立方

This paper hereby introduces the cooling process of the common 160,000 m^3-in-capacity atmospheric LNG storage tank in China, the preconditions and matters to which attention is paid upon the cooling of tank. It also discusses some commissioning techniques needed in the cooling process, including pressure control, cooling medium supply and its flow control, process monitoring and cooling rate control, etc. The paper points out that the displacement of pipelines is easily to be overlarge and flange leakage takes place frequently in the cooling process and it gives corresponding solutions.

为此，详细介绍了国内LNG接收站常用16×10^4 立方分尺常压LNG储罐的冷却过程，分析了LNG储罐冷却前应具备的条件及注意事项，讨论了LNG储罐冷却过程中的压力控制、冷却介质供应及流量控制、冷却过程的监控及冷却速率控制等调试技术，指出了冷却过程容易出现管线位移过大、法兰泄漏等问题，并给出了相应解决方法。

Oxy2 gen sensors used in auto has two types :oxygenic concentratin difference cell sensors and limiting current sensors.

经掺杂稳定的立方相氧化锆(ZrO2)固体电解质材料，具有良好的高温氧离子导电性，是制造汽车用氧传感器的关键部件。

FeSi nanoparticles were synthesized via thermal decomposition of iron pentacarbonyl in the solution of dioctyl ether, stabilizers oleic acid and oleylamine. The TEM images showed that FeSi nanoparticles had cubic shape, but it seemed that the composition was not uniform. According to the EDS results, the Fe:Si ratio of gray-uniform nanopaiticles was almost 1:1, and blacker FeSi nanoparticles contained more Fe atoms. Although FeSi didn't have uniform structure, it still could be proved that the incorporation of Fe and Si existed in a single nanoparticle. All possible structure, lattice, binding, morphology, surface condition would be discussed. These results indicated that perhaps FeSi2 was the main structure of the new products; however, due to incompletely combination and less synthesized time, it might still contain some part of Si and Fe structure. Besides, FeSi nanoparticles preserved the optical properties from Si atoms, but the PL intensity was much lower. The maxima PL peak appeared at 388 nm with the excitation at 300 nm. Their saturation magnetization, remanent magnetization and coercivity were measured by the SQUID, exhibiting their nearly superparamagnetic behavior.

利用热裂解系统可成功将研磨矽奈米粒子及五羰铁结合，制备出铁矽奈米粒子；从穿透式显微镜照片可知其粒子呈现立方体型态，但颜色深浅及组成不均，EDS结果则显示颜色均匀之粒子铁与矽之组成大致为1：1，颜色较深之粒子则含有较高量的铁元素；尽管组成比例并不统一，但单颗粒子同时含有矽与铁两种元素，初步说明铁矽奈米粒子之形成；进行多种结构与表面分析并探讨所有可能之键结、结构及表面元素后，推测铁矽奈米粒子可能以FeSi2之结构形成，并同时包含未重组完成的矽及铁之结构；利用PL分析得知铁矽奈米粒子确实保留矽之放光特性，并在300 nm激发光源下，於波长388 nm处有一最强放光特性峰，但整体发光效益不及研磨矽奈米粒子之结果；最后，利用超导量子干涉磁化仪量测其饱和磁化量、残留磁化量、与矫顽磁力，发现磁滞现象并不明显而几乎呈超顺磁性。

The effect of high intensity ultrasonic on solidification process of Sn Sb peritectic alloy was investigated.

在锡锑包晶合金的凝固过程中导入高能超声，不仅显著细化α相和β相晶粒组织，同时使具有立方晶体特征的β相组织有明显的球化趋势，消除了密度偏析。

All of the compounds have a cubic perovskite structure.

所有固溶体均具有立方钙钛矿型晶体结构。

The results of COS effects on fruits, vegetables, cut flowers, lily bulbs and potted ornamental plants showed that there were no phytotoxic effects of COS on fruits and vegetables under the condition of COS with the dosage of 40g/m^3 and for an exposure time of 2h.

COS熏蒸处理对水果、蔬菜、鲜切花、百合种球和盆栽观赏植物影响的研究表明：用剂量为40g/立方公尺的COS熏蒸2h后，COS对水果、蔬菜不产生药害，对果蔬外观和品质无影响；对植物的花朵无药害，但对植物叶片，特别是兰科、凤梨科等多肉质植物有较大药害，处理后的植物叶片出现脱水现象。

The results indicate that Pt-based alloys appear circular shape and distributehomogeneously on the carbon, the particle size is homogeneous and about 2～4nm. The crystalline form is platinic face-centered cubic and most of crystalplane is Pt(111), the doped metal elements dont form simple substance and existas Pt-M alloy formation.

研究表明，制备的Pt基合金微粒基本呈圆形，金属颗粒在活性炭表面上分布均匀，粒径也较为均匀，粒径范围约2～4 nm，晶型结构仍以Pt面心立方晶系存在，晶面以Pt(111)居多，掺杂的元素原子未单独形成单质颗粒，而是以Pt-M合金的形式存在。

AT the same time the paper deduces theory of model vessel of 125000 m^3 MOSS LNG Carrier, and makes programs and calculates, compares with result of ship test. At last it makes conclusion of practice precooling rule.

同时，以12.5万立方公尺的MOSS型LNG船为母型船进行了理论推导、编写计算程序和实际计算，并与实船试验进行比较分析，得出LNG船预冷的实际规律。

We designed Latin hypercube experiment; conducted deterministic simulation analysis for missile accuracy; designed Latin hypercube experiment and made certainty simulation analysis for missile accuracy, thus obtained the simplified functional expressions of missile's impact point deviation and error coefficient of each guidance instrument; built rapid calculation formula of prelaunch compensation quantity.

设计了拉丁超立方试验，并对导弹精度进行确定性仿真分析，得到导弹落点偏差与各制导工具误差系数的简化函数关系式，建立了导弹射前补偿量的快速计算公式。

The precursor powder materials were sintered by pressureless treatment at 600℃ and 900℃, respectively. XRD results show that the powder is in the form of a single cubic fluorite structure when sintered at 600℃.

在600℃和900℃下分别对初始粉体进行无压煅烧，XRD表明，在600℃时形成了单一的立方萤石结构。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐