wrapped it into the dust or clear plastic mulch films after the crease or relaxation phenomena, film hemming switched to a new membrane drying temperature is too high, adhesive surface crust adjust oven temperature, clear crusts partⅱ thermotolerance cohesion and not enough use better glue wrinkle of polymer-coated film transfer after the roll is not the proper balance of films at both ends are inconsistent or wave; adjustment layer of polymer-coated machine too thick, solvent evaporation incomplete, viscosity, pressure drum extrusion, paper (Business card printing and membership card making products) and films between slide to adjust the film covering technology electrothermic roll and rubber roller ends is not plain, pressure is inconsistent, ranging from the adjustment of the linear speed of the machine after the temperature inside the plastic mulch film covering the subject in yellow glue resin particularly resin or additives not resistant to ageing, in the light, heat, under the influence of ultraviolet radiation, chemical change, build the pigments should be switched to a new glue
薄膜或纸张表面不干净,裹入灰尘或杂质清除后再行覆膜薄膜有折皱或松驰现象,薄膜卷边换用新膜干燥温度过高,粘合剂表面结皮调整烘道温度,清除结皮胶的粘接力和耐热性不够换用更好的胶水覆膜后起皱薄膜传送辊是否不平衡;薄膜两端松紧不一致或波浪边;调整覆膜机器胶层过厚,溶剂蒸发不彻底,影响了粘度,受压力滚筒挤压,纸张与薄膜之间产生滑动调整覆膜工艺电热辊与橡胶辊两端不平、压力不一致、线速度不等调整覆膜机器覆膜后易变黄胶水中的主体树脂特别是一些增粘树脂或助剂不耐老化,在光、热、紫外线的影响下,发生化学变化,生成有色物质应换用新胶水
-
Coke properties has been studied by high temperature SiC oven、infrared gas analyzer and X-ray diffraction. First set forward the relationship between UPC and coke reactivity, strength, fine coke and coke graphitization, and creatively find the graphitization degree of coke tends to 100% when temp. reaches to 1350℃ UPC is profitableness to coke properties;②The effect of UPC on liquid slag distribution and flow functions in experiment oven has been studied by mathematics simulation The effect of UPC on taking shape and dropping of high titanium-bearing B. F. slag has been studied by using high temp. oven simulation cohesive zone and dropping zone of blast furnace.
为了弄清楚这部分UPC对高炉冶炼钒钛磁铁矿过程的影响,①在实验室利用高温SiC炉、红外线气体分析仪、X—射线衍射仪等进行了一系列UPC对焦炭性能及石墨化度的影响研究,提出了UPC与焦炭反应性、抗压强度、粉化性能及焦炭石墨化度之间的关系,创造性的发现高炉内1350℃以上,焦炭的石墨化度已达100%,UPC对焦炭性能的影响有益而无一害;②采用数学模拟方式研究了UPC对实验炉内液态渣分布及流函数的影响,并利用高温熔滴炉模拟高炉软熔带、滴落带研究UPC对高钛渣滴落性能的影响,采用旋转式粘度计测定滴落渣性能并通过高倍矿相显微镜观察了滴落渣的矿物结构。
-
Viscosity is the ink in the main control indicators that directly influenced the ink transfer and cards and membership cards to make the quality of the viscosity is too low, it rolled out; on the contrary, innovativeink viscosimetry excessive ink transfer be poor, prone collesting part of the irregularity, fine line break, and so on.
粘度是油墨应用中最主要的控制指标,它直接影响着油墨的转移性能和制卡和会员卡制作品的质量,粘度过低容易造成油墨铺展;反之,粘度过高则油墨的转移性能比较差,容易出现大面积实地部分着墨不匀、细线条断裂等弊病。
-
The effect of hydrophobe content on the intrinsic viscosity and Huggins constant kH of the water - soluble hydropho-bically associating terpolymers were discussed in this paper. Further...
结果表明,随疏水基团含量增加,特性粘数减小、Huggins常数增大;共聚物亚浓溶液的表观粘度随疏水基团含量的增加而增加,随温度、剪切速率的增加而降低,共聚物在NaCl、CaCl2盐水溶液中出现盐增粘现象。
-
In this paper, the third monomer 1,4- benzenediamine was introduced into the system of pyromellitic dianhydride and 4, 4-diamino diphenyl. Polyamic acid was synthesized in N-methyl pyrrolidone by solution polycondensation. The chemical structure of the polymer obtained was characterized by infrared spectrum. The dynamic viscosity and intrinsic viscosity were measured. Studies were mainly focused on the influences of monomer solid contents, monomer adding methods on intrinsic viscosity.
本实验在常用的均苯四酸二酐和4,4'—二氨基二苯醚聚酰亚胺体系中,引入第三单体对苯二胺,采用三元共聚的办法合成出聚酰胺酸溶液,对合成产物进行了分子结构的红外光谱分析以及特性粘数、动力学粘度的测试,并讨论了单体固含量、加入方式等对聚酰胺酸特性粘数的影响。
-
Bubbling temperature direct affect the diameter and the distribution of bubbles; Bubblier is a main factor which influence the bubble structure of foam glass. To select different bubblier results in different craft. To add stabilizer directs affect the melt viscosity, besides superficial expansion.
在泡沫玻璃烧结过程中,发泡温度(760~950℃)影响泡径及气泡的分布状态;发泡剂是影响泡沫玻璃制品泡孔结构的主要因素,发泡剂不同,发泡时间不同,则气泡的泡径和开闭口的情况就不同;在泡沫玻璃烧结过程中,稳泡剂的加入直接影响粘度,粘度过高气泡不易产生,粘度过低气泡极易逸出,两者都不利于产生所要求数量的气泡;另外,表面张力和配料中的水对发泡也有一定的影响。
-
UV flexbible business card printing and membership card making and putting it in good, Business card printing and membership card making high quality, Business card printing and membership card production processes do not change the physical character, not a stable viscosity of volatile solvents, and hard to paste version of the heap, available higher viscosity business card printing and membership card making, inking, dot-definition high reproducibility good halftoning, inks, intermediatein blazeof withattached bridgeis fit fine products cards and membership cards.
UV柔印油墨制卡和会员卡制作适性好,制卡和会员卡制作质量高,制卡和会员卡制作过程不改变物性,不挥发溶剂,粘度稳定,不易糊版堆版,可用较高粘度制卡和会员卡制作,着墨力强,网点清晰度高,阶调再现性好,墨色鲜艳光亮,附着牢固,适合精细产品制卡和会员卡制作。
-
A comparative study was conducted on 261 patients with malignant turnouts and 93 healthy controls.
检测结果表明,恶性肿瘤患者的血浆粘度,全血低切粘度及血沉均有明显升高(P.05和0.01);而血细胞压积均低于健康人(P.01)。
-
The experimental results showed that viscosity of the molten alloy increases with decreasing temperature and fits with Arrhenius formula.
粘度-温度曲线表明,随着温度的下降,Zr50Cu50合金熔体粘度呈指数增加,基本符合阿雷尼乌斯公式。
-
It is a polymeric coupling agent that reacts with degraded polymers to restore the original molecular weight as well as I.V. and melt viscosity.
它是通过与已降解聚合物进行化学反应,恢复其原来的分子量和特性粘度,增大熔融粘度。
- 推荐网络例句
-
Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.
Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。
-
I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.
我来只是现在,'歼灭战perfuming自己与胡努特,那麼,他来到和SAT 。
-
The shamrock is the symbol of Ireland and of St.
三叶草是爱尔兰和圣特里克节的标志同时它的寓意是带来幸运。3片心形叶子围绕着一根断茎,深绿色。