粗化

Furthermore, NiAl precipitates coarsen in the Cr phase and dislocation appears in the Cr phase.

此外，Cr相中的NiAl微粒粗化，在Cr相中出现了位错线。

Meanwhile, too great interface thickness would coarsen the secondary arms.

同时，过大的界面厚度会导致主枝晶和二次枝晶粗化。

The bubbles grow up, coarsen and rupture with prolonging foaming time.

随着发泡时间的延长，泡沫Al中的气孔发生长大、粗化、崩塌。

For 0.7%Cu steel, aging at 450℃ for 90 minutes, a great deal of Nb particles precipitated in matrix, and aging at 650℃ for 90minute, these precipitates started to coarsen.

含铜为0.74％的试验钢在450℃90分钟时效时，有大量细小的Nb粒子析出，在650℃90分钟时效时，粒子发生粗化。

Moreover, human activities play a more and more important role in the development of tidal flat. The concentrated coastal engineering change the dynamic environment of the tidal flat, and the exploitation of oil, natural gas and groundwater results in surface subsidence in the coastal area. In addition, sea level rise and the accompanied increase of storm surge frequency and intensity, will strengthen the erosional process, reduce the tidal flat area, coarsen the sediment, made the slope steep, and cause other environmental effects.

人类活动的环境效应对渤海潮滩发育的作用越来越明显，环渤海地区密集的海岸工程将改变原始的潮滩动力环境；石油、天然气、地下水的开采会导致海岸带发生地面沉降；海平面上升以及与其相伴随的风暴潮作用频率与强度的增加都将会使渤海潮滩的侵蚀过程加强、潮滩面积缩小、滩面物质粗化、坡度变陡，并产生一系列的相关的环境效应。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100℃ for 24 h, retrogression at 200℃ for 7 min, and reaging at 100℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5% H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the micro- structure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa，767 MPa和9.1%，显示优越的综合性能。

The results show that the flow stress decreases with increasing deforming temperature and increases with increasing strain rate. The flow stress of the alloy during hot compression deformation can be described by constitutive equation in hyperbolic sine function with a hot deformation activation energy of 196.27 kJ/mol. Partial recystallization takes place in the alloys deformed at a high temperature or at a low strain rate, and large number of dislocations and subgrains are observed in the alloy. The elongated grains observed in the samples coarsen with increasing temperature and decreasing strain rate. Correspondingly, the subgrain size increases and the dislocation density decreases. The main soften mechanism of the alloy transforms from dynamic recovery to dynamic recrystallization.

结果表明：Al-Cu-Mg-Ag耐热铝合金在热压缩变形中的流变应力随着温度的升高而减小，随着应变速率的增大而增大；该合金的热压缩变形流变应力行为可用双曲正弦形式的本构方程来描述，其变形激活能为196.27kJ/mol；在变形温度较高或应变速率较低的合金中发生部分再结晶，并且在合金组织中存在大量的位错和亚晶；随着温度的升高和应变速率的降低，合金中拉长的晶粒发生粗化，亚晶尺寸增大，位错密度减小，合金的主要软化机制逐步由动态回复转变为动态再结晶。

Meanwhile, the experiments show that the multi-level swarm intelligence refinement algorithm is better than the multi-level tabu search refinement algorithm, especially in view of the probability that the approximate global minimum partition of the coarser graph may be the local minimum partition of the finer graph. Furthermore, the experiments show that the multi-level ant colony optimization refinement algorithm achieves more performance improvement than the multi-level particle swarm optimization refinement algorithm, using the gain of vertex more effectively.

实验数据反映出，针对最小图上的全局最优剖分可能是初始图的局部最优剖分、粗化图上的全局最优剖分可能是细化图的局部最优剖分的情况，基于群智能的多水平迁移优化算法相比基于禁忌搜索的多水平迁移优化算具备更强的逃离局部最优的能力；基于蚁群的多水平迁移优化算法相比基于微粒群的多水平迁移优化算法，对收益值的启发信息更为有效地利用，取得最佳的性能改进。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。