粘度

While other reaction conditions were setted, viscosity and yield of the product P were determined by Ubbelohde viscosity meter in different temperature;By parity of reasoning,viscosity and yield of the product P were determined in different initiator concentration、monomer concentration and monomer ratio.

固定其它反应条件不变，用乌氏粘度计测定了在不同引发剂浓度下产物P的特性黏度及产率；以此类推，测定了在不同单体浓度、单体配比条件下产物P的特性黏度及产率。

In order to illustrate the phenomena occurred in the technological experiments, the infiltration dynamics of liquid aluminum into porous media was simulated in accordance with the laws of similitude. The results show that (1) the relation between the displacement of infiltration front and the advancing time is 〓;(2) the pressure of infiltration changes with time according to 〓;(3) the distribution of pressure in the direction of infiltration length is P=a〓+b〓L.(4) the change of temperature or viscosity of molten aluminum affects infiltration velocity in fillers of diameter in the range of 1. 5～5. 5mm very little, but this velocity in fillers of diameter 0.5mm is reduced with the decrease of AL temperature.

为了说明工艺试验中显示的各种现象，作者根据相似原理，采用模拟试验研究了铝液在多孔介质中的渗流过程，得到铝液渗流动力学规律如下：（1）渗流前沿位移—渗流进行时间关系为〓；（2）渗流压强随渗流时间的变化规律为〓；（3）渗流压强沿渗流长度分布为P=a〓+b〓L；（4）铝液温度降低或粘度加大时，对大于1.5mm的颗粒之间的渗流速度影响不大，但使0.5mm颗粒之间渗流速度减小。

The addition of sucrose will increase the viscosity of acidified milk drinks and improve the stability of acidified milk drinks.

蔗糖的加入使体系的粘度升高，使其稳定性增强。

Both Na-MMT and OMMT can be able to increase the softening point and viscosity of asphalts, but OMMT had a better modification effect.

Na-MMT和OMMT均可增大沥青的软化点和粘度，明显提高沥青的耐高温性能，但OMMT改善效果更为显著。

Fall congeal degrees on mixture of KH150BS bodying oil with different base oil of different nature such as high viscosity index base oil,isomerization unit based oil lost and so on were studied.

进行了KH150BS与高粘度指数基础油、大庆加氢异构化脱蜡油等不同性质基础油调兑后对降凝剂的感受性研究，用倾点测定法考察其降凝效果。

The vessel bunkered at Rio de Janeiro, Brazil, with fuel stemmed by charterers. The crew member followed routine bunkering procedure which included the following on board tests specific gravity, viscosity, compatibility, water, and pour point. The test results were all within acceptable limits.

根据承租人的安排，该船在巴西里约热内卢加油，船员遵循加油程序操作，包括船上测试，诸如比重、粘度、相容性、含水量和流点，检验结果全部可以接受。

The results showed that after the adding starch to the sheet, the viscosity of the PVA solution increased, the dissolution time of the sheet got longer, the rate of enlargement in water was smaller, the rate of moisture became smaller, stretch intensity enhanced and the change of shape diminished; also it could be seen from the surface of sheet that the starch existed in PVA sheet as the shape of conglomerating particle.

结果表明，加入淀粉后，PVA溶液的粘度增大，膜的溶解时间变长，水上伸长率变小，含水率变小，扯断强度增强，形变缩小；通过膜表面观察，发现淀粉在膜中以聚集颗粒状态存在。

Firstly, the different effect of rectorite modification for the mechanical property of E-51 system were compared; the effect of organic clay for the viscosity and Gel-time of pure E-51 epoxy resin were checked separately; the influence of organic clay for hardening process was studied with FTIR technology; And, the infection of organic rectorite content in matrix for the mechanical property thermal-wet tolerance property aging resistance property and medium endure property for the both of two system were studied relatively. The effect of organization for the inter-layer distance of clay was denoted by XRD technology; To probe into the thermodynamics status about reaction, we investigated the heat discharging of reaction system in the help of DSC. The impact and crooking of solidifying system was observed with the SEM to investigate the decentralization of organic clay, and, at the base of this ,we discuss the mechanism of clay toughing-buildup polymer matrix.

分别考察了有机粘土对树脂体系粘度和凝胶特性的影响，利用红外光谱分析技术研究了有机粘土的加入对体系固化工艺的影响；分别考察了有机粘土含量对二体系的力学性能、耐湿热性能、耐老化性能以及耐介质性能等的影响；采用X-衍射实验表征复合材料中有机粘土层间距的变化；用视差扫描量热法考察了体系的放热情况，以探讨反应的有关热力学状况；通过扫描电子显微分析技术对浇注体的弯曲、冲击断口进行观察分析，以考察、表征有机粘土的分散情况，并在此基础上探讨了有机粘土改性环氧树脂的机理。

In RICP technology, FCC unit not only is the final process for residue conversion, but also provides intermedium streams, such as heavy cycle oil and/or decanted oil, as co-feedstock for hydrotreating unit.

在RICP组合技术中，催化裂化装置是重油得以最终转化为产品的操作单元，同时提供低粘度、高芳香性的HCO和/或澄清油等中间物流作为渣油加氢装置的进料组元之一。

Mo-Ni-P catalyst is a highly effective desulfurer and denitrider and in addition, has a favourable degradation effect on the dehydrogenated products and makes the viscosity og the reformed oily liquid less susceptihle to the effect of the existence of a N_2 atmosphere.

Mo—Ni—P催化剂脱S，脱N效果好，加氢改质产品轻质化效果佳，改质液化油在N_2气氛下粘度变化较小。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐