空气流动

A numerical simulation method is used to investigate the cooling and humidifying effects of wetlands. A mixture model was adopted to simulate the flow and diffusion of air and moisture, which describes the process of heat and mass transfer.

采用数值模拟方法研究湿地对周边区域空气的降温增湿效应，建立了空气、水气的流动与扩散混合模型，描述给定空间的传热传质过程。

The removal efficiency of VOCs by the air sparging process depends critically on the contact volume of the contaminated groundwater by the injected air, or the sweep efficiency.

气提法是藉著注入地下水层中的空气将溶於地下水及非饱和层中的挥发性有机污染物带出，因此空气在含水层之流动路径及接触污染物的排扫效率就成了影响气提法现场污染整治成效的重要因素。

This possibility is supported by the observation in our laboratory that flowing air at 121 C sterilizes in about 50% of the time required by static air.

我们在实验室里的观察支持这种可能性，静止空气在121C灭菌时大约50 %的时间需要流动空气。

True love, like air, the sky is blue in the flow of air, fresh, natural, transparent.

真正的爱情像空气，是蔚蓝色的天空里流动的空气，清新，自然，透明。

When the injection pressure is about 0.1MPa, the air flow through the injector becomes critical, so if the swirl level variation reaches the required range, the pressure should be kept as low as possible.

空气射束的喷射压力越大，涡流比的变化范围也越大。而当喷射压力达到0.1MPa左右时，空气在喷嘴内的流动已接近临界状态。因此，射束喷射压力不宜过高，在满足涡流变化要求的前提下，喷射压力应尽量低一些。

High density energy of the plasma ignition carries on the heat and chemical effect to the air and the fuel mixture, produced a great deal plasma activation carrier.

其高密度能量对空气或可燃混合物进行热学作用，进入等离子体点火器内的空气和雾状燃料经历的过程非常复杂，它涉及气体湍流流动、传热、传质、化学反应、辐射等过程。

A distributed parameter model was proposed to simulate the airside heat transfer of the finned-tube evaporators in the frosting process.

建立了结霜条件下翅片管蒸发器空气侧流动和换热的分布参数仿真模型，模型考虑了蒸发器结构、霜层厚度以及湿空气状态等参数在气流方向的沿程变化。

A distributed parameter model is proposed to simulate the airside heat transfer of the finned-tube evaporators in the frosting process. The variation of the evaporator structure, the frost thickness and humid air conditions along the flow path are taken into consideration.

建立了结霜条件下翅片管蒸发器空气侧流动和换热的分布参数仿真模型，模型考虑了蒸发器结构、霜层厚度以及湿空气状态等参数在气流方向的沿程变化。

This displacement of air from the fan center to the circumference causes a reduced pressure at the fan center or inlet, I, towards which more air moves, to be thrown in turn to the circumference, thereby keeping up a continuous flow of air through the fan.

这种位移的空气从范中心到周长原因减少的压力，在樊中心或进气道，我，对更多的空中动作，被扔在谈一下围，从而保持了连续流动的空气通过风扇。

The research results are highly reproducible owing to the repeatable micro-model technique.(2) Quantifying the Kr-S-P curves in two-phase flow. The validity and adaptability of multi-phase curves are verified using micro-model testing bed tailored to adequate scale of pores. Results obtained from the P-S micro-model tests generally agree with the threshold values of displacement mechanism offered by researchers using geometric shapes. The hysteresis of .experimental Kr-S curves of numerous two-phase flows are depicted in terms of connectivity and humidification. The P-S and Kr-S curves of two-phase flow are well-derived in conjunction with micro-model test results and empirical van Genuchten model. For the curve expressing the relation between saturation and capillary pressure, experimental results of water-air flow system corresponds to the theoretical data.

2二相流体对微模型实验之Kr-S-P关系：包括以孔颈尺寸比例组成微模型板实验平台去证实多相流流动主要特性曲线正确性与适用性；验证水和空气二相流之P-S微模型实验，与前人以几何形状所推估出来的置换机制门槛值大致吻合；以连通性及润湿性等解释多组二相流体对Kr-S曲线实验之迟滞现象；以微模型实验结果配合van Genuchten特性曲线经验式互推估二相流体对之P-S与Kr-S 曲线，推估结果良好；以比例原则推估多组二相流体於毛细压力-饱和度曲线的结果，显示在水和空气二相流体对为参考流体对时，推估其他组流体对吻合度最佳。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。