磨损性

ABSTRACT A new category of steels having excellent combinations of strength, toughness and strain-hardening ability and excellent resistances to high-stress, especially to severe impact-loaded abrasion was developped with a new idea of abrasion-resistant materials designing.

本文以新的耐磨材料合金设计思想，研制了一类同时具有很高强韧性和良好加工硬化能力、在高应力尤其是高冲击负荷磨损条件下耐磨性十分优异的新型耐。。。

It has good properties, such as, wettability, high flash point and viscosity, low pour point, and little action on metal and rubber. So it can decrease the friction force of moving surface to enhance antifriction.

具有良好的湿润性、高闪点和高粘度、低倾点等优良性能，对金属和橡胶的作用很小，减小运动表面间的摩擦力，提高抗磨损能力。

A new type in-situ reinforcing Cr7C3 ceramal composite coating was fabricated on carbon steel(C3) substrate by plasma cladding. Microstructure of the ceramal composite coating was characterized by SEM, XRD and EDS. Room and high temperature wear properties were evaluated under dry sliding wear test conditions and their wear mechanism was discussed.

采用等离子熔覆技术，在调质C3钢表面制得以原位生成初生相Cr7C3为增强相的金属陶瓷复合材料涂层；利用SEM、XRD和EDS等分析了涂层的显微组织和相组成；测试了在室温干滑动磨擦及高温滑动磨擦条件下涂层的耐磨性，并讨论了其磨损机理。

The hardenability of medium-temperature phase transformation of 290Cr8Si2 wear-resistant medium chrome cast iron is worse than that of 290Cr8Si1 medium chrome cast iron .

耐磨损290Cr8Si2中铬铸铁热处理中温相变的淬透性低于290Cr8Si1中铬铸铁。

Valve: The sealing performance between valve check and seat ring will be damaged because of worn and corrosion. If this occur, close the main valve and take down the valve clack to polish.

阀门：吹灰器阀门因为吹灰介质的磨损和腐蚀，会引起阀瓣与阀座环间密封性的破坏，如果出现这种情况，应关闭吹灰器总阀，取下阀瓣研磨。

The lower wear－(reduce coater and business card printing and membership card production version tearover).

较低的耐磨性(减少涂布机和制卡和会员卡制作版的磨损)。

The results show that the brush-plating coating is even and compact from section plane with good toughness and adhesion. The microhardness of the coating is 230.6HV0.5 which is 3 times of cast aluminium substrate. The wear resistance of the coating is 3 times of cast aluminium substrate. But the friction coefficient of the coating is 0.70 which is more high than that of the substrate, which is favorable for the fixed conjugate between the axis sheath and the axis seat of the gear-box.

结果表明，镀层厚度分布均匀、致密，镀层与基体界面清晰，未出现氧化物夹层，镀层的韧性和结合强度均较好；测得碱性铜及铸铝基体的显微硬度分别为230.6、74.2HV0.5；碱性铜的镀制使基体表面显微硬度及耐磨性均提高了2倍多，磨损状况明显改善。

Chill blocks are also used at points where it is designable to have localized hardening, as in the case of bearings or wear surfaces.

冷块也用于站后，这是设计性，以有局部硬化，在案件或轴承磨损表面。

Composed of square door frames, gate, rack , sealing strip, adjustable structure of sealing , this kind of sealing principle is door frame is fixed on square pipe of pool and wall, rack is fixed on door frame and wall, through rack opens and closes till weld block of gate meets with weld block of rack to make sealing surface of gate close to sealing surface of door frame to achieve sealing .Besides , sealing of gate and sealing of door frame are made of inlaid copper which is well resistance ,It makes valve with well sealing ,wear resistance , corrosion resistance, easily operation, convenient installation , long life , wildly usage.

本闸门是由方型门框、闸板、导轨、密封条、可调整密封机构等部件组成，其密封原理是门框固定于水池方型管道及墙壁上，导轨固定门框与墙壁上，闸板通过导轨做启闭动作，直到闸板上的锲块碰到导轨条上的锲块，使得闸门密封面紧靠门框上的密封面，从而起到密封效果，另外闸板密封面跟门框密封面都是镶铜材质的，具有耐磨损的特性，使得阀门密封密封性好、耐磨性强、耐腐蚀、操作简单、安装方便、使用寿命长、适应性广等特点。

At the evaluation parameters part, the article point out 20 suspension parameters to evaluate the vehicle independent suspension kinematics and elasticity kinematics characteristics, and give the exact definitions of these 20 parameters, at the same time the article endeavors to discuss the changeable characteristics of these parameters and their influences to the vehicle handling performance.

分别指出了反映了车轮定位、顺从转向、车身纵倾和侧倾、车轮回正性、转向轻便性和轮胎磨损等独立悬架运动学和弹性运动学特性的20个悬架参数指标，给出了它们的定义，并尽力阐述了这些参数对汽车操纵稳定性等重要性能的影响及其合理的变化趋势或范围。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。