硅铁

The process to substitute ferro-silicon-aluminium with ferro-silicon-aluminium-barium as end deoxidizer is discussed.

对河北敬业钢铁有限公司炼钢厂用硅铝钡铁代替硅铝铁作终脱氧剂工艺进行了探讨，认为该工艺是可行的，钢水浇注性能良好，并且可获得明显的经济效益。

The process to substitute ferro-silicon-aluminium with ferro-silicon-aluminium-barium as end deoxidizer is discussed. It is considered the process can be used for production because of the good casting performance of melting steel and distinguished economic profit.

对河北敬业钢铁有限公司炼钢厂用硅铝钡铁代替硅铝铁作终脱氧剂工艺进行了探讨，认为该工艺是可行的，钢水浇注性能良好，并且可获得明显的经济效益。

The device is fabricated by nonsilicon surface micro-machining, which uses the photoresist and the sputtered copper thin films as the scarificial layers, and the electroplated ferronickel as the structure layer to fabricate the optical MEMS components. The device consists of an electroplated ferronickel optical shutter interposed in a gap between two fiber alignment componets, an electroplated planar coil, a silicon spring, and two fiber alignment components with V-shaped grooves.

该衰减器利用非硅表面微加工工艺(这种工艺采用光致抗蚀剂和溅射铜薄膜作为牺牲层，电镀铁镍层作为结构层来制作MEMS元件)制作，由电镀铁镍层构成的一个插在两对准光纤空隙中的挡光片，一个平面电感线圈，一个硅弹簧和二个带有V型槽的光纤对准元件构成。

The ironrich and silicapoor liquids, commonly different from the low iron and silicarich liquids, are rare on the earth surface. There are not the same, which can be used to explain their petrogenesis at present.

在自然界中与普遍发育的具Bowen趋势的低铁富硅熔体不同，高铁贫硅岩浆非常罕见，也没有直接的现代类比物可以对比以解释其岩石成因。

In this thesis, basic manufacturing processes and techniques for integrated ferroelectrics, such as thin film deposition and film patterning, have been studied. Based on these studies, lead zirconate titanate ferroelectric thin film, which has higher piezoelectric constant than normal piezoelectric materials, is used in silicon-based piezoelectric miniature microphone.

本论文深入系统的研究了硅基铁电薄膜的制备方法及刻蚀加工等集成技术，在此基础上创新性地提出将具有优异力电耦合性能的锆钛酸铅铁电薄膜用于硅基微麦克风研制的思想，完成了器件的优化设计，并成功实现了国际上首个铁电微麦克风器件原型。

It is indicated that the hexagonal calcium hydroferrite is a kind of high scattered calciferous compound. The interplanar spacing of hexagonal calcium hydroferrite is wide. The desilication activity of hexagonal calcium hydroferrite is higher. And the loss of alumina can be reduced.

结合X射线衍射分析讨论水合铁酸钙的脱硅机理，提出水合铁酸钙是一种高度分散的含钙化合物，其晶面间距较大，脱硅活性较高，并可大幅度降低铝损。

Purified water, euphorbia cerifera wax, glyceryl stearate, ammonium acrylates copolymer, butylene glycol, copernica cerifera wax, stearic acid, sucrose acetate isobutyrate, acrylates copolymer, bentonite, tromethamine, hexylene glycol, silk amino acids, cholesterol, glycine, synthetic wax, ethylhexyl glycerin, alanine, PEG-9 dimethicone, nylon-6, lecithin, silica, simethicone, caprylyl glycol, xanthan gum, propylene glycol, isostearic acid, sodium laureth-12 slfate, ceteareth-20, polyvinyl alcohol, sodium chloride, sodium acetate, disodium EDTA, benzyl alcohol, chlorphenesin, phenoxyethanol, methylparaben, ethylparaben, propylparaben, butylparaben, isobutylparaben, may contain /- mica, iron oxides (CI 77491, CI 77492, CI 77499), titanium dioxide (CI 77891), ferric ferrocyanide (CI 77150), ultramarines (CI 77007), blue 1 lake (CI 42090), bronze powder (CI 77400), aluminum powder (CI 77000), bismuth oxychloride (CI 77163), carmine (CI 75740), chromium hydroxide green (CI 77289), chromium oxide greens (CI 77288), yellow 5 lake CI 19140

水，小烛树蜡，硬脂酸甘油酯，丙烯酸铵共聚物，1，3-丁二醇，巴西棕榈蜡，硬脂酸，异丁酸醋酸蔗糖酯，丙烯酸酯共聚物，蒙脱土，二吡喃乙酸乙酯胺，已烯醇，丝氨酸，胆固醇，甘油，合成蜡，异丁基甘油，丙胺酸，PEG-9二甲基硅油，尼龙-6，卵磷酯，硅粉，硅氧烷，癸酰基乙二醇，汉生胶，丙二醇，异硬脂酸，月桂基醚-12硫酸钠，十六十八醇醚-20，聚乙烯醇，氯化钠，醋酸钠，EDTA二钠，苯氧乙醇，氯代苯酚，卞醇，尼泊金甲酯，尼泊金乙酯，尼泊金丙酯，尼泊金丁酯，尼泊金异丁酯，[可能还含有云母，铁黑(CI 77491， CI 77492， CI 77499)，钛白粉(CI 77891)，氰化亚铁(CI 77150)，靛蓝(CI 77007)，蓝1号(CI 42090)，青铜粉(CI 77400)，铝粉(CI 77000)，氯氧化铋(CI 77163)，洋红色素(CI 75740)，氢氧化铬绿(CI 77289)，氧化铬绿(CI 77288)，黄5号(CI 19140)]文章来自网络，不代表本网站立场，版权归原作者所有，转载请注明出处！

The result shows that modification can make the β-Si phase thin when the joining amount is 0.3wt%, making the best modification result. Alloying elements Mn and Ni are always used to neutralize iron"s harm in aluminum alloys. They can form many kinds of complicated metallically compounds with Fe and Al, and eliminate needle-like iron-rich phases to reduce iron"s harm in Al-Fe alloy. Copper makes the alloy microstructure thick and electromagnetic stirring obviously makes the alloy microstructure thin, round the second phase, when the stirring voltage is 200V, making the best result; Reheat makes liquid phases emerge in the alloy, when the warming temperature is 650?

研究结果表明：红磷可以明显细化合金中的初晶硅，当加入量为0.3wt%时，取得最佳变质效果；锰、镍合金中加入后，通过形成多种复杂金属间化合物，细化针片状富铁相，减小铁对铝硅合金性能的危害；铜使合金微观组织发生粗化；电磁搅拌明显细化合金组织，使第二相圆整化，搅拌电压为200V时，取得最佳细化效果；二次加热使合金组织中产生部分液相，在650？

Using silicon and metallic iron,α-Si_3N_4 olivary microparticles with a diameter of about 300～500 nm have been obtained at 650℃.When silicon and metallic aluminium were used to react with ammonium chloride,α-Si_3N_4 nanowire bundles with diameter of about 8 nm can be also obtained at 600℃.Since all of the starting materials used are relatively cheap,the methods will have potential prospect in industrial application.3.Graphite-like carbon nitride nanowire bundles with diameters of 200-500 nm were synthesized from the solid state thermolysis of melamine at relatively low temperature(400℃).

相关研究工作的成果发表在International journal of applied ceramicstechnology.2、以廉价的硅铁合金和氯化铵为原料，在600℃合成了α相的氮化硅纳米线束，单根纳米线直径8 nm，长达800 nm，考察了反应温度和反应时间对产物纯度和形貌的影响；以硅粉和铁粉为原料合成了纯度良好，直径为150～500 nm的α-Si_3N_4亚微粒子；以硅粉和铝粉为原料在400-600℃合成了直径为10 nm左右的α相氮化硅纳米线束。

Monolayer.2. A Novel Sensor Based on Layer-by-Layer Hybridized Phosphomolybdate and Poly on a Cysteamine Modified Gold ElectrodeA novel sensor have been constructed by layer-by-layer hybridizing phosphomolybdate and poly on a cysteamine modified gold electrode.

磷钼杂多酸和聚二茂铁硅烷多层组装膜修饰电极及其电化学行为采用层层组装法在金电极上组装多金属氧酸盐阴离子和聚阳离子聚二茂铁硅烷，交替沉积多层膜，构建了杂多酸-PFS多层膜修饰的金电极。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。