磨损

The friction coefficient and wear coefficient of resin depended on the content of hardener and independent the content of active dilution.

实验中发现，线性酚醛环氧树脂固化物的摩擦磨损性能与固化剂的结构和用量紧密相关，低于理论计算用量的固化剂与线性酚醛环氧树脂生成的固化物具有更低的摩擦系数和更强的抵抗磨损的能力。

Suggested that wear of a polyethylene socket combined with a ceramic head might be as much as 20 times less than with a metal head.

Semlitsch等所做的早期体外磨损试验发现，聚乙烯臼配陶瓷头的磨损比配金属头小20倍。

It adopt many leaf's number to reduce the single abrasion of leaf's slice for this designing slurry pump, also increased combines over the thickness that flow the parts the high degree of hardness in adoption bears to whet the material to come to let up the wear and tear, and empressed an entrance covers plank design as to bulge and smooth hubcap head .

因此所设计的渣浆泵中采用多叶片数来减少单个叶片的磨损，适当的增加过流部件的厚度并采用高硬度的耐磨材料来来减小磨损，将叶轮入口的后盖板设计为凸出的、由光滑圆弧组成的轮毂头。

Nano- and Micro-Hardness Testers（Nano Indentor/Micro Indentor）- Quantitative measurement of mechanical surface properties: elastic modulus and hardness - Analysis of fracture modes, cracking,… Nano- and Micro-Scratch Testers - Adhesion and anti-scratch properties of coatings and films - Profilometry Tribometers - High Temperature, Vacuum and Nano Tribology - Wear and Friction studies Calotest / Calowear - Coating thickness measurement - Wear rate testing 3D Imaging - Atomic Force Microscope - Confocal Microscope

动态压痕测试仪器为您提供纳米或微米尺度下材料的硬度、弹性模量、蠕变、断裂韧性等性质。我们还为您提供纳米级、微米级摩擦磨损测试仪器，用以测量材料的摩擦系数和磨损率。我们的球磨仪器是测量薄膜厚度最简单准确的工具。我们同时提供光学显微镜、原子力显微镜、白光共焦显微镜成像工具。我们在瑞士的分析测试中心随时准备为您提供高质量测试服务。

Picker-wheel support structure was used in strip label papers of tobacco industry, but it had appeared some problems: picker-wheel vibrates easily, label paper was picked insecurely, and double-shafts generated deformation and linear bearings wear easily. The ultimate cause was founded by analyzing linear bearings stress from statics and dynamics. The original structure of double-shafts one-side support was replaced by two-side support with one fixed end and one free end.

针对FOCKE350S条盒商标纸拾取轮总成支撑结构拾取轮易振动、商标纸拾取不可靠、双轴易弯曲变形、直线轴承磨损快的情况，从静力学和动力学的角度分析了直线轴承磨损快的根本原因；并将原来双轴单侧支撑结构改为双轴双侧支撑，采用一端固定，一端游动的支撑方式。

Picker-wheel support structure was used in strip label papers of tobacco industry, but it had appeared some problems : picker-wheel vibrates easily, label paper was picked insecurely, and double-shafts generated deformation and linear bearings wear easily. The ultimate cause was founded by analyzing linear bearings stress from statics and dynam-c- teplaced by two-side support with one fixed end and one free end.

针对FOCKE350S条盒商标纸拾取轮总成支撑结构拾取轮易振动、商标纸拾取不可靠、双轴易弯曲变形、直线轴承磨损快的情况，从静力学和动力学的角度分析了直线轴承磨损快的根本原因；并将原来双轴单侧支撑结构改为双轴双侧支撑，采用一端固定，一端游动的支撑方式。

According to the data analysis of erosion and damage of a cannon barrel,the paper locates the characteristic planes of erosion and abrasion,and then uses several characteristic planes to describe the change of interior ballistics.

通过对某加农炮的身管烧蚀磨损特征数据进行分析整理，确定了身管烧蚀磨损特征面，采用了多特征面来表述火炮内弹道性能变化。

The results of tests of friction and wear shows that the coefficient of kinetic friction of specimens is decreased by 64%～77%,and the wear rate of specimens is decreased by 22%～48%.

精密摩擦、磨损试验及显微硬度测量结果，试件表面的滑动摩擦系数降低了64%～77%；磨损率减少了22%～48%；显微硬度提高0.3～1.4倍。

The result shows the tribology properties are good, the kinetic friction coefficient are under 0.1. In the same conditions of wearing test, the weight loss of surface treated with EDC is about one tenth of the weight loss without treatment, and is about one sixth of the weight loss treated with electroless composite coating.

结果表明：在本试验的条件下，涂层的滑动摩擦系数较小，均在0.1以下，说明涂层的摩擦学性能较好；在相同的磨损实验条件下，用液中放电沉积方法处理过的表面磨损失重量是未处理表面的1/10左右，是化学复合镀方法处理表面的1/6左右，说明涂层的耐磨性相对较好。

Test results of EMP-steel frictional pairs showed that the wear rate h of EMP, press p andvelocity v are suited to equations separately: h =m .p n and h =a .v b.

试验证明EMP复合材料瓦与钢对磨时的磨损率h与压力p、速度v之间分别满足h=m.pn和h=a.vb关系式，给出了相应系数m、n、a、b的值；磨损率与钢试件表面粗糙度Ra之间满足h=A·RaB关系式，给出了A、B的有效范围值。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。