磨损

To investigate the wear mode of the silicon nitride balls in lapping process, a series of abrasion tests were carried out on a ball-plate wear test apparatus with different loads, abrasive girt diameter, and slurry concentrations.

为掌握不同研磨条件下氮化硅(Si3N4)陶瓷球表面的磨损形式，在球－盘式磨损实验装置上，采用不同载荷及磨料粒度和浓度的碳化硼(B4C)磨料进行了磨损实验。

The experimental results show that the erosion behavior is similar to that of brittle ceramic materials while the maximum erosion is found to occur at a jet angle of 90 degrees. The successive spalling of splats ...

结果表明：Cr3C2 NiCr涂层的冲蚀磨损呈现脆性材料的冲蚀磨损特征，在 90°冲蚀率最大；磨料冲击引起的裂纹沿涂层内粒子界面萌生、扩展并最终导致粒子剥落，是涂层主要的冲蚀磨损机制。

In the paper,the working principles of the cutting tools are analyzed,the wearing of the cutting tools during the shield boring is investigated,analysis and study are made on the features of and causes for the wearing of the disc cutters and scrapers,the reasons for the wearing are summarized and some recommendations are made.

在对刀具切削原理的分析和盾构掘进中的刀具磨损情况进行了现场调查的基础上，对滚刀和刮刀的磨损特点及原因进行了分析和研究，指出了磨损的主要原因，最后提出了合理的建议和意见。

In the paper,the working principles of the cutting tools are analyzed,the wearing of the cutting tools during the shield boring is investigated,analysis and study are made on the features of and causes for the wearing of the disc cutter s and scrapers,the reasons for the wearing are summarized and some recommendations are made.

在对刀具切削原理的分析和盾构掘进中的刀具磨损情况进行了现场调查的基础上，对滚刀和刮刀的磨损特点及原因进行了分析和研究，指出了磨损的主要原因，最后提出了合理的建议和意见。

And the wear of stator is the least. With i〓 increasing, wear of planet gear obviously increases.

行星轮轮齿的磨损最为严重，蜗杆齿面的磨损次之，定子齿面的磨损最轻。

Theoretically the pump blade failure mechanism was worn on, the impact of wear failure leaves the various factors was analyzed, combined with practice pumping station operation and maintenance experience, the focus at a reasonable selection, surface heat treatment, non-metallic protective coating alloy powder spray repair welding and welding six aspects, premature wear of the pump blade technical measures and repair methods was prevented in order to enhance its effective life.

理论上阐述了水泵叶片磨损失效的机制，具体分析了影响叶片磨损失效的各种因素，并结合泵站运行实践和维修经验，重点在合理选材、表面热处理、非金属涂层防护、合金粉末喷焊和补焊等6个方面，提出了防止水泵叶片过早磨损的技术措施和修补方法，以提高其有效的使用寿命。

Injector fuel supply or pressure is not enough, atomization bad, drip, etc.; plunger rod adjustable arm or teeth protruding ears from the governor lever fork slot prolapse in non-oil position; fuel pump plunger and barrel assembly seriously wear and tear, oil pressure is too low, the oil valve wear serious Mifengbuyan; washer crack and deformation, a broken valve spring, injector wear and tear stuck in the closed position.

喷油器不供油或压力不足、雾化不良、滴油等；柱塞调节臂或齿杆凸耳从调速杠杆叉槽中脱出处于不供油位置；喷油泵柱塞偶件严重磨损，供油压力太低，出油阀磨损严重，密封不严；垫圈开裂变形，出油阀弹簧折断，喷油器磨损卡死在关闭位置。

If there is no excessive wear or the time gap, they should check: First, the steering gear worm gear wear, or the required space, such as the gap is too large to be adjusted; Second, the shift device connected part of the wear and tear, or whether or not to adjust too loose; Third, the steering is loose parts installed; Fourth, there are loose steering arm down.

如无过大磨损或间隙时，则应检查：第一，转向器蜗轮蜗杆磨损情况，或间隙是否符合规定，如间隙过大应调整；第二，转向装置连接部分的磨损情况，或是否调整得过松；第三，转向器安装部位是否松动；第四，转向垂臂有松动。

Iron-based composite coatings were deposited on mild steel substrate by arc spraying cored wire with WC-CoNi ceramic powders. The abrasion wear properties were evaluated using a examined MLS-225 wet sand/rubber wheel tester. The microstructure, phase compositions and worn surface of the coatings were examined by means of optical, scanning electron microscopy and X-ray diffraction.

采用电弧喷涂含WC-CoNi金属陶瓷粉末的粉芯丝材，在低碳钢基体上制备铁基复合涂层，采用MLS-225型湿砂橡胶轮磨损试验机评价铁基复合涂层的耐磨粒磨损性能，利用光学显微镜、扫描电子显微镜和X射线衍射仪对涂层的显微组织结构、磨损表面及其相组成进行分析。

The effectiveness of the technique in recognizing the kind of wear is also discussed, studying the application of neutral network technique on the expert system of wear diag...

使用神经网络技术可以大大提高发动机磨损故障诊断的效率，说明该技术方法在发动机磨损故障诊断领域是有效的，同时对其它机械设备的磨损故障诊断具有借鉴意义

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。