破损

Tests was carried out on cookies both in single and package unit to measure its velocity change and acceleration in different orientation in different damage rate based on damage boundary theory. The damage boundary curve was obtained.

以苏打饼干单片和单包为研究对象，应用破损边界理论，设计相关实验，测试饼干在不同破损率条件下各个方位的速度变化及加速度，构造出饼干的破损边界曲线。

Thiele type continued fraction interpolation is used to interpolate pixels around damaged part of the regular texture aiming at repairing the texture based on the regular inpainting method. Bisection is used when whole information and details are needed in sampling. Thiele type continued fraction interpolation is not an ideal method in the case of irregular damaged region Newton-Thiele type contined fraction is put forword to solve this problem. Point window is also used in the process of sampling.

在通常的图像修复技术上，对于一些规则的破损纹理图案采用一元Thiele型连分式模型来进行修复，在采样选取上，考虑到图像的整体信息和细节特征采用了二分的方法来进行处理，对于具有不规则破损区域的纹理图案，采用一元的方法不能达到令人满意的效果，采用二元Newton-Thiele型混合有理插值连分式的有理插值的方法来对具有不规则破损部分周围的像素点进行插值并采用采样点窗的方法进行采样可以达到修补破损部分的目的。

The paper combined with the data of pavement distress of Shen-Da Expressway,studied distress regular of asphalt pavement,on this condition,established a long term forecasting model of asphalt pavement adopting grizzle system theory.

结合沈大高速公路青路面破损状况的实测资料，对高等级公路沥青路面破损规律及评价方法进行了研究，在此基础上，运用灰色系统理论方法建立了沥青路面破损状况的长期预报模型。

AlTiN coating has inconspicuous anti-wear effect on carbide.(3) With the introduce of graphite chips bwteen the frictional surface, the effect of graphite chip on the sliding friction and wear behavior of frictional pair was studied. The results show that graphite chips can reduce the coefficient of friction and frictional temperature, and make the coefficient of friction decrease with the decrease of normal load and rise of sliding speed.

在硬质合金微铣刀高速铣削石墨的刀具磨损和破损研究方面，分析了石墨高速铣削过程中的摩擦学条件，揭示了涂层和非涂层硬质合金微铣刀高速铣削石墨的刀具磨损和破损形态及其机理，研究结果表明涂层早期剥落是涂层的早期破损形式，&抛光&磨粒磨损是涂层硬质合金微铣刀在稳定磨损期的主要磨损机理。

In this paper, the connexity is described as the pavement distress subimage model's continuity.

提出利用连通性来描述路面破损子块矩阵中破损子块连续性，并根据通路长度来确定路面破损子块模式值是否为野点。

It is analyzed that the main reasons for negative metacentric height are seepers of cabin in the superstructure. According to the types of curves of statical stability, the righting methods are discussed. It is suggested that the stability should be restored first and then the warship balanced.

分析了上层舱室积水是舰船破损后出现负初稳性的主要原因，根据破损后静稳性曲线的类型探讨了舰船破损后出现负初稳性时应采用先恢复稳性然后平衡舰体的扶正方法。

First, this paper presents three girders model with double cable planes which main girder and side girder is connected by rigid arms, analyzes the dynamic characteristic of Yonghe cable-stayed bridge and obtains its natural vibration modes (i.e., frequency, damping values and the mode shapes ) by ANLSIS structural analysis program and uses these parameters as dynamic dactylogram of the intact case of cable-stayed bridge. Using the passage of random as the ambient vibration ,the dynamic properties of Yonghe Bridge is measured and the modal parameter of its 15 years after is identified and used as dynamic dactylogram of the damaged case. By the finite element analysis and locale vibration test, damaged and undamaged modal parameter is analyzed and curvature mode shape, which is sensitive to damage state, is introduced as possible candidate for identifying and locating damage in the cable-stayed bridge. Selecting the branch of part measured point from modal parameter, this paper deduces the damaged index which can detect the possible damaged location of the cable-stayed bridge deck and identifies the damaged region and degree for Yonghe Bridge. For the purpose of structural condition monitoring in in-situ , from another viewpoint, this paper introduces the method called the best optimization vector to detect damaged location and degree. The accuracy and reliability of the method presented in this paper are demonstrated by static analysis and test and the healthy state of Yonghe Bridge can be evaluated.

建立了双索面通过刚臂与主梁及边梁相连的三梁式力学模型，采用ANSYS结构分析程序对永和斜拉桥进行动力分析，对其振动模态参数进行识别，以此作为斜拉桥完好状态下的动力&指纹&；采用自由交通流作为环境振源，对永和斜拉桥动力特性进行测试，识别出永和斜拉桥使用15年后的模态参数，确立了破损状态下的动力&指纹&；利用有限元分析、现场振动测试，对破损前后的模态参数进行分析，提取对破损状况较敏感的模态曲率作为斜拉桥破损诊断的参数；并从模态参数中选取部分点的分量，导出可以指示斜拉桥桥面大概损伤位置的Index损伤指标，识别出斜拉桥发生破损的区段及破损程度；考虑大型斜拉桥在线监测要求识别破损的具体位置，从另一角度提出采用最优矢量法具体确定破损发生的位置及程度；为验证本文研究成果，对永和斜拉桥进行静力分析及静力测试，对其健康状况提出可靠的评价。

Therefore liquid CO_2 avoids gas-solid multiphase flow, and supplies continuous low temperature gas for cryoprobe. Experimental results show that the 2-dimension temperature distribution for the first time, it includes:(1) The cooling velocity and freezing zone increases along the flux up at certain size of the cryoprobe in the same biological tissue.(2) As the diameter of cryoprobe increases, the temperature will descend faster, freezing zone will be broader obviously, and ice ball become larger. Until it arrives heat balance, the temperature keeps invariability.(3) Single freezing-thaw results in biggish mechanical injury already for loosen tissue such as pork liver; Successive freeze-thaw circle could quicken freezing and thaw velocity for compact tissue, and it has proved the more mechanical injury of successive freeze-thaw circle than the single freezing-thaw treatment.

文中首次对生物组织进行了二维温度场分布实验研究，得出：(1)当刀头大小一定，对同一组织冷冻时，流量越大，降温速度越快，降温影响区域越大；(2)随着冷刀直径的增加，降温速度随着增加；温度影响区域明显增大；冰球直径也随着增大，热量平衡后温度几乎不随时间变化；(3)对于结构疏松组织比如猪肺脏，单次冻融对组织已造成较大的机械破损；对于结构较致密组织，多次反复冻融可以使降温和复温速率增加，单次冻融的热应力造成的机械破损较小，多次冻融后造成的机械破损比单次冻融所造成的机械破损大；(4)直喷式刀头比导热式节能约15％。

For the DC leakage current could not effectively evaluate the state of DC feeder cable insulation layer with cut or crack, the discharge theory and its characteristic were studied in the DC feeder cable under special condition, and the DC discharge was proposed to detect the insulation cut or crack fault in DC feeder cable.

针对泄漏电流检测直流馈出电缆绝缘破损故障效果不佳的问题，研究了直流馈出电缆破损状态下的放电机理及特征，提出采用直流放电法检测直流馈出电缆破损故障。

The results showed that the damaged starch contents of hard wheat were 20% higher than that of soft wheat under the same processing condition, and the damaged starch contents would be increased ...

研究结果表明：硬麦加工后淀粉破损率高，而软麦则相对较低，硬麦粉的淀粉破损率较软麦粉高出 2 0 %左右；面粉越细则淀粉破损率越高；研磨道数越多，研磨强度越大，淀粉破损越严重；齿辊所造成的淀粉破损程度要比光辊为重，但差距不是很大；撞击机在正常生产时对淀粉破损影响较小，如反复撞击也会使破损淀粉增加，但其影响程度较研磨强度缓和。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。