粉末化

The influence of double carburization upon the microstructure of WC powder is investigated by adopting of different tungsten oxides.

通过对不同氧化钨前驱氧化物的采用，研究两步碳化法对 WC粉末微观结构的影响，在国内首次探讨 WC粉末中生长孪晶的形成机制及其结构特点，阐述生长孪晶对硬质合金性能的影响。

The fluidization characteristics of powder coatings are studied by means of experiments and observation.

通过试验和观察，研究了粉末涂料的流态化特征，提出了粉末涂料流态化质量的评价方法。

Hydrogen nitrate powder acidizing is to mix solid hydrogen nitrate powder and hydrochloric acid in certain proportions to generate strong oxidizing nitrosyl chloride, which can violently and locally dissolve rock and blocked material without destroying formation structure, to make through oil path and improve formation permeability.

硝酸粉末酸化工艺技术，是利用固体硝酸粉末与盐酸以一定的比例混合后，生成氧化能力很强的氯化亚硝酰。

Determination of the uranium content in nuclear grade uranium hexafluoride, uranyl fluoride solutions, uranyl nitrate solutions, uranium oxide, uranium dioxide, powder and pellets; gravimetric method

核子纯的六氟化铀。氟化铀溶液。硝酸溶液。氧化铀粉末。二氧化铀粉末和颗粒铀含量的测定。重量分析法

In order to reduce the cost more and accelerate the application in the civil area, the laser rapid forming technology with low cost hydrogenation dehydrogenization titanium alloy powders had been investigated, and the following results were obtained:1 Disclosed the formation mechanisms and influencing factors of t.

为进一步降低该技术的成本，促进其在民用领域的发展，本文针对低成本氢化脱氢(hydrogenmiondehydrogenization，HDH)钛合金粉末的激光快速成形进行研究，取得的主要成果如下： 1。从粉末特性及成形工艺角度揭示了缺陷的形成机理及影响因素，结果发现：(1)气孔的产生是由于粉末在成形过程中卷入成形气氛中的氩气所致。

With cellulose as the skeleton, gelatinized cassava starch solution and tungsten carbide were used as porogenic agent and inert densifier, respectively. The matrix prepared showed good sphericity and a logarithmic symmetrical distribution of particle size.

取得的主要结果如下：纤维素基复合层析基质的物理功能化：以再生纤维素为骨架，碳化钨粉末为增重剂，糊化木薯淀粉为制孔剂，采用&反相悬浮热再生法&和成球后去除淀粉方法，成功制备了纤维素/碳化钨复合微球，可用作层析介质的基质。

The result showed that the powder microelectrode with WC prepared in the CH4/H2 atmosphere showed better catalytic activity forα-nitronaphthalene electrochemical reduction. This result was mainly attributed to different post treatments and surface morphological structures of two types of WC powders. Moreover, the WC-PME with WC prepared in the CH4/H2 atmosphere showed good chemical stability.

结果表明，以CH4/H2为还原碳化气氛所制备的WC粉末，其制成的粉末微电极对NP具有更良好的电催化活性，这主要与该WC粉末的结构形貌及其制备后的处理工艺有关，同时该WC-PME具有良好的化学稳定性。

Therefore, the crystallite growth rate of anatase during calcination for aged gel powder was slower than unaged gel powder.

经过陈化处理的胶体粉末其粉末中的氢氧基随著陈化时间的增加而减少。

Crystal size and microstrain caused by mechanical alloying on Fe_(70)B_(30) powder were studiedby X-ray diffractometry and transrnission electronmicroscopy.

在机械合金化过程中球磨所造成的微观应变不大，球磨初期粉末的内应力随球磨时间增加而增加，当粉末粒子尺寸很小时，随球磨的进行粉末中的微观应变显著下降。

The isothermal kinetics of nanogram obtained by MA has been studied in section three. The grain growth of α solid solution of Fe〓CuNb〓Si〓B〓 powders is controlled by a single kinetics within the experimental temperature range, the activation energy for grain growth is 80.3kJ/mol, magnetic properties of powders at different annealing and milling conditions are measured, a preliminary effort has been given to the consolidation of Fe〓CuNb〓Si〓B〓 powders.

第三部分研究了机械纳米晶化粉末的等温晶粒长大动力学，在实验研究的温度范围内，Fe〓CuNb〓Si〓B〓纳米晶α固溶体的晶粒长大由单一的动力学过程所控制，其晶粒长大激活能为80.3kJ/mol，研究了不同球磨条件及热处理条件下纳米晶粉末的磁性，对纳米晶粉末的成型进行了初步的尝试。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。