立方

The results of X- ray Diffraction indicated that face - centered cubic Al layers were obtained both by pulse plating and D.

在钢板上获得银白色铝镀层。X射线衍射结果表明，两种情况均得面心立方结构的铝，但由脉冲镀所得的铝晶粒较小。

The crystal structure of pure Pd is of face centered cubic and it is a hydrogen absorbing metal.

钯是一种面心立方结构的吸氢金属，氢原子溶解在晶格中，占据八面体间隙位，形成fcc的子晶格，吸氢时晶格发生等方性膨胀；氢在钯中的扩散路径为O T O跃迁，存在反同位素效应；钯氢化物的氢同位素分离因子较大，并受到温度、氢浓度等因数的影响；钯氢体系的p c等温线表现出良好的坪台性，Pd H和Pd D均存在临界点，尚未确定Pd T有无临界点；单晶钯氢反应动力学与不同的晶面有关；钯氚体系存在氚老化效应

Investigation of the ballistic propagation of acoustic wave through two almost same sintered samples with face - centered cubic lattices indicates that there is a band gap range respectively in two order quasi - homogeneous media.

研究超声波经过两个烧结样品的行为。两个烧结样品为有序的面心立方结构，它们的结构几乎相同。研究表明：在两个有序的准均匀的介质中分别有一个禁带区域。

Phase change memory with N-GST can realize three-state storage in one PCM cell by using the resistivity difference between the amorphous state, the face centered cubic phase and the hexagonal phase of GST.

利用N-GST薄膜的非晶态、晶态面心立方相和晶态六方相的电阻率差异，能够在同一存储单元中存储三个状态，实现相变存储器的多态存储功能。

On the insertion of Li with low current density, the crystal structure is keeping original spinel; while with higher current desity or by thermal activation, owing to violent movement of Li~+ ions, part of crystal structure transforms into rock type similar to face—centered cubic structure of ferrous oxide.

结果表明，以较小电流密度嵌锂时，晶体结构保持原来的尖晶石型；当以较大电流密度嵌锂或热激活时，由于Li~+的运动加剧，部分晶体结构转变为类似于氧化亚铁的面心立方结构。

SiO2 opal with face centered cubic structure is fabricated using a self-assembly method. Two different three-dimensionally ordered macroporous carbon materials are prepared using SiO2 opal as a template through "volume templating" and "surface templating" approaches, respectively. The final morphology of the sample can he controlled by the infiltration times.

通过自组装的方法制备了面心立方结构的SiO2欧泊，并利用其为模板，分别采用"体积模板"与"表面模板"两条途径，合成了两类不同结构的三维有序大孔碳材料，分析了填充次数对产物形貌结构的影响。

The object of the study was investigated the nanostructured precipitates and superparamagnetic properties of the γ-austenite face centered cubic Fe-9A1-30Mn-1C-0.5Si alloys, for which two kinds of specimens were solution-treated quenching in oil, and the S. T. quenching in oil then cold-forged 20%~50% strain, respectively.

本研究计画之目的，系探讨沃斯田铁面心立方结构之铁－9铝－30锰－1碳－0.5矽合金，两种试样时效热处理后内部微析出物显微结构与超顺磁性质之关系，两种试样分别为闯溶油冷与因溶油冷锻应变20%-50%，再同时於823K持温140天时效处理。

The Pd-Cu/C catalysts were shown to have the face centered cubic crystal structure. This could indicate that the addition of Cu shortened the Pd-Pd distances in the crystal lattice, and therefore –HO(subscript 2ads) and O-O could be better adsorbed on the surface of the catalyst. When NaBH4 was used as the reducing agent, and the atomic ratio of Pd to Cu was 3:1, the resulting catalysts had an average particle size of 3. 4nm and showed the best catalytic performance. The electrochemical active surface are a of Pd3Cu/C was 38.9m^2/gPd and the oxidation reduction reaction activity of the Pd3Cu/C catalyst was much higher than that of the Pd/C catalyst. The electrochemical activity of the Pd3Cu/C catalyst was comparable to that of a commercial Pt/C catalyst.

结果表明：催化剂中Pd与Cu的物质的量之比与预设值相近，Pd和Cu基本被全部还原；Pd-Cu/C催化剂为面心立方结构，元素铜的加入使催化剂的Pd-Pd间距缩小，从而HO(下标 2 ads)和OO键能更好地吸附在催化剂金属表面；当采用NaBH4为还原剂，Pd与Cu物质的量比为3：1时，催化剂(Pd3Cu/C)的平均粒径为3.4 nm，催化剂的催化性能最好，电化学活性表面积EAS达到38.9平方公尺/gPd，电化学性能较Pd/C催化剂有很大提高，接近Pt/C商用催化剂。

Crown ether was introduced to copolymerize with the monomer of styrene owing to which can associate with silver ions. The silver ions were in-situ reduced to silver nanoparticles by UV light. Then silver nanoparticles were led on the surface of polystyrene latex particles. The vertical precipitation was employed to get the spheres self-assembled into close packed colloidal crystal with a face centered cubic structure identified.

利用冠醚可与银离子复合的特性，制备了聚苯乙烯－冠醚乳胶粒，采用原位还原的方法在乳胶粒表面引入银纳米颗粒，通过垂直沉降，乳胶粒子可自组装成紧密堆积具有面心立方的聚苯乙烯－银胶体晶体。

The spherical , monodispersed , ultrafine cobalt powder with a face centered cubic structure and a size less than lum were synthesized by the reduction of tetra hydrated in glycol or 1,2-propanediol.

经(来源：A0eBccccC论文网www.abclunwen.com)过探索实验和正交实验，找出最佳制备工艺，制备出晶粒尺寸小于1um，具有面心立方晶体结构且分散性较好的球形的超细钴粉。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐