离心的

The results show that at normal temperature,the demulsify volume is 2 percent of the oily sludge volume, the volume percent of solvent is 80 percent, and the centrifugalization is fifteen minutes with 1500 revolutions per minute.

对胜利油田郝现联合站的罐底泥进行了分析，针对油泥特点，进行了化学破乳溶剂萃取离心分离的脱油处理技术研究。

Key words: oily sludge; chemical demulsification; solvent extraction; centrifugalization

对胜利油田郝现联合站的罐底泥进行了分析，针对油泥特点，进行了化学破乳溶剂萃取离心分离的脱油处理技术研究。

ResultThe maximumabsorption wavelength of reaction solution was about 720nm.The fermentation volume,adding the activated carbonor not,pHvalue of reaction solution and so on had no great effect onthe determinationresults and they could increase the screening efficiency.The effect of ultrasonic treatment for20min was obvious.When50ml volumetric flask was used,the suitable sampling volume was 2.5ml.It was better to centrifugate the fermentationliquid and the supernatant could be taken after standing inthe determination when necessary.

结果反应液最大吸收波长在720nm左右；发酵体积、加入活性碳与否、反应液的pH值等对测定结果影响不大，在筛选时可大大提高效率；超声波处理20min效果明显；在用50ml容量瓶进行定容时，取样体积以2.5ml为宜；对发酵液进行离心效果更好些，但在必要的情况下，可静置后取上清测定。

The invention discloses a method for extracting polysaccharide from chiretta and an application, which comprises breaking dry chiretta via a breaker into powder, arranging into an extraction pot, adding ligarine to reflux and defat, adding distilled water into defatted residues to extract, processing alcohol precipitation and centrifugation to obtain deposits, removing protein, processing acid hydrolysis and gel chromatography separation, freezing and drying to obtain active chiretta polysaccharide.

本发明公开了一种从当归中提取多糖的方法及应用。干燥当归用粉碎机粉成粉末，置入提取罐中，加入石油醚回流脱脂，向脱脂后的残渣中加入蒸馏水提取，醇沉、离心得沉淀，除去蛋白、酸解、凝胶色谱分离、冷冻干燥得到活性当归多糖。

The centrifugal、filtration and extraction of conventional process were replaced by degrease cotton adsorption、filtration and membrane,thus the operating time is shorten considerably.The experiment result showed that:the content of active components is increase from 75%to 85%.

通过此工艺，将原来工艺中的离心、过滤和萃取替代为脱脂棉吸附、过滤和膜分离，缩短了操作时间，实验结果表明：使总莲心碱含量从原来的75%提高到85%。

Both polymer and non-polymer forming starter were used in the yogurt.Cultured broth was digested for 16h at pH 7.5, 30 with Pronase, precipitated with 95% ethanol, centrifugation (12000*g, 20min)and dialyzation, thus get the crude EPS, HPLC was choosed to determine the EPS composition in the cultured broth.

将产粘菌株与普通酸奶生产菌结合用于制作酸奶，用链霉蛋白酶在pH 7.5，30℃条件下消化16h，再用95％乙醇沉淀、离心、透析获得粗多糖，HPLC法测定发酵液中的糖组成及EPS的单体组成。

DSC and dilatometry were carried out to determine the phase transformation temperature of a high speed steel used for centrifugal cast rolls.

采用差式扫描量热法及热膨胀法测定了离心铸造轧辊用高速钢的相变点，根据高速钢的临界转变温度，进行了退火、淬火和回火实验。

In this study, Mono-nuclear cells containing hematopoietic stem/progenitor cells were isolated from umbilical cord blood of normal full-term deliveries, healthy adult and heterocellular HPFH patient bone marrow by density gradient centrifugation. After simple purification and expansion in vitro, MNCs were induced to erythroid cell differentiation using different culture systems and cytokines including Epo, IL-3 and GM-CSF.

本研究首先利用密度梯度离心方法，从正常成人和异细胞型遗传性胎儿血红蛋白持续存在综合症家系患者的骨髓组织、健康足月正常分娩胎儿脐带血中分离得到了含有造血干／祖细胞的单个核细胞(Mono-Nuclear Cell，MNC)，进行初步纯化及体外扩增后，组合使用Epo、IL-3、GM-CSF等细胞因子，将造血干／祖细胞向红系方向进行诱导培养。

The effects of RE compound modificator on the mechanical properties and microstructure of high carbon high speed steel used for roller ring were investigated by SEM, EDS and EPMA.

通过扫描电镜、能谱分析仪和电子探针研究了稀土复合变质剂对离心铸造的高碳高速钢轧辊组织和力学性能的影响。

The analyses of flow characteristics and the calculations of theoretical flow fields on blade-to-blade surfaces and the turbulent boundary layers in forward multiblade impellers were described in this paper.

本文分析了离心风机前向多翼叶轮内的流动特性，计算了跨叶片面内的理想流场和湍流边界层。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。