研究试验

First, the orthogonal test is conducted, and the results show that slurry concentration and momentum driftage of oxidic atmosphere has a great influence on both grain size and concentration distributions; agitated manner has little influence on either grain size and concentration distributions; agitated power has little influence on concentration distribution, but has a great influence on grain size distribution.

首先用正交试验组织了试验研究，并采用直观分析法和方差分析法对正交试验结果进行了分析，发现浆液浓度对沿浆池高度气液固三相的浓度分布不均匀性有特别显著性影响，对颗粒粒度分布不均匀性有显著性影响；浆池内氧化气体的动量流率对沿浆池高度气液固三相的浓度分布不均匀性和颗粒粒度分布不均匀性有特别显著性影响；搅拌方式对沿浆池高度气液固三相的浓度分布不均匀性和颗粒粒度分布不均匀性影响不大；搅拌功率对沿浆池高度气液固三相的浓度分布不均匀性影响不大，而对颗粒粒度分布不均匀性有显著影响。

When it is crashed to -3 mm and is mixed uniformly it will become the sample for multi-elements analysis raw ore screening and elutriation raw ore mineralogy research and gravity concentration test.

试验矿样取自选矿生产现场，经破碎至-3毫米，均匀混样后作为本次试验的多元素分析样品、原矿筛分及水析样品、原矿矿物学研究样品和重选试验样品。

In this paper, the author describes a new dynamic termination method based on sequential life testing and failure termination.

为解决这一问题，提出了寿命试验的动态截尾方法，利用该方法研究寿命服从指数型分布产品的可靠性试验，提出了试验动态截尾的数据处理模型及判据。

The modal tests of PCB and PCB assembly (free boundary condition and fixed boundary condition) were carried out. The equivalent elastic modulus and damping parameters of PCB can be gained, and the fixed boundary condition of finite element model was also determined. These will help to the following work.Second, drop impact tests of three different heights were carried out. Strains and acceleration responses of PCB were measured. Failed BGA packages of different test conditions were dyeing, and cross section analysis of failed solder joints was conducted.

针对JEDEC标准试件的局限性，提出了设计便于统计学研究焊点可靠性的试验试件的构想，利用有限元模态分析方法确定并验证了用圆形PCB组件替代JEDEC标准试件的可行性；通过一系列模态试验和有限元模态分析，确定了圆形PCB组件的相关试验参数，这不仅为跌落碰撞下PCB组件有限元模拟确定了较为合理准确的有限元模型，而且为正确地评价跌落碰撞下PCB组件的可靠性问题奠定了基础。2。

The modal tests of PCB and PCB assembly (free boundary condition and fixed boundary condition) were carried out. The equivalent elastic modulus and damping parameters of PCB can be gained, and the fixed boundary condition of finite element model was also determined. These will help to the following work. Second, drop impact tests of three different heights were carried out. Strains and acceleration responses of PCB were measured. Failed BGA packages of different test conditions were dyeing, and cross section analysis of failed solder joints was conducted. It was found in our drop tests that the root cause of lead-free solder joints under drop impact was the combined effect of mechanical shock and PCB bending vibration.

针对JEDEC标准试件的局限性，提出了设计便于统计学研究焊点可靠性的试验试件的构想，利用有限元模态分析方法确定并验证了用圆形PCB组件替代JEDEC标准试件的可行性；通过一系列模态试验和有限元模态分析，确定了圆形PCB组件的相关试验参数，这不仅为跌落碰撞下PCB组件有限元模拟确定了较为合理准确的有限元模型，而且为正确地评价跌落碰撞下PCB组件的可靠性问题奠定了基础。

The ignition and its flame spreading test system of the modular charges in the natural environment is built up, a number of ignition and its propagation methods are simulated, the characteristic parameters of the system in the natural environment are obtained.

本文针对刚性组合装药的点传火技术进行了一些基础性试验研究和理论分析，建立了自然环境下刚性组合装药的点传火试验系统，并对多种点传火方案进行了模拟试验，获得了点传火系统在自然环境下的重要性能参数。

The tests have Simulated the rainstorm state and the order state, and the results indicated the disposal of microorganisms-aquatic plant system is efficient. The optimization removal rate time was ascertained under the static state test, in dynamic test, comparing and analyzing the effect on removal rates of different concentration wastewater. The results showed, without aeration, the removal rate of CODCr, TN was 85.9%,75.1%, respectively, the highest removal rate of TP was 64.6%, and the concentration of DO increased steadily from 2mg/L to 7mg/L during experiment. In dynamic test, the microorganisms-aquatic plant systems have also appeared better effect on freshet, and the removal rate of TN,TP and CODCr, was 64%,69% and 81%, respectively.

利用接种高效微生物菌剂促进填料快速挂膜，并和水生植物联合作用去除水体中的氮磷等污染物，在静态水体下研究达到最佳去除效率的时间，并在连续流试验下对比分析不同浓度下的去除效率，根据静态模拟试验结果表明，在不曝气，自然复氧条件下，CODCr和TN的最终去除率分别为84.3%和71.4%，TP最高去除率为62.9%，DO也从2mg/L稳定的升高到7mg/L左右；在连续流模拟试验结果表明，该系统对雨后入湖的河水中TN、TP及CODcr的去除率分别稳定在近64%，69%和81％以上。

For the minimum dry density test of sand, test devices are improved to simplify the procedures and the test steps are adjusted to reduce the measurement error. The reverse graduated cylinder method and the tilting graduated cylinder method are recommended as the best methods for minimum dry density test and for leveling sand surface respectively. The optimum sampling quantity and the times of reversing graduated cylinder are studied.

对最小干密度试验，改进了试验装置以简化操作手续；调整了试验步骤以减小测量误差；推荐只使用量筒倒转法测量，用量筒倾斜法整平砂面；研究了最佳取样量和量筒倒转次数。

Choosing hairtail as the object, taking processing pressure、 time of holding the pressure and time of pre-processing as the factors, orthogonal experiment with three factors and three levels is conducted.

选取带鱼为试验对象，以加工压力、保压时间、预处理时间为试验因素，进行三因素三水平正交试验研究。

The detailed means is proposed to apply the Water Saving Irrigation in the dry west area, based on the feasibility study of representative hungriness section. It is also a theoretical reference for all the droughty or semiarid area of north-west.

本研究在试验区内进行了滴灌、喷灌和防渗渠畦灌棉花试验，滴灌分为三种不同的节水灌溉方式处理，喷灌采用覆膜与不覆膜两种处理，防渗渠畦灌试验为对照实验。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。