粒剂

The total flavonoids content of peanut hulls of different sources were evidently different,those peanut hulls contained more total flavonoids from Shandong province,higher maturity and raw. This suggested that attention should be paid to the choice of peanut hulls as medicine materials. 3.The optimized extraction technology conditions considering the two indices of total flavonoids andβ-sitosterol were: the peanut hulls were extracted by 95% acohole 6 times of the hulls weight refluxing for 2 hours first,and extracted by 70% acohole 4 times of the hulls weight refluxing for 2 hours at the temperature below 80℃successionally,then the concentrate was dried vacuumizedly with the additament of starch 2% of the concentrate weight after the extracts were fitrated,united and concentrated. 4.The dried extract powder possessed high hygroscopy and low fluidity,but the weight variation of capsule contents could comply with the requirement of CP if it was mixed with dextrin and granulated by sieving 40 meshes using 95% ethanol as the wetting agent,and filled into capsules after dried below 60℃.The critical relative humidity of the granules was about 63%.

不同来源的花生壳总黄酮含量有较大差异，山东产区、成熟度高的及未经炒制的花生壳总黄酮含量较高，提示作为药材时应注意选择； 3、兼顾总黄酮及β-谷甾醇的最佳提取工艺为：先以95%乙醇6倍量加热回流提取2小时，再以70%乙醇4倍量80℃以下回流提取2小时，提取液过滤、合并、浓缩，加2%淀粉60℃以下减压干燥； 4、浸膏粉吸湿性大，流动性差，但加糊精并以95%乙醇为润湿剂、过40目筛制粒，60℃以下烘干后填充胶囊，可保证装量差异符合要求；颗粒临界相对湿度约为63%。

The relationship of the amounts of emulsifier, organosilicon monomer (D4) and initiator with the ratio of fluorescence intensity between first vibronic peak of pyrene (λ= 373 nm) and third vibronic peak of pyrene (λ=384nm)Ⅰ1/Ⅰ3 were discussed during the emulsion polymerization process, in which pyrene was used as fluorescence probe. The polymerization behavior of the organosilicon-acrylate latex with core-shell structure was investigated in line with the relationship of monomer conversion and development of morphology in latex particles with the value of Ⅰ1/Ⅰ3 for probe pyrene during the polymerization process.

以芘为荧光探针，探讨了有机硅-丙烯酸酯核壳乳液聚合过程中，芘的第一振动峰(373nm处)与第三振动峰(384nm处)荧光强度的比值Ⅰ1/Ⅰ3与乳化剂、有机硅单体（D4）和引发剂用量之间的关系，并结合聚合过程中探针芘的Ⅰ1/Ⅰ3 峰值与单体转化率及乳胶粒形态演变之间的关系，研究了核壳结构有机硅-丙烯酸酯乳液的聚合行为。

The coagulating mechanism of polysilicate-containing composite inorganic polymer flocculants was discussed by studying the Zeta potentials of flocculants and contaminants,the growing processes of flocculates,and the sizes of flocculates.

通过测定含硅多核无机高分子絮凝剂水解沉淀物和废水中污染物的Zeta电位、絮体粒径及不同絮凝阶段的絮体显微照片，并结合絮凝剂的形貌结构和混凝性能探讨了其混凝机理。

The results showed that the residual quantities of chloroform, acetone, and ethanol were 36.30ppm, 2.07ppm, and 25.17ppm, respectively.

致孔剂粒径、致孔剂用量、PLLA／β-TCP配比及成型压力对支架的性能都有重要影响。

Through research, the relationship among cured depth and concentration of photoinitiator, exposure energy, concentration of monomer, ratio of monomer to cross linker, refractive index of liquid, volume fraction of powders, mean diameter of powders are confirmed.

通过对浆料固化性能的研究，得出了固化厚度随引发剂浓度，曝光能量，单体质量分数，单体和交联剂比例，单体溶液的折射率，粉末体积分数以及粉末粒径的变化关系，并得出相应的最佳值。

The results suggested that the reaction temperature, the ratio of oil to water, the amount of ethyl cellulose as dispersant, initial monomers composition, the drop manner and the amount of initiator, the stirring speed, the pH of the buffer and the elution process have great influence on the morphology such as diameter of the hydrogel beads.

研究结果表明，采用反相悬浮聚合法，以丙烯酰胺和N-乙烯基吡咯烷酮为共聚单体，N，N'-亚甲基双丙烯酰胺为交联剂，牛血清白蛋白为模板，可以制备BSA印迹共聚物微球；反应温度、水油比、乙基纤维素分散剂用量、初始共聚单体配比、引发剂用量和加入方式、搅拌速度、水相pH值以及后续洗脱条件等均对粒径等微球结构和形态产生明显影响。

Inorganic flocculant CF-PAC、Al-pillared rectorite act as sorption mostly ; Meanwhile organic flocculant chitosan acts as the adsorption bridge mainly. Chitosan coagulates fine flocci together into lager、impact floccules and greatly strengthens the polymerization degree and coacervation force. The sedimentation rate and adsorption efficiency rise greatly. So the flocculation efficiency of this composite flocculant is superior to the single one.

无机絮凝剂CF-PAC、铝交联累托石主要起吸附作用，而壳聚糖主要起吸附桥连作用，将细小的絮粒凝结在一起形成更大更致密的絮体，并使聚合度和凝聚力大大增强，从而使其沉降速度和吸附效率大大提高，起到优于单一絮凝剂的絮凝效果。

Methods Baicalin gelatin microspheres were prepared by emulsion chemical-cross linking method with degradable gelatin as carrier, liquid paraffin as oil phase, Span-80 as emulsifier.

以天然的可生物降解的明胶为载体，液体石蜡为油相，Span80为乳化剂，戊二醛为交联剂，采用乳化化学交联法制备黄芩苷明胶微球，测定明胶微球的平均粒径、载药量、包封率，并对工艺重现性进行了考察。

The study results showed that the porosity, pore size, pore distribution and crush strength can be adjusted by the alternation of addition and powder size of pore-forming agent, the variating of addition of binding admixture, sintering temperature, holding time, forming method.

研究发现，改变成孔剂的加入量、粒径大小，粘结剂的加入量，坯料颗粒大小、成型方式，烧成温度、保温时间等方法可以调节样品气孔率、孔直径、孔径分布、压碎强度。

In our study, ultra-fine ZnO powder , ultra-fine TiO〓 powder , and zeoliteAg , which were all surface modified with titanium coupling agent, were pelletized with PP into masterbatch, and melt-spinning with PP to obtain PP fiber with good antibacterial property and good UV-cut property.

采用正交实验，以沉降体积为测试指标，研究不同粉体表面改性因素对粉体表面改性效果的影响，发现偶联剂用量是粉体表面改性的最相关因素，随粉体表面改性偶联剂用量的增加，粉体沉降体积减小，并出现一极小值，该值小于基于粉体粒径计算的理论值。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。