管下的

Level circular canal fixed under stator coil, 'lower circular canal' for short, is installed according to number of line bars to connect it with insulation draft tube via airproof parts, and to ensure coolant in line bar evenly distributed.

定子绕组下方配置的水平环管，简称下环管。按定子线棒数在环管上装设接口，经密封构件与绝缘引流管连接，以确保所有线棒中冷却介质的均匀分配。

In the spiral pipe heat exchanger exports terminal, the ammonia steam temperature has been heated up 85 ℃--95 ℃, by now, the ammonia steam had the 45kg-55kg/cm2 ammonia steam pressure, sent in the ammonia steam turbine through the constant temperature pipeline, impelled ammonia steam turbine revolving, led the generator electricity generation;After the ammonia steam makes the merit release energy, the temperature drop, the returns ammonia storage tank, passes through again adjusts the press pump to press into the spiral pipe-type heat exchangers to carry on the next circulation;Including the ammonia steam turbine entire ammonia steam road is becomes the independent closed cycle system, is isolates completely with the outside air;The ammonia steam only plays the carryhome and the shift energy role, in the electricity generation process does not consume the actuating medium, the stored energy carrier water also is only gets up the carryhome and the shift energy function,The waterway also is from becomes the independent closed cycle system, in the electricity generation process also the needless water consumption, through the actuating medium ammonia steam and the stored energy carrier water unceasing shuttle service, transforms through the heat interchanger the solar energy as the actuating medium ammonia steam heat energy and the kinetic energy,With the aid of the ammonia steam turbine heat - machine transformation function and the generator machine - electricity transformation function, has realized the solar energy hot - electricity entire conversion process, transforms continuously the solar energy into the electrical energy, power supply for foreign;The low temperature generating system must solve three big technical keys:One, the anticorrosion (has actuating medium has strong corrosiveness), two is Explosion-proof (Some actuating medium Can have the detonation with the air mix when divulging, controls warm malfunction, elevates temperature suddenly also can have detonation), three is guards against the revolution axis divulging

以太阳能低温发电系统为例，低温发电方法是这样进行的：以水作为储能载体的太阳能采集器将太阳能采集起来，将水温提升至85℃--98℃；用氨作为工作介质储于氨储罐及氨汽路中；采用螺旋管型热交换器；用调压泵将氨储罐中的氨汽压入螺旋管型热交换器的螺旋管内，用调压泵将携带太阳能的85℃--98℃的储能载体热水压入螺旋管型热交换器的螺旋管外壁空间进行循环式热交换，在热交换器的螺旋管出口端，氨汽温度已被加热到85℃--95℃，这时，氨汽具有45kg—55kg/cm2的氨汽压力，通过恒温管道送入氨汽轮机，推动氨汽轮机旋转，带动发电机发电；氨汽作功释放能量后，温度下降，返回氨储罐，再经调压泵压入螺旋管型热交换器进行下一次循环；包括氨汽轮机在内的整个氨汽汽路是自成独立的封闭循环系统，与外界空气是完全隔绝的；氨汽只起携带和转移能量的作用，发电过程中并不消耗工作介质，储能载体水也是只起携带和转移能量的作用，水路也是自成独立的封闭循环系统，发电过程中也不消耗水，通过工作介质氨汽和储能载体水的不断循环运行，通过热交换器将太阳能转化为工作介质氨汽的热能和动能，借助氨汽轮机的热—机转化功能和发电机的机—电转化功能，实现了太阳能的整个热—电转化过程，将太阳能源源不断地转变为电能，对外供电；低温发电系统要解决的三大技术关键：一是防腐（有的工作介质具有较强的腐蚀性）、二是防爆（有的介质泄漏与空气混合会产生爆炸，控温失灵，急剧升温也会产生爆炸）、三是防轴漏（汽轮机是动态旋转体，必须解决工作介质的防轴漏问题）。

After removing the catalyzer by dense muriatic acid, carbon nanotubes are reacted with mix acid (vitriol:nitric acid=3:1 vol./vol.). By comparing the surface image of gained carbon nanotubes under the different condition, the best mix acid oxidation temperature is fixed on 140°C and the reaction time is 30min. The soluble carbon nanotubes were prepared by decorating of octadecylamine on the surface of nanotubes. Three processes of grafting were investigated in this research.

对碳纳米管的热失重、差热分析结果表明，通过在一定温度下空气氧化可去除大部分碳颗粒；而浓盐酸浸泡可去除碳纳米管制备过程中残留的催化剂颗粒；对在不同条件下与硫酸和硝酸配制的混酸反应处理后得到的碳纳米管的表面形貌研究表明最佳混酸氧化条件为140℃氧化30min。

Moreover, since the strain energy of zigzag tubes is larger than that of the armchair tubes with the same semidiameter, the ends of the armchair tubes are easier to be closed than those of the zigzag ones. And the closed structures of the zigzag tubes have a lot of defects, even at 3000 K, there will be few carbon atoms flying away from them.

此外，由于锯齿型碳管应力能比同口径扶手型碳管的应力能大，使得扶手型碳管比锯齿型碳管更容易形成端口封闭的结构，且锯齿型碳管端口的封闭结构出现相对较多的缺陷，甚至在3000K下会有少最碳原子从端口飞离碳管。

It is usually situated in the lower third of the urachus but can be seen just inferior to the umbilicus.

脐尿管囊肿见于脐和膀胱之间，通常位于脐尿管的下1/3 ，但也可见于仅位于脐下。

ET tube insertion procedures were performed on 59 pediatric patients aged newborn to 17 years (33 boys) due to cardiopulmonary arrest or impending respiratory failure. Ultrasound images were taken before and after the procedure in two-dimensional and time-sector modes using a portable ultrasonic machine. The subxiphoid window at the mid-upper abdominal — just beneath the xiphoid process and the lower margin of the liver — was used most often, with a wide transducer sector angle (90 degrees) for bilateral scanning of the diaphragm.

这项试验对59位从新生儿到17岁（33位男童）的小儿科病患进行插管，插管的原因是因为心肺衰竭或是严重的呼吸衰竭；在插管前与后使用可携带式超音波机器进行二度空间与时间象限的超音波显影；最常使用中上腹的剑突影像，就在剑突与肝脏下下缘部份的影像，与以宽的转换区间角度（90度）作横隔膜双侧扫描。

Methods 101patients were enrolled to perform central venous catheter placement.The patients were taken hor-izontal position,retrosternal raised30°orientation,head faced to the left.The puncturing point lower1.5cm subclavian（at1/3between sternoclavicular joint and shoulder joint）,injector was directed toward laryngeal prominence,parellel and slowly puncturing.

101例锁骨下静脉置管患者均取平卧位，肩背部垫高30°，头向左侧，取胸锁关节至胸肩关节连线的1/3处，锁骨下缘1.5cm为穿刺进针点，右手持注射器于穿刺点朝喉结方向平行缓慢进针，置管深度为15cm。

In order to do research on pipe flow and pump characteristics of polymer flooding and water flooding rod-pumped well in especially high water-cut stage, rheometric test aimed at production stream from polymer flooding and water flooding rod-pumped well in especially high water-cut stage has been made, and the characteristic of production stream in especially high water-cut stage is confirmed as Newtonian fluid. Experiments using different mediums about pipe flow and pump characteristics is made. Frictional resistance and coefficient of friction resistance of annulus fluid between sucker rod and the pipe flow is calculated under different working conditions. Frictional resistance between plunger and pump barrel under different parameters is calculated based on related theory of pump characteristic and the strained analytical model of oil-well pump. Besides, using the theory of slit flow and hydraulic -clamping pressure, the frictional resistance is calculated, and the error between the result and measured value is no more than 13%.

为研究特高含水期水驱及聚驱抽油机井管流特性与泵特性，本文针对特高含水期水驱及聚驱井采出液进行了流变性试验，确定了特高含水期油井采出液的性质属牛顿流体；利用不同介质，进行管流特性与泵特性试验，得到了不同工况下杆、管环空流的摩擦阻力和摩阻系数；根据泵特性相关理论和抽油泵受力分析模型，计算了不同参数下柱塞与泵筒间的摩擦阻力，并利用缝隙流与液压卡紧力理论对柱塞与泵筒间的摩擦阻力进行了计算，计算结果与实测值误差在13%以内。

Objective: To provide anatomical basis of clinical transnasal endoscopic approach to the vidian canal by endoscopic anatomical study of vidian canal region.

目的：通过鼻内镜下经鼻腔入路对翼管周围区域的解剖学研究，为临床内镜下翼管区域手术提供解剖学基础。

Based on the electron-lattice interaction,Frohlich Hamiltonian and quantization theory are used to deduce the dimerized energy gap and phase transition temperature of carbon nanotube.

依据碳纳米管中电子-声子相互作用的原理，采用哈密顿量、量子化理论推导了二聚化对应能隙和相变温度，在紧束缚近似、量子理论和能带理论的基础上，利用周期性边界条件对碳纳米管Π电子进行了分析，讨论了碳纳米管的导电性，预测了室温下碳纳米管碳管中载流子输运方向

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新