硅

Methods The optical calculation was taken as the following by using the parameter of Gullstrand model eye:①The refraction of silicone filled eye in non-accommodative status;②The refraction of silicone filled eye in non-accommodative status;③The aniseikonia analysis when one eye filled with the silicone oil;④The IOL power re-calculation.

采用Gullstrand模型眼参数进行以下分析：①非调节状态下正常眼球与硅油填充后眼球的屈光状态；②调节状态下正常眼球与硅油填充后眼球的屈光状态；③无晶状体眼玻璃体腔填充后的屈光状态；④正常眼球与填充硅油后视网膜像放大率变化；⑤硅油填充后的白内障人工晶状体植入术人工晶状体度数的变化。

Silicon oil fit-into anterior chamber: two crystal eyes, intraocular tension has been controlled by releasing silicon oil , silicon oil fit-into one eye again, silicon oil filling exceed one month, useless of expectant treatment, after checking the reattachment of retina, doing the silicon oil dislodge from anterior chamber and vitreous cavity; there aphakia eyes by prone position and draping hypotensive drug: two iris ambitus excision aperture membrane occlusor eyes by lasering at 6 clock or perforating again., iris ambitus excision at 6 clock by lasing .one by iris ambitus excision affiliation anterior chamber plasty, acuity of vision has been elevated different degree after intraocular tension controlled.

硅油进入前房者：有晶体眼中2眼经前房放油眼压控制，其中1眼硅油再次进入前房，硅油填充亦超过1个月，经保守治疗无效，检查眼底视网膜复位后，同时行前房和玻璃体腔硅油取出术；无晶体眼中3眼经俯卧位加点降眼压药物，眼压控制，2眼虹膜周切孔膜闭者经过激光6点位打孔或重复打孔处理眼压控制，1眼作6点位周切孔重建，1眼行虹膜周切联合前房成形术，眼压控制。96眼眼压控制后，视力均有不同程度提高。

This paper analyzes the factors that affect the performance of silicon oil fan clutch and the key configuration.A kind of silicon oil fan clutch has been developed,performance and experimental data of silicon oil fan clutch are summarized through bench testing.The test results show that the optimized clutch can make a response to temperature and has less consumption of power.

硅油风扇离合器不仅可以减少发动机有效功率的损耗，改善发动机的经济性，提高发动机寿命，而且能有效的降低发动机噪声，具有广阔的应用前景[1]。1结构及工作原理硅油风扇离合器是用硅油作介质，利用硅油高粘度的特性来传递转矩，其结构如图1所示，当发动机负荷增加时，水温升高，从散热器吹来的热空气使双金属感温片受热而扭转变形，带动阀销一起转动并通过感温片变形量的大小控制进油阀开度。

According to the law of conservation of sample energy during solidification, under the condition of Newton's cooling, the ordinary mathematical equation of cooling curve was analized, and a theoretical method calculating solid phase fractions and latent heat was put forward on the basis of characteristic α value.

在对碳含量、硅含量和碳当量作三维空间投影分析的基础上，根据实验数据回归出了计算铁水碳含量、硅含量、碳当量、磷含量、抗拉强度、硬度和共晶度的数学模型；为了提高对硅含量的测量精度，提出了分段定硅的技术方法。

Two ferrocenyl and trimethylsilyl substituted cyanohydrin ethers have been prepared by the addition of trimethysilyl cyanide to two acetyl-substituted ferrocenes: 1-(1-cyano-1-trimethylsilyloxyethyl)-ferrocene (1) and 1, 1'-bis(l-cyano-1-trimethylsilyloxyethyl)ferrocene (2). The structures of these two compounds were characterized by elemental analysis, IR, 1H NMR and X-ray crystallography.

通过两种取代的乙酰基二茂铁与三甲基氰硅烷的加成反应，得到两种取代二茂铁基三甲基硅烷基氰醇醚的晶体：1-（1-氰基－1-三甲基硅烷氧基乙烷基）二茂铁(1)，1，1-二（1-氰基－1-三甲基硅烷氧基乙烷基）二茂铁(2)，用X射线单晶衍射、元素分析、红外光谱和核磁共振氢谱对分子结构进行了表征。

When replacing, firstly, demount the shelters at both ends and the collet of silicon carbide rod, then take out the damaged silicon carbide rod, to be careful when install it, for the silicon carbide rod is easy to be broken. The parts of both ends exposed out of the furnace plate shall be equal, and the collet must be firm, make it well contact with the silicon carbide rod.

更换时先卸下两端保护罩与硅碳棒夹头，然后取出已损坏的硅碳棒，由于硅碳棒易断，安装时须小心，两端露炉壳外部分应相等，夹头必须紧固，使之与硅碳棒接触良好。

Now people attach importance to the cleaning of silicon grinded wafer. There are a lot of carborundums and silicon powders on the wafer surface because grinded wafer are grinded by carborundum and corresponding depth are remove in the sequence of grinding. After grinding there are plenty of carborundums and silicon powders enchase in the damaged layers. So there are many difficulties in later processes.

半导体硅单晶衬底加工工业中最受重视是硅磨片的清洗，由于硅磨片是用金刚砂研磨的，研磨过程中又要去除相应的厚度，所以刚加工的磨片表面附着着大量的金刚砂和研磨下来的硅粉，而且还有相当一部分金刚砂和硅粉镶嵌到破损层里面，这给后续的清洗工作带来了困难。

The electroplated ferronickel shutter is suspended by a silicon spring The shutter is fabricated by the nonsilicon surface micromachining techniques. The planar coil is fabricated by high-aspect-ratio photolithography and mask-plating processes. And the silicon spring and the fiber alignment components are fabricated by the reactive ion etching and by the silicon anisotropic etching process.

电镀铁镍制作的挡光片被固定在一个硅弹簧上，该挡光片采用非硅表面微加工工艺制作，平面电感线圈利用高深宽比的光刻工艺和掩蔽电镀工艺制作，硅弹簧和光纤对准元件采用反应离子刻蚀和硅的各向异性腐蚀工艺制作。

Still having a bit is not to become helpless link, this business that I build stands its keyword silicon fireclay and fireproof cement, be in originally Baidu 100 divisions are done not have, and I establish a link in 100 divisions to want to be in, I created 2 vocabulary entry with respect to oneself, one is silicon fireclay one is fireproof cement, website address Www.guihuoni.com stayed in vocabulary entry, silicon fireclay vocabulary entry was passed a long time probably, I examine next links that keep to still be in, bright of a word in the heart, but do not have bright enough a day, go when me that vocabulary entry that when Baidu searchs silicon fireclay, I create still discharges me unexpectedly in front, stand mine to squeeze came down, I am really right it is hated again love again, two words are helpless.

还有一点是不要做无奈的链接，我建的这个企业站其关键词硅火泥和耐火水泥，本来在百度百科是没有的，而我为了想在在百科建个链接，我就自己去创造了二个词条，一条是硅火泥一条是耐火水泥，在词条里留下了网站地址www.guihuoni.com，硅火泥词条大概半天就通过了，我查看下留的链接还在，心里一个字爽，但没爽够一天，当我去百度搜索硅火泥的时候我创造的那词条居然还排我前面，把我的站给挤下来了，我真是对它又恨又爱啊，两个字无奈。

The test to smelt 75% FeSi in 1800kVA electric furnace has been done to replace smelter coke and steel cuttings by coke of medium caking property and high volatile, iron ore concentrate and ganister powder asraw material.

铁硅；冶金焦；还原剂；比电阻；化学成分；硅铁；中等粘结性高挥发分煤和铁精矿、硅石粉做原料炼出的铁硅焦代替冶金焦和钢屑，在1800kVA铁合金电炉上进行了冶炼75硅铁的试验。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。