立方

The value of specific capacitance was 56.4 F/g and the ESR value of the supercapacitor was 12.5 .f On the back surface of co substrate of carbon micro coils, Ni particles exhibited face centered cubic phase and hexagonal close packed phase. Only hcp Ni was found in the vicinity of the gas inlet, and Ni monolith shaped as flat hexagonal plates. Far from the gas inlet, Ni grains aggregated into flat plates without total fusion.

电容器等效串联电阻为12.5.6、碳微线圈碳基底背面有密堆六方和面心立方两种晶格结构的Ni共存；进气口附近，Ni为密堆六方晶格结构，颗粒为近似六边形的扁平晶体；离进气口较远处，催化剂小颗粒聚集成饼状的结构，相互之间没有完全熔合在一起。

This paper introduces the structure of the interpolation filter, which is suitable for VLSI. A new structure based on the Farrow structure of Lagrange is proposed, which can be used to improve the operational rate of the filter by pipelining and Parallel processing technology.

本文主要探求一种适合于VLSI实现的插值滤波器结构，在拉格朗日立方插值滤波器的Farrow结构基础上，融入了流水线技术和并行处理技术以提高滤波器运算速率。

The results show that the microscopical pore structure of the three dimensional orthogonal woven carbon fabric structure perform is composed of body-centered cubes which arranged periodically at spaces. The net structure and shape of the pores of perform are determined by the size and proration of the fasciculus diameter, which are key factors influencing the gaseous permeability and final density of composites. Once the proration of the fasciculus diameters of different directions is determined, the trend of diversification of the permeability followed by pore rate during CVI process and the density of composites are stated, and the permeability increases with the increase of the fasciculus diameter.

研究结果表明：三维正交结构炭纤维预制体的宏观孔隙结构在空间上可以看成是由呈周期性排列的体心立方"晶胞"构成； X ， Y 和 Z 3个方向纤维束直径大小及比例关系决定三维正交结构炭纤维预制体宏观孔隙网络的结构和形状，也是决定反应气体在孔隙中的比渗透率和复合材料最终致密度的重要因素；当 X ， Y 和 Z 3个方向纤维束直径的比例关系一定时，不同预制体在CVI增密过程中比渗透率随孔隙率变化的趋势相同；复合材料的最终致密度一定；比渗透率随纤维束直径增大而略有增大。

While most of the world insists on driving computer engineered square boxes with four tires attached, I'd rather spend just one hour in a '70 Mustang fastback with a 428 cu. in. Cobra Jet engine "laying some rubber" on the asphalt from an intersection.

这世界多数的人都想要开著电脑设计的四轮方盒子，而我只想要有一个小时的时间，开著一辆装载 428 立方吋眼镜蛇喷射引擎的70年代揭背式野马，从交叉路口冲出去时，在柏油路面留下轮胎的痕迹！

A linear system can be obtained by solving the governing equation using the Finite Element Method.

控制方程式应用有限元素法离散后，可获得一线性联立方程式。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.08-0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02-0.05 and 0.2 mm^3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2立方公厘左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

If this number grows as the cube of the distance, the space is flat.

如果这个数量随着距离的立方增长，宇宙就是平的。

The 45 cubic inch V-twin engine (later to be known as the "flathead") is introduced on the D model.

哈雷戴维森在D型摩托车上推出了45立方英寸排气量的V型双缸发动机，这款发动机后来被称为"Flathead"发动机。

The experimental results show that, Mn〓O〓 and Na〓Zr〓, which were cubic crystal and floccule in catalyst surface respectively, were active species, Mn〓O〓 was main active species and addition of Zr further activated methane molecules to improve methane conversion.

分析结果表明，Mn〓O〓和Na〓Zr〓是多组分甲烷氧化偶联催化剂的活性组分，在催化剂表面上分别以立方晶体和絮状物存在，且Mn〓O〓起主要作用，Zr的加入进一步活化了甲烷分子，提高了甲烷的转化率。

The results show that the prepared samples have uniform crystallinity and fine crystalline, with a cubic fluorite structure.

结果表明：所得到的纳米晶粒度均匀、结晶完好，属于立方萤石结构。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐