碳化的

The reaction between the boron carbide and aluminum interface changes the properties of the composites during the post infiltration heat treatment.

碳化硼与铝界面的反应是热处理改变碳化硼／铝复合材料性能的基础。

In addition, the prediction model of carbonation depth is analyzed with the first order reliability method.

研究结果表明，拉、压应力分别可加快和减缓混凝土结构的碳化速度，Xσ反映了碳化速率的变化趋势。

The effect of styrene-butadiene latex on the water absorption ratio and the carbonization depth of cement mortar were studied.

研究了丁苯乳液对水泥砂浆吸水率及碳化深度的影响，并提出了吸水率、碳化深度的多因素预测模型。

The interface connecting between WC particles and high chrome cast iron was studied by using H 800 TEM, WE 10 and MM 200 testers, and the courses of removing WO 3 film on the WC particles and conducting the slag were analyzed with the help of thermodynamic calculations.

利用 H- 80 0透射电镜、WE- 10型万能拉伸试验机和 MM- 2 0 0型磨损试验机研究了碳化钨颗粒与高铬铸铁的界面结合问题，并对去除碳化钨颗粒表面的氧化膜和造渣过程进行了热力学计算。

Progress and key difficulties in the synthesis and characterization of carbon nitride crystals are summarized.

介绍了氮化碳晶体的合成与表征研究进展，分析了氮化碳晶体合成中存在的主要困难。

Then, the statistic characters about carbonation depth such as average, deviation, model of normal distribution and its density function and etc. are also given.

同时，给出了碳化深度的统计特征即平均值、标准差、变异系数统计量和碳化深度正态分布的概率模型及其密度函数。

Composite electrodeposits of nickel-cobalt-tungsten carbide were prepared by adding tungsten carbide particles in the nickel-cobalt alloy solution.

研究了在镍钴合金镀液中加入碳化钨微粒形成镍－钴－碳化钨复合镀层的共沉积过程。

The Flex-Hone tool is available in a variety of abrasive types including Silicon Carbide, Aluminum Oxide, Boron Carbide,Tungsten Carbide, Levigated Alumina and Zirconia Alumina.

球头刷的研磨粉可提供各种材料，包括：碳化硅、氧化铝、碳化硼、碳化钨、氧化铝、氧化锆。

Based on light burned magnesia as raw material, factors that influence dissolution and Mg2+ carbonation, such as particle size, dissolution time, carbonation temperature, and compositions, et al, were studied.

以轻烧镁为原料，对溶浸和Mg2+碳化过程中的主要影响因素，如物料粒径、溶浸时间、碳化温度以及配料组成进行了研究。

Based on light burned magnesia as raw material, factors that influence dissolution and Mg(superscript 2+) carbonation, such as particle size, dissolution time, carbonation temperature, and compositions, et al, were studied.

以轻烧镁为原料，对溶浸和Mg(上标 2+)碳化过程中的主要影响因素，如物料粒径、溶浸时间、碳化温度以及配料组成进行了研究。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。