粗糙度

This phenomenon was caused by the combination of surface roughness of coating and particle size effect.

这是由涂层表面粗糙度和粒子尺寸效应共同作用的结果。

The results of experiment show the relation between static coefficient of friction and surface roughness.

实验得出静摩擦因数随表面粗糙度的变化关系。

Static coefficient of friction Surface roughness Dry friction

静摩擦因数；表面粗糙度；干摩擦

Experiments were performed with this device to measure the static coefficient of friction for three kinds of material(45steel,HT35-61,QT80-2) in the same processing method,the same surface texture,the same load,dry friction and different surface roughness conditions respectively.

分别对材料(45钢、HT35-61、QT80-2)在相同加工方法、相同表面纹理、载荷恒定、干摩擦条件下，改变表面粗糙度时的静摩擦因数进行了测定。

Detection: carbon-sulfur analyzer, oxygen analyzer, glazing machine, Rockwell hardometer, profile projector, surfagauge, scan electron microscope, laser conductometer, magna-check, universal measuring instrument, metallograph and image analysis system, abrasion tester, universal test machine and other advanced analysis and detection equipment and instruments.

检测类：碳硫分析仪、氧分析仪、试验室用抛光机、洛氏硬度计、轮廊投影仪、表面粗糙度测量仪、扫描电镜、激光热导仪、磁力探伤机、万能测量仪、金相显微镜及图像分析系统、磨损试验机、万能试验机及其它的先进的分析检测设备和仪器等产品类。

studies the result shows the bacterium is right originally the conglutinate ability of surface of artificial and articulatory material not only depend on bacterial itself, also concern with material property and exterior surface roughness.

结论本探究结果表明细菌对人工关节材料表面的粘附能力不但取决于细菌本身，也和材料性质和表面粗糙度有关。

Results show that the water contact angle becomes smaller and the surface is rougher after modification.

结果表明，改性后的硅表面接触角减小，粗糙度增加。

Since continuum hypothesis is still valid for liquid flow in microchannels with hydraulic diameter at about 100 micro-meters, a turbulence convection heat transfer model for single-phase liquid flow in microchannels is established, in which wall surface roughness viscosity is introduced.

分析表明水力直径为100μm左右的微管道内单相液体流动仍满足连续介质假设，引入粗糙度粘性系数，建立了微管道内单相液体湍流对流换热模型，并采用3维有限容积法进行了数值计算，将计算结果与实验结果进行了对比。

A theoretical model for calculating the cutting angle with different crystal planes, orientations and tool orthogonal rakes are described in this paper. It is built with the ultra-precision cutting model by the principle of the maximum specific energy of shear deformation and the mechanism of change of the shear modulus with...

本文利用剪切变形比能最大及单晶材料不同晶面晶向剪切弹性模量不同的原理，结合超精密切削模型，从理论上计算出不同晶面、不同晶向及不同刀具前角超精密切削条件下的剪切角，得到其在不同切削条件下的变化规律，并由此解释了切削加工中由KDP晶体各向异性所导致的工件表面粗糙度的各向异性。

But the conventional cleaning method can't achieve our need when cleaning 2 μm thickness cuprum foil.

极薄的铜箔是惯性约束聚变中常用的靶材之一，要求密度达到晶体理论密度、表面洁净、粗糙度低、润湿性好，用常规方法清洗厚度在2 μm及以下的铜箔，难以达到要求。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。