空载

Electrical wiring spile on the ring, passing into the collector ring of power to pass through the internal outlet to the device.

确认上述各款都以做到，方可送电试车，空载运转往复20个圆周后无异常现象，即正式工作运行。

Finding conjugate points in the overlapped parts of scanned data sets and calculating the coordinate transformation parameters are the common steps of merging point cloud data.

透过重叠点云资料之共轭点位进行地面光达点云资料的结合是常用的方法，而空载光达的应用亦常需以共轭点位进行航带平差。

The problems of amorphous alloy distribution transformer, such as the core structure, no load loss, noise, anti-short circuit ability, technical and economic questions, were mainly analyzed.

分析非晶合金配电变压器的铁心结构、空载损耗、噪声、抗短路能力、技术经济性等问题。

We claim the system can potentially assist to plan a crew timetable and to solve the crew arrangement and the deadhead and layover problems efficiently.

最后本研究以Java 程式语言为基础，设计一套整合型排班决策支援系统，可规划符合经济效益的空服员排班表，并有效地解决空服员调与空载和过夜问题。

Based on the equivalent circuit, the resonance frequency equation is derived and the expression of the resonance frequency is obtained.

在此基础上，得出了振子空载时共振频率方程和振子共振频率的表达式。

According to generalized modular design, finite element models of each function module are built in ANSYS, which belong to pre-tightening frame of 45 MN forging press. MPC banded contact is used to simulate the connection of two fixed parts, while standard contact is used to simulate the connection of two dissociable parts, Deformations and stresses of the forging press under two working conditions are discussed, which provide good guides to the design of such kind of press.

依据广义模块化设计原理，在ANSYS中分别建立了45MN锻压机预紧组合机架各个功能模块的有限元模型，采用MPC绑定接触模拟闭合模块间的连接，标准接触模拟可开裂模块间的连接，分别讨论了空载和临界载荷两种状态下机架的变形和应力分布，计算方法和计算结果为此类机架的分析、设计提供参考和指导。

Based on the systematic analyses of the applications and developments of step motor, the driving technique of step motor are analyzed in this paper, and upon these statements, a mathematical model of VR step motor is built. With this model, the coil current of step motor with chopping driver and the non-loaded starting frequency are simulated for the base of designing of step motor servo system.

本文在系统分析了步进电机应用和发展的基础上，对步进电机的驱动技术作了详尽的论述，建立了三相反应式步进电动机的数学模型，并利用该模型对斩波驱动的步进电机绕组电流及空载运行的启动频率等进行了仿真，为步进电机驱动系统的设计提供了依据。

Simulation in the discussion, respectively, from the rated load, and the empty set three conditions for the system simulation, obtained under the three conditions in response to step through the analysis of the curve, the load that the impact of changes in the system And to improve the system.

在仿真讨论中，分别取额定负载、空载和过载三种情况对系统进行仿真，得出其在三种情况下的阶跃响应，通过对曲线的分析，得出负载的变化对系统的影响，并以此对系统进行了改进。

This working area is composed of a family of curves of the practical raising frequency—raising voltage on the power amplifier bridge when the motor working from non—load to full—load, the value of which influences the operation characteristic of motor.

工作区是由电机从空载到满载运行时功放桥上获得的实际的升频升压曲线族组成，它的大小影响着电机的运行特性。

Inside, hydraulic driving is applied and friction force with tape is power resource. System can automatically distinguish the belt conveyers loads and the condition carrying idler, and realize carrying coal and spraying linked. It has got fine effect in scene application.

把动力部分、传动部分、控制部分、执行机构集成一个整体，在内部采用液压传动，依靠与胶带产生摩擦力作为动力源，并且可自动识别胶带机的负载和空载情况，使运煤和喷雾联动，在现场应用中取得了良好的效果。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了