等变晶的

And the lattice distance expands anomalously with decreasing particle size. Using the model of long-range interaction and its cooperative phenomena altered by particle size, the size-induced cubic-tetragonal phase transition, the anomalous lattice expansion, and the change in chemical bonding characters have been well understood.

采用长程相互作用的晶粒尺寸效应模型，对钛酸钡纳米晶结构相变、晶格间距异常增加、价键性质变化等实验现象给出了合理的统一的解释；并把该模型扩展到解释与钛酸钡晶体具有不同共价性成分的氮化镓等纳米体系的相变以及晶格结构变化现象。

The macroscopic rheological parameters and microstructure parameters were closely related, it is helpful to explain the essence of multiple rheological properties through the analysis of which the wax evolution process and microstructure of the crude oil which is waxy and high viscosity; the yield time of gelled waxy crude oil monotone increases along with the decreasing of rate of shear (the time of stress effect prolonged), there was power function relationship between them, it can be expressed with ; when adding diesel oil to Sudan crude oil, dilute proportion bigger the eccentricity degree of paraffin particles were bigger too, that was to say the symmetry of wax crystal was better, the wax crystal form fabric more hardly when the intermolecular interaction was smaller; in the light of macroscopica, the fall extent of the abnormity temperature, solidifying point and viscosity could be larger along with the accretion of dilute proportion, as a result, it's rheological properties could be improved.

SD原油析蜡点为94℃，析蜡高峰为50～30℃，异常点为40℃；其蜡晶颗粒细小、对称性差，所以具有较大的比表面能，容易形成联生、联锁结构；损耗角曲线与储能模量曲线或损耗模量曲线的交点所对应的温度与原油凝点或倾点温度非常接近，大约在39℃左右；也就是说，含蜡原油粘弹特性曲线的交点可以表征其流动性；原油宏观流变参数与微观结构参数密切相关，原油析蜡过程及蜡晶微观结构分析有助于诠释易凝高粘原油多重流变特性的本质；胶凝含蜡原油的屈服时间随剪切速率的降低而单调增加，二者显然存在幂函数关系，可用关系式描述；当SD原油加柴油稀释处理时，稀释比越高，蜡晶颗粒的偏心度也越大，亦即蜡晶对称性越好，分子间作用力越小，蜡晶颗粒越不易形成结构，宏观表现为异常点、凝点及表观粘度等流变参数下降的幅度越大，流动性越好。

Moreover, the hot compressive deformation behavior of the RS/PM AZ91 magnesium alloy and AZ91 alloy matrix composite were also investigated, the conclusions are drawn as follows:1. The processing parameters of the atomization-twin rolls quenching technology were optimized as follows: the diameter of the nozzle 1mm, the wheel velocity 25m/s, the pressure of atomization gas 0.3MPa and Ar gas for melt injection 0.1MPa. The RS AZ91 alloy flakes exhibited fine and uniform microstructures. When the flakes were extruded at 673K, extruded velocity of 0.1mm/min and extrusion ratio of 25:1,the magnesium alloy rods with clean surface, uniform dimension and excellent mechanical properties were obtained.2. The RS AZ91 magnesium alloy powders prepared by atomization-twin rolls quenched technology exhibited fine equiaxed grains with the grain size of 1-3μm, the phase constituent included supersaturate solid solution phaseα-Mg and miner fineβ-Mg_(17)Al_(12) phase. The as-extruded materials also exhibited equiaxed grains with the size of 5-7μm and a large number of fineβ-Al_(12)Mg_(17) and fewer AlMg_2Zn phases were detected in the alloy.

本文还研究了快速凝固/粉末冶金AZ91镁合金热压缩变形流变应力行为，快速凝固/粉末冶金法原位生成Mg_2Si增强AZ91镁基复合材料，经过系统的研究，获得如下结论：1、雾化-双辊急冷法在下列工艺参数组合下：双辊线速度25m/s；喷嘴直径1mm；熔体压射压力0.1MPa；雾化气体压力0.3MPa。，可获得宏观尺寸细小、微观组织均匀细小、综合性能优良的的快速凝固AZ91镁合金细碎箔带，快速凝固箔带在挤压温度为673K、挤压速度为0.1mm/min，挤压比为25：1时，可获得的外表光洁、尺寸均匀、组织性能优异的镁合金棒材。2、雾化-双辊急冷法制备的AZ91镁合金粉末态为细小等轴晶组织，晶粒尺寸1-3μm，组织为α-Mg过饱和固溶体和微量的细小β-Mg_(17)Al_(12)相组成；粉末挤压棒材为等轴晶组织，晶粒尺寸5-7μm，组织中含有大量细小的β-Al_(12)Mg_(17)以及AlMg_2Zn析出相，室温力学性能，抗拉强度383MPa，屈服强度275MPa，断后伸长率7.5%。

Most significantly the site provides a number of slide images on the following subjects: Isograds and chemical reactions in regional metamorphism, chemical reactions in rocks, interplay of nucleation and growth, the origin of porphyroblasts, crystal size distributions, feedback mechanisms, the metamorphic aureole of the Bushveld Complex and reconciling theory and observation, the critical overstep for andalusite growth.

网站还提供了一些重要的幻灯片图片，内容涉及到：等变质级、局部变质化学反应、岩石化学反应、晶核形成与发育的相互关系、斑状变晶起源、晶体大小分类及红柱石发育限度评估。

These jadeite jade specimens show mainly following texture types: granular crystalloblastic texture, equigranular crystalloblastic texture, inequigranular crystalloblastic texture, prismatic crystalloblastic texture, f...

主要的结构类型有粒状变晶结构(粗粒状、中粒状、细粒状及微粒状)、等粒变晶结构、不等粒变晶结构、柱状变晶结构、纤维状变晶结构、碎斑结构、交代结构、糜棱结构及碎裂结构等。

The coating exhibited a typical dendritic and equiaxed microstructure, and the grain size decreased with NbC content increasing.

当NbC的质量分数增加时，熔覆层的枝晶组织明显变细，主要以树枝状、等轴晶的形态存在。

The thermal shock resistance of the brick is expected to improve as a result of bigger bulk density, lower thermal expansion coefficient, phase transformation of fused MgO-ZrO2 eutectic powder, formation of magnesiaalumina spinel and forsterite.

材料性能的变化主要与电熔MgO-ZrO2共晶砂的体积密度大、热膨胀系数小、氧化锆的相变、镁铝尖晶石和镁橄榄石等物相的生成相关。

The Pl-lherzolite differs from the cumulates in having blastic texture and high-temperature deformed fabric of Ng[100] characteristic of the mantle peridotite and yielding orthopyroxene.

含长二辉橄榄岩以其具有地幔橄榄岩特有的变晶结构和Ng(100)高温变形组构，以及含斜方辉石等特点而区别于堆晶岩。

Consequently, they continued to grow and connected with each other to form the skeletal crystal for the porphyroblast.

本区石榴石、十字石等变斑晶的生长过程有多种形式，多数单晶不是一开始就环绕一个晶核不断增长，而是以多结晶中心聚集生长为特征。

Then a complete porphyroblast was formed.

初期石榴石、十字石等呈细片状绿泥石、云母等假象，它们组成多结晶中心的网状集合体，接着进一步聚合生长，逐渐连成一片，成为变斑晶的骸晶，然后形成完整的统一的变斑晶，再在此基础上层圈式增生。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。