管

Histologically, the seminiferous tubules contained numerous Sertoli cells and more Sertoli-spermatozoa complexes, accompanied by the depletion of Leydig cells with deeply stained nuclei. Mature spermatozoa were stored up in the epididymis, but only a few in the efferent ducts. In the second place was testicular atrophy（32/120; 26.7%）. The seminiferous tubules showed moderate to severe inactivity of spermiogenesis with evidence of only spermatogonia, spermatocytes and Sertoli cells. The Leydig cells were obviously decreased in numbers associated with decrease of lipid droplets in their cytoplasms. Testicular hypoplasia was the third disorders（22/120; 18.3%）. Only a few spermatogonia and Sertoli cells appeared without any spermiogenesis. The associated changes was decreased in Leydig cells and fibrous hyperplasia in the interstitium.Epididymal stones were sometimes found（12/120; 10%）. Grossly, yellowish-white nodules with various sizes and firm in consistency were observed in the epididymis and the front efferent ducts. Microscopically, the epididymal ducts were dilated with voluminous spermatozoa storage, even showed calcification in severe cases. The deposited calcium salts were stained positively by Von Kossa and Alizarin red methods.Amyloidosis was also detected in 10 roosters（8.3%）. Eosinophilic, homogeneous, amyloid-like substances were deposited mainly in the testicular interstitium and the periphery of blood vessels. These substances showed positive reaction by Congo red staining. Five roosters（4.2%）had Marek's lesions in the testis, epididymis and peripheral nerves with infiltration of pleomorphic lymphocytes. Only one case showed epithelial necrosis of seminiferous tubules accompanied by fibrous proliferation in the interstitium.

结果发现，在总共搜集的120个病例中，其中因年老所导致的产精力不佳为最多，占38例（31.7%），於镜下可见大量精虫黏附於Sertoli cell的表面，并可见Sertoli cell数量明显增多而Leydig cell明显减少，且其细胞核呈现浓染的现象，而在其副睪中仍可见到成熟精虫蓄留於管腔中，但在其输精管内却只有少量精虫存在；其次为睪丸萎缩，占32例（26.7%），镜下可见中度至重度无造精作用，其生精小管中只见到精母细胞、精原细胞及Sertoli cell存在，但Leydig cell数量明显减少且其细胞质内的脂质也明显减少；睪丸发育不全，占22例（18.3%），於生精小管内只见到精母细胞及少量Sertoli cell存在，不见造精细胞分化，於生精小管间质可见Leydig cell减少并伴随结缔组织增生；副睪结石，占12例（10%），肉眼下可在副睪及输精管前段见到黄白色大小不一的结节，触感坚硬，於镜下可见副睪管扩张并有大量成熟精虫蓄积，严重时可见钙化现象，以Von Kossa及茜素红染色均呈阳性反应；类淀粉沉著症，占10例（8.3%），镜下在睪丸间质及血管周围可见粉红均质样的物质沉积，以刚果红染色成阳性反应；马立克病，占5例（4.2%），镜下可在睪丸、副睪实质及周边神经内均可见到嗜碱性大小不一的淋巴样细胞浸润；睪丸坏死，占1例（0.8%），镜下可见生精小管上皮细胞坏死脱落及间质结缔组织增生。

When pulp chamber access were achieved, the working length of each canal was measured using ROOT ZX apex locator with root canals in dry or moisture conditions.

常规根管清理后，采用ROOT ZX根管长度电测仪在干、湿两种根管状态下进行根尖位置的探测，根管充填后，根据X线片影像确定根管长度电测法的准确性。

The manufacture of copper core of automobile radiator includes coating tinned or bared copper cooling pipe; roasting assembled main core inside braze welding furnace at 230-280 deg.c for 30-60 sec; welding main sheet to cooling pipe via conventional process; and welding the copper lid opening for the water chamber with brazing agent without solder and welding filament.

一种铜质汽车散热器主芯的制造方法，其先将镀锡冷却管或裸铜冷却管外壁分别进行覆膜处理。将组装好的主芯主体置于铜钎焊炉内于230～280℃温度焙烧30～60秒。主片与冷却管间采用常规的方法焊合。还可以将组装好的主芯主体每排冷却管上摆放一根外表面涂有无钎料钎剂膜的锡焊丝，它们贴在冷却管与主片结合处。

Glass, ceramic tube fuse; resettable fuse, automotive fuse; strong electricity fuse; ultra-small capacitance, resistance of the Bi-High-type fuses; surface mount fuses, etc., telephone dedicated fuse; BS Plug Fuse-specific; handheld devices termination ESD protection; at the same time with the tube fuse tube matching folders, tube socket and other products.

玻璃管、陶瓷管保险丝；自复保险丝、汽车用保险丝；强电用保险丝；超小型电容、电阻之必高二型保险丝；表面贴装保险丝等，电话机专用保险丝；BS插头专用保险丝；手持装置的ESD端接保护；同时提供与保险丝管配套之管夹、管座等产品。

Objective To evaluate clinical effect of the handling ProTaper Nickel-titanium rotary instruments in preparation of canals of posterior teeth.Methods 96teeth with pulpitis or periapical periodontitis were instrumented by handling ProTaper rotary instruments using step-down technique,and by K files using step-back technique for control.All teeth were obturated with lateral condensation methods.The efficiency of preparation was analyzed with ra-diographs before and after operation.

目的 评价手用ProTaper预备后牙根管的临床效果方法选取患有牙髓炎和根尖周炎的后牙96例，随机分成试验组和对照组各48例，试验组用手用ProTaper 锥度镍钛旋转器械逐步伸入法预备根管，对照组用K锉，逐步后退法预备根管，两组均用侧向加压充填法充填根管，根据治疗后的X线片，评价后牙根管预备效果。

Author has introduced the process design method for steam tracing system of chemical piping ;has discussed the relative regulation,code and gist in the steam tracing design at home and abroad from aspects of diameter,quantity,and max.

介绍了化工管道蒸汽伴热系统的工艺设计方法；从伴管的直径、数量、最大允许长度、U型弯累计上升高度以及伴管、疏水器、紧固件的材料等方面论述了国内外蒸汽伴管设计相关规定、规范和要点；结合工程实例，论述了伴管蒸汽的引入和伴管敷设时相关注意事项，以及在最大允许范围内出现袋形累计上升的高度值问题。

The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.The optimal size of air gap and hot load to guarantee long life of cast iron cooling stave were obtained.

根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。

The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.

根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。

Based on the experime ntal researches some of heat pipe apparatus are developed, such as, giant heat p ipe steam generator, high temperature heat pipe air furnace and separate-type heat pipe steam generator at high temperature and with high heat flux. All of t hese show the progress of heat pipe tec hnology research and development in recent years.

在试验研究的基础上，又相继开发了一系列热管设备，如高含尘气体下的大型热管蒸汽发生器、燃煤高温热管热风炉以及高温高热流密度下的分离式热管取热器，从而反映了近年来热管技术研究开发的一些进展情况。

The outside sealing component -corrugated tube of valve can affect outside sealing properties of valve. Through finite element analyse of stress state of corrugated tube, the stress status which are under stretch, compress and stretch-compress action are obtained. Combined with test, the stability, detonation pressure and rigidity of corrugated tube are analyzed. The result showed that corrugated tube is safety under working pressure and when stretch-compress displacement is less than 60% of maxmium displacement.

作为阀门外密封元件的波纹管是影响阀门外密封性能的关键部件，通过对波纹管进行有限元分析，初步掌握了波纹管在拉伸、压缩以及拉伸压缩共同作用下的应力状况，同时采用有限元计算和试验相结合的方法，分析了波纹管的稳定性、爆破压力、刚度等，结果表明，波纹管在工作压力下，拉伸和压缩量达到许用位移的60%时，波纹管工作仍是安全的，为阀门开启量的确定提供了理论依据。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了