等浓度
- 与 等浓度 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
DVibrio parahaemolyticus: Each essential oil from the rhizome, stem, leaf and flower, as well as in ether zone and pentane zone, the antibacterial effects of all is 100% by 0.05% density of each essential oil.
4肠炎弧菌:0.05%浓度的月桃根、茎、叶及花等精油及其层析 pentane区分物及ether区分物,即有100%之抗菌效果。
-
Secondly, to explore the effect of pH, concentration of ferrous ion, and inorganic ions such as sulfuric ion and perchloride ion to the performance of electro-Fenton method for dye wastewater treatment.
至於,过氯酸根与硫酸根的影响,以前者处理效率较高。在不同染料废水水质的影响中,以COD、氯离子浓度及导电度等项目,对电解Fenton法处理效果的影响最大。
-
B yusing UV, MI, TGA and DSC techniques, the effects of phenoxide groups andits relative concentration on the structure and propenies of PEEK during Synthsisand processing have been studied.
本文用稍过量4、4'-二氯苯酮合成的聚醚醚酮样品,利用UV、MI、DSC和TGA等研究本氧阴离子及其相对浓度在树脂合成和加工过程中对PEEK分子结构和性能的影响。
-
The adsorption properties of the function fiber in solution for transition metal ion such as Zn2+,Cd2+,Hg2+etc., were studied and the effects of temperature, concentration, pHon adsorption were also determined. The results showed that the fiber exhibited fairly good adsorption properties, and the adsorption capacities for Zn2+.Cd2+,Hg2+ were up to 196.79mg/g, 275.40mg/g and 6,84.01mg/g respectively.
又研究了该纤维材料在水溶液中对Zn2+、Cd2+、Hg2+等过渡金属离子的吸附性能,测定了温度、起始浓度、PH对吸附性能的影响,结果表明该功能纤维对部分过渡金属二价离子有良好的吸附,对zn2+、Cd2+、Hg2+的吸附量分别为196.79mmg/g、275.40rmmg/g、684.01mmg/g。
-
The prepared powders were characterized by XRD, UV-Vis, FTIR, N_2 adsorption, Fluorescence spectroscopy, etc. N-doped TiO_2 evidently shows its absorbance shoulder shift into visible light region. Moreover, N-doping retards the transition of TiO_2 from anatase to rutile type as well as restrains the growth of the crystal size which leads to less decrease of surface area. These characteristics are considered to benefit the photoactivity of TiO_2; When all the samples were applied to the photodecomposition of Methylene Blue under visible light(λ>400 nm), the N-doped TiO_2 show an obvious superiority when compared to the undoped TiO_2, the active hydroxyl groups are found to play a important role in this high photoactivity; When the same experiment was performed under UV light, all the samples show the consistent sequence of photoactivity as in the visible light.
通过UV-Vis、XRD、BET、IR、FL等表征手段测试表明:掺氮不仅使TiO_2的光吸收区域拓展到可见光区,而且有利于延缓TiO_2晶相的转换,从而抑止了高温煅烧下所引起的晶粒增大以及比表面积的降低,且氮源浓度越高,此现象越明显,这些特征都有利于催化剂光催化活性的提高;在主波长大于400nm的可见光催化亚甲基蓝实验当中,掺氮TiO_2的光催化活性明显优越于未掺氮样品,亚甲基蓝在90min内达到88%的脱色率。
-
Refractive index is one of fundamental physical constant, which is often related to concentration, temperature, void fraction, internal strain etc.
折射率是一个基本物理量,通过它可以跟浓度、温度、空穴率、内应力等联系起来,因此折射率的测量很重要。
-
The contrast experimental analyses on the spray voltage, pinhead size and other influential factors are carried out.
在初步试验的基础上,利用正交试验的方法考察了海藻酸钠,羧甲基纤维素钠以及氯化钙的浓度对成囊过程中微胶囊膜厚,粒径等的影响。
-
MethodsWith the extract yield and piperyl piperidine content as index, orthogonal test was used to evaluate the influence factors, including the concentration of alcohol, the extracting time and the amount of alcohol.
方法采用正交实验法,以固含量和胡椒碱含量为考察指标,对乙醇浓度、回流次数、乙醇用量等影响因素进行研究。
-
The distribution of gas-solid two-phase flow in the axial guide vane cyclone tube was measured with five-orifice pitot tube and by means of isokinetic sampling method.
为研究颗粒分离机理,提高分离性能,采用五孔球探针测试仪及等动采样法对轴流导叶式旋风管内气固两相流速度与压力分布进行了测量,并分别对不同导流锥和排尘结构参数下的纯气流流场及颗粒浓度场分布进行了对比分析。
-
Effect of kind of ion, salt concentration, kind and amount of plasticizer and temperature on conductivity were discussed in detail.
文中详细讨论了离子种类、盐浓度、增塑剂种类和用量以及温度等因素对其电导率的影响。
- 推荐网络例句
-
I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""
客人们在卡罗利娜·埃凯家里,举止就文雅一些,因为卡罗利娜的母亲治家很严厉。
-
Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.
由著名品牌 Herm è s 设计,这件高贵的制服是香港本土制造,是我们第一套不配帽子的制服。
-
Do not 'inflate' your achievements and/or qualifications or skills .
不要 '夸大' 你的业绩或成果,条件或者技能。