硅

The method takes amorphous silica as silicon source and by the steps of soaking, baking, Fe nano particles is implanted, amorphous silica implanted into Fe nano particles and Alpha germanium oxide are mixed and grinded, the obtained mixture is gas-solid treated by organic amine, so as to obtain the silicon germanium oxide composite nano line.

该方法是以无定型氧化硅作为硅源，通过浸泡、焙烧植入铁纳米粒子，再将植入铁纳米粒子的无定型氧化硅和α氧化锗混和研磨，通过有机胺的气-固相处理，最终获得硅锗氧化物复合纳米线。

Products are mainly yellow silicon paper, white silicon paper, kraft silicon, Glassine paper, silicone double-sided paper,¤, all kinds of plastic sheets and so on.

产品主要有黄硅纸、白硅纸、牛皮硅、格拉辛纸，双面硅油纸，淋膜纸，各种胶布等等。

A variety of gram release paper, Glassine paper, kraft paper, double-plastic single silicon paper, double silicon paper, various kinds of imported Release Paper; a variety of PET-off membrane, a single silicon membrane, double-silicon film, the original membrane and white film, black film, membrane switch-specific membrane; all kinds of tape, double-sided tape, Burkina tape, police-style tape, kraft paper tape, textured paper tape, fiber tape; I Division sales PET release film has a different g weight-off edge, and can provide customers from the type of force production.

各种克重离型纸、格拉辛纸、牛皮纸、双塑单硅纸、双硅纸、各种进口离型纸；各种PET离型膜、单硅膜、双硅膜、原膜、白片、黑膜、薄膜开关专用膜；各种胶带、双面胶、布基胶带、警式胶带、牛皮纸胶带、美纹纸胶带、纤维胶带；我司销售的PET离型膜有不同克重的离型力，并可按客户提供的离型力生产。

Results show that the tensile strength and the tear strength could reach 8.71MPa and 52.14kN/m respectively in the presence of 150phr ethylene silicone rubber,1phr hydrogenous silicone oil,2phr polyvinylsilicone oil,4 phr hydroxyl silicone oil and 40phr amorphous silica.

结果表明，在150份乙烯基质量分数为0.13%的硅橡胶中加入1份硅氢基质量分数为1.65%的含氢硅油、2份乙烯基质量分数为8%的多乙烯基硅油和4份羟基硅油，用40份白炭黑增强，可得到拉伸强度为8.71 MPa，撕裂强度为52.14 kN/m的乙烯基硅橡胶。

Distribution of biogenic silica content in surface sediments from deep water areas showed that it could not only reflect the paleoproductivity of siliceous micropaleontology in surface waters, but also indicate the strong or feeble upwelling. Thus, it was further confirmed that using biogenic silica content in sediments to trace upwelling and its change was effective and reliable. The analyzed result showed that radiolaria and poriferous specula have more contribution for biogenic opal, comparing with diatom in surface sediments from the northern studied area, probably owing to the diatom dissolved easily away and eaten by other organisms with little effort.

深水区表层沉积物中生物硅的含量分布表明，其不仅能反映出表层水体中硅质生物的古生产力水平，而且还能指示上升流的强弱，从而进一步证实了利用沉积物中生物硅含量来追踪上升流发育和变化的有效性与可信度研究结果还显示，在研究区域中北部表层沉积生物硅中放射虫和海绵骨针较硅藻占有更大的比重，这可能是由于硅藻易被溶解并易被其他生物体摄食的缘故。

The results show that the porosity of porous silicon increased with the increase of etched time, which lead to the decrease of minority carrier life and the increase of luminescent efficiency of porous silicon.

多孔硅的空隙度随腐蚀时间的延长而增大，这也导致了多孔硅的少子寿命的降低，从而造成多孔硅的光致发光效率随多孔硅空隙度的增大以及少子寿命的降低而提高。

The surface morphology of the porous silicon samples was observed by the field emission scanning electron microscopy and the atom force microscopy and microwave photo-conductance decay technique was first used to measure the minority carrier lifetime of PS.

结果表明，多孔硅的发光来自与氧空位有关的缺陷，而多孔硅表面的氢原子能够钝化多孔硅表面的非辐射中心从而提高多孔硅的发光效率。

The influence of different assembled condition such as assembly method, concentration of zirconium source and pH value on the effectiveness of assembly were evaluated via DSC-TG, FT-IR, Uv-vis and SAXRD et al. It showed that the assembly effectivness of uncalcined 3 Si/Zr_10# sample was best.c The optical characteristic, which including light-conduction in infrared band and polarity in visible band, of dip-coating film and membrane assembled zirconia after processing parameters of assembly optimized were observed via FT-IR and Uv-vis. The polarity was characterized by polarizing angle through calculation from light-transmittance, light-reflectance and fresnel coefficient. qualitative analysis showed that the polarity of Si/Zr_10 # dip-coating film assembled was best.d Adopting zirconium oxychloride as zirconium source, CTAB as template, employing different CTAB adding sequence, two mesoporous zirconia samples were prepared. The template effect of two samples was discussed. It showed that the effect of the sample which CTAB adding sequence was same as mesoporous silica film was better. The light-conduction in infrared band of these samples was also studied, which offered comparison to the polarity of zirconium dioxide assembled within mesopore.

结果显示：组装条件优化后的uncalcined 3 Si/Zr_10#厚膜样组装效果最好，其组装液对应的pH值最利于该锆源离子模板交换组装； c选用FT-IR、Uv-vis对组装条件优化后纳米氧化锆/介孔氧化硅厚膜、纳米氧化锆/介孔氧化硅薄膜包括红外导光性、可见光区内的偏光性在内的光学特性进行了分析，其中偏光性以膜层透光性、反光性及菲涅耳系数计算出的偏振角即布儒斯特角表征，定性分析显示，Si/Zr_10#ZrO_2/介孔氧化硅厚膜偏光性最好； d以氧氯化锆ZrOCl_2·8H_2O为锆源，CTAB为模板剂，采用不同的模板剂加入顺序，探索性地制备两介孔氧化锆样，分析了两介孔氧化锆样的模板效果，得出模板剂加入顺序同介孔氧化硅薄膜时介孔氧化锆样的模板效果较好，并分析了所得样品的导光性，为锆氧粒子引起的附加光学特性分析提供了参考和对比。

The experiments results show that, for Al-20%Si alloy with working temperature about 820癈, the coarse primary silicon turns to be obtuse, and that the average diameter of the primary silicon decreased from 150 m to 40 m, resulting in ideal primary silicon.

研究结果表明：P在820℃左右对含硅量为20％的铝硅合金进行变质处理，粗大的初晶硅棱角钝化，平均直径从150μm下降到40μm左右，获得理想的初晶硅组织。

Effects of different silane coupling agents on high temperature resistance of epoxy modified silicon resin were studied.

研究了不同硅烷偶联剂对环氧改性有机硅树脂耐高温性能的影响，研究结果表明，使用KH560的环氧改性有机硅树脂耐高温性能较使用其它硅烷偶联剂的为好。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。