空气控制

You can change pattern width by remote control during painting by controlling center air and horn air independently, resulting in reducing overspray.

您可以通过远程控制模式，在绘画的宽度控制中心空气和独立喇叭空气，减少喷涂造成。

Based on a series of signal process and noise source identification techniques, especially the major noise source identification methods, such as expurgation method, sound intensity analysis, spectrum analysis vibro-acoustic correlation analysis and so on, the pass-by noise control of SC7080A and SC6360B are studied in detail. By the roadway and dais experiments, the major noise and radiating parts are identified and some economical controlling methods are made. For the SC7080A, to control the emissing noise from the intake and shell vibration of air cleaner, a intake muffler is installed between the air cleaner and intake valve. Based on the theory of Helmholtz resonator, One three-parallel-connected resonant silencer is designed and trial-manufactured. For the SC6360B, the attenuation performance of exhaust muffler in high frequency region is improved. To reduce the vibration noise of shell part, the structure of oil sump tank, exhaust manifold shield and exhaust manifold shield are analyzed and improved. At the same time, some measures, such as sound absorption, sound insulation, are taken to reduce the noise of engine surface emissivity and a sound shield is designed.

本文首先综述了目前国内外汽车加速噪声控制的现状、主要方法和技术措施，在此基础上，结合SC7080A和SC6350B汽车的车外加速噪声水平及现状，综合运用分别运行法、声强法、频谱分析法、声振相干函数法等现代噪声源识别方法，对SC7080A和SC6360B汽车进行了准确详细的车外加速噪声源识别并提出了经济可行的控制方案，针对SC7080A，主要在空气滤清器和进气阀门之间的进气管道上加装进气消声器，抑制空气滤清器壳体表面和进气口两处的噪声辐射，根据Helmholtz共振腔原理设计了三腔并联旁支型共振消声器，并进行了工程化设计和试制；针对SC6360B，主要改善了排气消声器在高频段的消声性能，对罩壳类零件进行了结构改进，降低了其表面噪声的辐射，并对发动机舱进行了吸声、隔声处理，设计了发动机隔声罩。

The first step of simulation method is to establish the one-dimension parabolic partial differential advection diffusion equation that was used to describe the mass transportation model of air-pollution distribution as a block program model of the controllable plant. Then, applying the Fuzzy logic theory to operate tunnel jet-fans and control the tunnel wind quantity and adjust the wind average velocity would not let the air-pollution concentration over the standard safety value too much.

模拟方式首先将常被用以表示隧道内空气污染物质传理论模式之一维向平流扩散抛物线型偏微分方程式建构成一组可控制对象的方块程式模拟模型，再运用模糊逻辑理论模拟控制喷流式通风机之运转风量来调节隧道内平均风速以控制隧道内空气污染物浓度不至於高过标准安全值太多。

The method of using formaldehyde buffer solution a b sorption-hydrochloric pararosaniline spectrophotometry to determine sulfur diox ide in air has higher sensitivity and good selectivity,and prevents from adoptin g mercurial absorbent.But the conditions in lab are not well controlled,the v alue of reagent blank and standard curvilinear slope can't accord with the one s tipulated in"Methods for Air and Waste Gas Monitoring and Analysis".Some opra tional techniques for SO2 determination in lab are introduced for reference.

文摘：以甲醛缓冲溶液吸收-盐酸副玫瑰苯胺分光光度法测定空气中的二氧化硫，方法灵敏度高，选择性好，避免了使用含汞的吸收液，但如果实验条件控制不好，试剂空白值及标准曲线的斜率就会不符合《空气和废气监测分析方法》中规定的值，本文着重从操作技巧方面对二气化硫测定的实验室质量控制进行分析，仅供参考。

Using the method of positive direction logic illation,finally the control connection between inflow in combustion section and resident time of waste in each furnace section is found.

分析了城市生活垃圾焚烧炉中关键的技术环节垃圾自动燃烧的控制过程，在此基础上提出了一种控制燃烧过程的智能控制方法，根据提取的影响焚烧过程的特征行为空间，分析了在不同种情况下行为提取算子，找到了以空气进气量和炉床运行速度为基本控制变量的控制基元组合。

Thermal comfort and indoor air quality requirements are presented; the contents cover the following topics:(1) Concept of air-conditioning,(2) Thermal principle,(3) Psychrometry and wetted-surface heat transfer,(4) Heating and cooling-load calculations,(5) Air-conditioning systems,(6) Fan and duct system,(7) Pumps and piping,(8) Cooling and dehumidifying coils,(9) Air-conditioning controls,(10) Absorption refrigeration,(11) Heat pump,(12) Cooling towers and evaporative condensers.

课程大纲本课程将介绍空调工程与系统设计，藉由湿空气线图讨论空气调节之过程，分析人体舒适与空气品质之需求，及各种空调设备系统之设计，内容涵盖如下：(1)空调的概念(2)热原理(3)湿空气与湿表面热传(4)加热与冷却负荷估算(5)空调系统(6)风扇与风管系统(7)泵与管路配置(8)冷却与除湿盘管(9)空调自动控制(10)吸收式冷冻系统(11)热泵(12)冷却水塔与蒸发式冷却。

Fuzzy control was used in regulation loops of furnace temperature oil fuel, air flow and hearth pressure.

炉温、燃油、空气流量和炉膛压力调节回路采用模糊控制，燃油／空气比例采用模糊自寻优控制。

The paper firstly analyze for nonlinear stiffness characteristic of the air spring and provide four type of hypothesis to nonlinear stiffness of the air spring, that is: rubber material nonlinear、composite of rubber and lining cloth nonlinear、 contact nonlinear and geometry nonlinear. Using test method relation curve between stiffness of air spring and on/off time of electro-magnetic valve had been established and the formula has been drawn up.

本人在2001年承担了吉林省科技厅资助的&汽车电控空气悬架系统研究开发&项目，论文的内容是该项目的核心部分，重点在于控制算法的研究和控制系统的设计，为最终在整车上实现空气悬架的自动控制进行前期的基础研究和必要的设计准备工作。

The attitude changes of the air spring vibration isolation platform caused by the leakage of the air spring are thoroughly analyzed and a quick check method for identifying the defect air spring is proposed.

文中分析了空气弹簧漏气对隔振平台姿态的影响，提出了一种漏气快速检测方法，利用模糊控制理论对空气弹簧隔振平台的姿态控制进行了研究和试验。

One new auto-optimized fuzzy control model of car-engines based on genetic arithmetic was introduced aiming at the problem that the parameters of car-engine are of the discreteness, the nonlinear and the uncertain characteristics, with which it is difficult to control accurately the excess air coefficient and the spark advance angle in dynamic procedure when using a conventional control model.

针对汽车发动机参数具有离散性、非线性和不确定性，采用传统控制模型难以精确控制瞬态过程的过量空气系数和点火时刻的问题，提出了一种基于遗传算法的发动机自寻优模糊控制模型。设计了实现该控制模型的嵌入式控制器，讨论了实时在线仿真基础上，采用遗传算法对模糊控制参数的自动寻优。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。