粒度测定的
- 与 粒度测定的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
During the process of peptization and hydrothermal crystallization, the aggregation behavior and the resulting morphology of nanocrystalline titania (TiO2) were studied by X-ray diffraction, scanning electron microscope, and dynamic light scattering techniques.
通过XRD、SEM和动态光散射粒度测定仪研究了胶溶及水热晶化过程中纳米TiO2晶粒聚集行为及形貌。实验结果表明,在胶溶无定形沉淀过程中所形成的大小为10-15nm的锐钛矿型胶粒或金红石型胶粒易定向聚集成更大的、具有(30-50)nm×(80-100)nm的次级晶粒。含有次级晶粒的溶胶前驱液在水热晶化过程中,次级晶粒发生崩裂并生长成结晶度更高的大小约为10-30nm球形和大小约为20-60nm棒状纳米TiO2
-
By synthetically analysizing the physical and chemical properties of all components and particle size, the content of F2641 in the JOB-iC is determined by gravimetric analysis after F2641 is seperated from HMX,TATB and PNP through ? alkali reflux. Determination conditions is set as follows the sample is boilingly refluxed for six hour in a constant temperature bath after adding lOOm! 8.0 ?? 0.1% NaOH. The solvent DMF saturated by TATB is used for extracting HMX,F21 and PNP from the sample and TATB is seperated by crucible filter G4. The mass precent of TATB is determined by extraction fractionation. The mass percent of PNP is measured by multiwavlength linear regression ultraviolet spectrophotometry. The testing conditions are set as follows:multiwavlength constitution: X=267nxn, 275nm, 283nm, 29mm, 299nm,the application scope of the Lambert-Beer law: the concentration of PNP is O.005?0.O25mgIml, the concentration of HMX is 0.060.3Omg/ml,absorption coefficents of PNP and HMX are solved by the slope of linear regression curve of absorbency- concentration of standard solution of PNP and HMIX for measuring wavelengthes,on the basis of the Lanibert-Beer law and absorbancy additivity principle, the slope of linear regression curve of A/E(1) and E1 of PNP and HMX solution is regarded as the concentration of PNP in the solution.
根据传爆药中各组分的物理、化学性质及主体炸药的粒度大小,进行综合分析,确定了采用碱回流重量法测定JOB-1C 中F_(2641)的含量,测定条件:加入100ml浓度为8.0±0.1%的氢氧化钠,在恒温水浴中煮沸回流6h;采用溶剂萃取法测定JOB-1C中TATB的含量,选择TATB饱和的二甲基甲酰胺为萃取溶剂,用G4坩埚式过虑器进行萃取分离;采用多波长线性回归紫外分光光度法测定JOB-1C中PNP的含量,通过实验确定了多波长组合:λ=267nm,275nm,283nm,291nm,299nm;朗波—比耳定律的适用范围为PNP浓度:0.005~0.025mg/ml,HMX浓度:0.06~0.30mg/ml;在测定波长下,对PNP、HMX标准溶液的吸光度—浓度进行线性回归,由回归曲线的斜率得出PNP、HMX的吸收系数;根据朗波—比耳定律和吸光度加和性原理,在测定波长下,对PNP、HMX 两组分混合溶液A_i/E_HMX(i与E_PNP(i/E_HMX(i进行线性回归,回归曲线的斜率即为混合溶液中PNP的浓度。
-
ABSTRACT: The fractal characteristics of low silica sinter with different Brazil high grade iron ore were investigated by using Least Square to measure the fractal dimensions.
本文探讨了低硅烧结矿在不同高品位巴西粉条件下粒度分布的分形特征,并用最小二乘法测定了其分形维数。
-
The Zetasizer Nano ZS is made in Marvern in England. It is the newest Zetasizer Nano ZS with the newest technology. Malvern Zetasizer Nano ZS90 is for the measurement of size, zeta potential of dispersed particles and the molecular weight of random coiled polymers. If it connect with the Autotitrator, it can measure zeta potential as a function of pH, conductivity or concentration of an additive, provides much greater insight into the processes involved in stabilizing or flocculating disperse systems.
英国马尔文公司生产的Zetasizer Nano ZS型纳米粒度仪是目前世界上技术最先进的纳米粒度仪之一,该仪器可以测定纳米材料的粒度分布、ZETA电位值,并可以进行蛋白质的熔点测定,及蛋白质等大分子和聚合物材料的分子量测试,如果与自动滴定仪相连接后,可自动测定粒度或Zeta电位随pH值、盐浓度或添加剂浓度等的变化趋势。
-
Methods Different particle sizes of betunilic acid and HPMC ,different viscosity grades and amount of HPMC and different pressures were used to prepare betulinic acid sustained-release tablets.
方法分别采用不同粒度白桦脂酸不同粒度、含量的羟丙甲纤维素,以及不同的压片压力制备白桦脂酸缓释片,在0.5%十二烷基硫酸钠溶液的释放递质中测定其释放度。
-
The granularity and broken cellular wall of ultra-fine powder were studied by JL9200 laser analytical instrument of granularity and scanning electron microscopy, as well as the bulk density and liquidity of "Cumiansan" ultra-fine powder were measured, and compared to the commonly cribble.
应用激光粒度仪和扫描电镜对微粉的粒度和破壁情况进行了观测,测定了&促免散&微粉的堆密度及流动性,并与普通粗粉进行了比较。
-
Methods AH dry powder inhalation was prepared by spray-drying method. Following spray-drying, resultant powders were characterized using scanning electron microscopy and laser diffraction, and the aerosolisation performance was determined using twin-stage liquid impinger. The process conditions were optimized with orthogonal design combined with multi-index test. The powder yield, aerodynamic diameter, angle of repose and respirable fraction were used as indices for orthogonal design.
采用喷雾干燥法制备盐酸氨溴索干粉吸入剂,采用双层液体碰撞器测定盐酸氨溴索干粉吸入剂体外沉积率,扫描电镜观察粉粒的形态,激光粒度测定仪测定粒径大小,以产品收率、粉末的空气动力学径、休止角及体外沉积率为考察指标,通过正交设计结合多指标综合评价法优化最佳制备工艺。
-
Based on the characterizations such as SEM、EDS、TG-DTA、FTIR、DRS、XRD、XPS、Zeta potential and Particle size analysis, The effect of preparation conditions including washing and calcining temperature on the photocatalytic activity of N-doped photocatalysists was discussed through the photodegradation of styphnic acid (2,4,6-Trintroresorcinol).
对改性后的催化剂进行了SEM、EDS、TG-DTA、FTIR、DRS、XRD、XPS、Zeta电位测定及粒度测定等表征,研究改性催化剂的微观形貌、元素组成、化学结构、热稳定性、吸光范围、晶型、表面电荷以及在水中的粒径分布。
-
The particle size of latexes prepared by different reaction condition was measured by transmission electron microscope and particle size measuree.
采用透射电子显微镜和粒度测试仪对不同反应条件下制备的乳液的粒度进行了测定。
-
Methods:(1) bFGF was loaded with PLGA, PELA and gelatin microspheres. The pharmac characteristics of particle size distribution, loading efficiency, entrapment efficiency, bFGF release kinetics were evaluated with scanning electronic microscope, MTT and ELISA respectively. The prescription with the best pharmac characteristics and the highest bioactivity of bFGF was chosen for the next step.
(1)制备PLGA,PELA和明胶微球,通过扫描电镜和激光粒度分布仪测定其粒径分布;ELISA法测定微球溶出度,包封率,bFGF释出动力学;MTT法测定微球释出的bFGF的生物活性,筛选出一种具有较好药剂学性质和较高bFGF生物活性的微球载体材料。
- 推荐网络例句
-
But we don't care about Battlegrounds.
但我们并不在乎沙场中的显露。
-
Ah! don't mention it, the butcher's shop is a horror.
啊!不用提了。提到肉,真是糟透了。
-
Tristan, I have nowhere to send this letter and no reason to believe you wish to receive it.
Tristan ,我不知道把这信寄到哪里,也不知道你是否想收到它。