硅酸化

The main factors affecting the decompounding rate of sodium fluosilicate by calcined soda were confirmed.

探讨了碳酸化法合成冰晶石的工艺条件，确定了影响纯碱分解氟硅酸钠的分解率的主要因素，试验结果表明：氟化钠溶液的精制、n(6F)/n、反应温度等对冰晶石性能有显著的影响。

According to the study of thin sections, from the interior to the edge of the orebody, there are mainly K-silicate alteration, andalusite secondary quartzitization and beresitization, forming large areas of mineralization.

薄片研究表明：矿体由内至外主要发育钾硅酸盐化、强烈硅化、绢云母红柱石次生石英岩化和黄铁绢英岩化蚀变，形成了大范围的矿化。

The synthesis condition of PSFCS were: Fe-to-Si mol ratio being 2, silicic acid activation pH being 2, silicic acid activation time being 30~40 minutes, ageing time being 2~2.5 hours.

PSFCS的合成条件：Fe/Si摩尔比为2，硅酸活化pH值为2，硅酸活化时间是30～40 min，陈化时间是2～2.5 h。

The main ore_stage alterations related to hydrothermal fluids include ①early K_silicate alteration,②silicification,③ pyrite_sericite_quartz alteration and ④propylitization.

成矿期间与矿化热液活动有关的蚀变主要有：①早期钾硅酸盐化；②红柱石次生石英岩化；③黄铁绢英岩化；④青磐岩化。

Element analysis shows that Si exists on the surface of hybrid membrane when TEOS content is not too low. The effects of TEOS content on the performance of hybrid membranes were investigated.

实验初步考察了正硅酸乙酯的添加量对聚偏氟乙烯－硅杂化膜的超滤性能和力学性能的影响，对杂化膜进行了能谱分析。

Moreover, the loading amount of the inorganic phase was another important factor on the properties of the hybrid membrane, and the comprehensive performance was obtained when the addition amount of TEOS was around 30% based on the polymer content.

此外，杂化膜中无机相的负载量也是一个影响杂化膜结构和性能的重要因素，当正硅酸乙酯的添加量为30%时，杂化膜的综合性能较为理想。

A clean production technology for fluorine and silica white is introduced, with fluorine-containing gas raw material directly absorbed by ammonium fluoride, or ammonia to obtain ammonium fluorosilicate ,and to get ammonium fluoride and silica white by ammonization, further to manufacture other fluoride product with high value.

介绍一种利用磷肥生产中的含氟废气生产氟化合物与白炭黑的清洁生产方法：用氟化铵或氨直接吸收含氟气体生成氟硅酸铵，然后氨化得氟化铵与白炭黑(SiO2)，氟化铵可进一步加工为其它高价值氟化物产品。

The process is carried out by rubbing into filament raw materials, digesting in plasticizing liquid of sodium hydrate and sodium silicate at 100-130degree for 1-2hrs to obtain plasticized raw material, high-speed agitating plasticized raw materials with non-metallic minerals, octadecanoic acid and silicon oil at 100-130degree for 15-45hrs, coating and drying to obtain the final product.

先用农用搓揉机直接搓揉成丝状物料，然后丝状物质在含氢氧化钠和硅酸钠的塑化液中于100～130℃下蒸煮1～2小时，得到塑化物料，最后将塑化物料同改性非金属矿粉、硬脂酸和硅油在100～130℃下高速搅拌15～45分钟进行包覆处理，干燥后便得到目标产物。

A new polysilicate ferric aluminum was prepared by using water glass,ferric sulfate and aluminum sulfate as raw materials.The conditions of preparing PSFA were optimized: the polymerization degree of silicic acid is 0.5; the molar ratio of Fe3+ and Al3+ to SiO2 is 1: 1; the molar ratio of Fe3+ to Al3+ is 1: 1;and the degree of hydrolysis is 0.5;while the influence of the aging time on the coagulation property of PSFA is not obvious.

用水玻璃、硫酸铁和硫酸铝制取聚硅酸铁铝混凝剂，确定了制备PSFA混凝剂的优化条件：硅酸聚合度η为0.5，Fe3+及Al3+与SiO2的摩尔比为1： 1， Fe3+与Al3+的摩尔比为1： 1，水解度B*为0.5，而熟化时间对PSFA混凝剂的混凝性能影响不明显。

Poly silica hybrids were prepared through polymerization, condensation and sol gel processes of the mixture of methyl methacrylate, poly and a small amount of coupling agent methacryloxylpropyl trimethoxy siliane in tetrahydrofuran.

采用溶胶-凝胶技术，以硅酸钠为原料制备聚硅酸/四氢呋喃溶胶，再与甲基丙烯酸甲酯及少许偶联剂甲基丙烯酰氧丙基三甲氧基硅烷(MPTMS 混合，经聚合、缩合和溶胶-凝胶过程制备了有机/无机两相间有— C—Si—O—键的杂化材料——聚甲基丙烯酸甲酯/二氧化硅(PMMA/Si O2 )。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。