研究与开发处

The main results of the investigation are as following:(1) Some important criteria for the design of multi-layer structure are acquired: the ratio of the layer thickness to the contact diameter should be controlled to a value about 0.8; increasing the number of the gradient layers and elasticity modulus of the top layer would benefit to the yield strength and the stress status at the interface.（2）By means of molecular dynamics simulations for a indentation and sliding process, it is discovered that dislocations of 45 direction to the surface occur in the surfaces layer, which is correspond to the direction of the plastic flows observed in the macroscopic continuous medium. The irreversible deformation caused by the dislocation and the atom piles at the surface are responsible for the irreversibility of the force response. They are also the main factors for the friction generation. The temperature and the indentation velocity have significant effects on the deformation behaviors of the material of the surface layer. The yield strength would increase obviously if the indentation velocity is greater than 10 m/s.（3）A method to evaluate the fracture toughness of coating by estimating the crack-density functionβof a Wicker''s indentation was proposed. Meanwhile a new surface treatment technology was developed using non-equilibrium plasma.（4）A MD-FE hybrid method and corresponding software was developed to analysis the tribological behaviors for multiplayer system.

研究主要内容和结果有：（1）得到指导梯度膜设计的几个准则：控制膜层厚度与接触半径比在0.8左右为宜；适当增加梯度层层数和顶层弹性模量，有利于提高抗屈服能力和改善界面处的应力状态；（2）通过对嵌入和滑动摩擦过程的分子动力学模拟，发现表层产生一个与宏观连续介质的塑性流动方向观测一致的45 方向位错；位错造成的不可逆变形和表面的原子堆积，是力的响应不可逆性的原因，也是构成摩擦力的主要因素；温度和嵌入速度对材料变形特性有显著的影响，当嵌入速度大于10 m/s时，屈服强度明显增加；（3）提出压痕裂纹密度系数β半定量判定膜层断裂韧性的方法；并开发出表面强化新工艺；（4）开发出分析表面摩擦学特性的MD-FE复合模拟方法和相应模拟软件。

The results indicate that the different thermal expansions and elastoplastic properties and distributed randomness of various mineral particles composed of oil shale will lead to the nonuniformity of thermal field , deformation field and stress field in heating process , which makes the particles of oil shale deform incompatibly : and the release of product pyrolysis results in irreversible damages of oil shale material and structure . These are the main reasons for the thermal fracture of oil shale .

研究结果表明：组成油页岩各种矿物颗粒热膨胀和弹塑性性质的不同及其分布的随机性，导致油页岩加热过程中温度场，变形场和应力场的非均匀性，使得油页岩颗粒间变形不协调和油页岩热解产物释放引起油页岩材料与结构性能发生不可逆的劣化损伤，这是油页岩发生热破裂的主要原因；热传导方式加热油页岩，温度的传递比较缓慢，加热井和生产井的间距不宜过大，对油页岩储层性质存在差异时，注热井应选择较高热导率的区段；油页岩的层理对油页岩地下原位开发形成渗透带至关重要，油页岩达到热解温度会产生附加的膨胀力，首先在层理处开裂，应充分利用油页岩层理赋存条件改造其渗透性。

The results indicate that the different thermal expansions and elastoplastic properties and distributed randomness of various mineral particles composed of oil shale will lead to the nonuniformity of thermal field, deformation field and stress field in heating process, which makes the particles of oil shale deform incompatibly: and the release of product pyrolysis results in irreversible damages of oil shale material and structure. These are the main reasons for the thermal fracture of oil shale. When oil shale is heated through thermal conduction, temperature transfers slowly, so the spacing between heating well and production well should not be kept too long. When difference exists in oil shale reservoir's properties, heating well should be chosen in the high conductivity region. Oil shale's stratification is vital for developing permeation zone in in-situ retorting. Oil shale will generate additional expansion force as it reaches its pyrolysis temperature, and stratification will be cracked first, so the oil shale stratification should be utilized to enhance its permeability.

研究结果表明：组成油页岩各种矿物颗粒热膨胀和弹塑性性质的不同及其分布的随机性，导致油页岩加热过程中温度场、变形场和应力场的非均匀性，使得油页岩颗粒间变形不协调和油页岩热解产物释放引起油页岩材料与结构性能发生不可逆的劣化损伤，这是油页岩发生热破裂的主要原因；热传导方式加热油页岩，温度的传递比较缓慢，加热井和生产井的间距不宜过大，对油页岩储层性质存在差异时，注热井应选择较高热导率的区段；油页岩的层理对油页岩地下原位开发形成渗透带至关重要，油页岩达到热解温度会产生附加的膨胀力，首先在层理处开裂，应充分利用油页岩层理赋存条件改造其渗透性。

It is necessary that manufacturer and supplier build strategetic cooperation relationship. Secondly, the thesis analyzes this strategetic cooperation partner relationship and expounds merits and demerits of building this relationship. The thesis emphasizes the choice

本文重点是系统探讨战略性供应商的评价和选择问题，在全面分析、借鉴供应商评价的有关理论和方法成果的基础上，以A公司为对象进行实证研究，设计开发了战略性供应商的选择与评价模型，并指出A公司供应商评价与选择的不足之处，提出改善建议。

Professor Banerjee's previous areas of research and consulting have included comparative urbanism and urbanization, user perceptions of residential environments, spatial environment of adolescence, urban scale vulnerability of seismic damages, privatization of public life and space, transit corridor design and developments, and regional growth visioning processes.

班纳杰教授曾从事的研究与咨询涉及城市比较与城市化、宜居环境的用户认知、青少年所处空间环境、地震灾害中城市的弱点、公共生活及空间私有化、交通走廊设计与开发、区域增长前景。

Finally, the paper reviewed the entire research situation based on the change of Voip network telephone terminal technical and the realization of system function module research, summarized the system's insufficient payment, and proposed the question that the system should be further improved.

最后，论文回顾了整个基于VoIP网络电话终端语音算法研究与改进及系统部分功能模块开发过程，总结了系统的不足之处，并且提出了系统有待进一步改进和完善的问题。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了