磁头

Read data, the dish a high speed revolves, because of adopting to a sport the delicate aerodynamicist designs, the this time the head of 磁 is placed in to leave the dish data area 0.2-0.5 microns are high of" fly appearance".

读取数据时，盘片高速旋转，由于对磁头运动采取了精巧的空气动力学设计，此时磁头处于离盘面数据区0.2---0.5微米高度的"飞行状态"。

Hard work in time to avoid the shock of it, because the distance between head and disk very close to, if clustering was head of the shock will lead to knock disk may be scratched disk heads, but also may lead to the total head count of the bad, the entire hard disk can not be used.

在硬盘工作的时候要尽量避免它的震荡，因为，磁头与磁片的距离非常近，如果遭到聚类的震荡会导致磁头敲打磁片，有可能磁头会划伤磁片，也可能会导致磁头的彻底算坏，使整个硬盘无法使用。

Head: your hard disk head to read the disc or modify the state of the magnetic material, generally speaking, each side will have a magnetic head from the top of the beginning number from 0 to start.

磁头：硬盘的磁头用来读取或者修改盘片上磁性物质的状态，一般说来，每一个磁面都会有一个磁头，从最上面开始，从0开始编号。

The method controls the move of head flying over the disk by firmware and analyzes the width change of projection of the read head, write head and erase band. The experiment shows skew angel can change off-track capability of magnetic head and change the radial error propagation of radial error of self servo-writing.

分离式磁头对硬盘驱动器伺服信息自刻写的影响同样不容忽视，为此提出了一种测定磁头偏移磁道能力大小的方法：通过控制磁头飞行过程，并在飞行过程中动态获取读头信号幅度和比特误差率，从而获取磁头磁道偏移能力。

The effect on morphology of magnetic head by particle size of nano-diamond in polishing process was studied.

研究了纳米金刚石研抛液对磁头进行表面研抛时，纳米金刚石悬浮液的粒度对磁头表面形貌的影响，评价了由该种研抛液抛光所形成的磁头基体表面质量。

In this paper. a novel magnetic head crab track pluck detection way is given by the analysis of etched servo graph for 4000 TPI etched surface servo. It improve the maximum seek track speed of magnetic head greatly, So that magnetic head can seek track at high speak for high track density.

光刻伺服盘是一种新的磁头伺服定位技术［1］，通过对4000TPI光刻面伺服系统的光刻伺服图形结构的分析，本文提出了一种简单可靠的磁头过道脉冲检测方式，可显著提高磁头寻道速度，保证磁头在高道密度下高速寻道。

Head component damage: mainly refers to the hard drive head components of a partially damaged, resulting in some or all of the normal read-write head can not be the case.

磁头组件损坏：主要指硬盘中磁头组件的某部分被损坏，造成部分或全部磁头无法正常读写的情况。

Head life expectancy is limited, and frequently will speed up the read-write head and head arm motor wear and tear and frequent disk read and write and even make the area a regional temperature, magnetic medium will affect the stability of the area will lead to read and write errors, due to high temperature will make the area of hot pockets of serious head and facial disc closer under normal circumstances head and disc surface only a few microns, have a closer?

磁头寿命是有限的，频繁的读写会加快磁头臂及磁头电机的磨损，频繁的读写磁盘某个区域更会使该区温度升高，将影响该区磁介质的稳定性还会导至读写错误，高温还会使该区因热膨涨而使磁头和碟面更近了（正常情况下磁头和碟面只有几个微米，更近还得了？

Consequently, the spring arm 53 pivots the magnet from a position closely adjacent the play/record head 13 at a rate controlled by the unwinding of tape to a position farther therefrom as illustrated in FIG.

就算没停，取出来之前一定是停的，因此，相当于把一个磁铁放在距离磁头1CM左右的地方。淘宝的那些买家是基于这些原因给予好评的吗，dtape同学？？？？更具体的描述如何远离磁头：通过偏心旋转使磁铁逐渐远离磁头。

Head components of the methods and the possibility of damage to many, including head dirty, head wear, head cantilever deformation, magnetic coil damage, such as displacement.

磁头组件损坏的方式和可能性非常多，主要包括磁头脏、磁头磨损、磁头悬臂变形、磁线圈受损、移位等。

This brought fixed cost, but it also is meant at the same time use a source to won't make you singlehanded assume a problem.

这带来了一定的成本，但它同时也意味着使用开源不会让你独力承担问题。

He gained a small fortune in real estate.

他在房地产上发了一笔小财。