石墨的

The equipment has crept forward in its technology since Robin and his merry men had the run of Sherwood Forest, but the sport of archery remains essentially unchanged, A recurve bow coated in fiberglass has become standard, and arrows made of aluminium and carbon graphite can travel more than 240km/h, but the most important repuirements are straight forward: steady hands, strong shoulders, flexible muscles, sharp eyes and nerves of steel.

与罗宾汉和他的手下在舍伍德森林中占山为王的时代相比，射箭运动的器材装备在技术上已经逐渐进步不少，但是这项运动在本质上并没有改变。覆盖着玻璃纤维，向内凹进的弓已经成为了标准用具，用铝和石墨制成的箭时速可高达240公里。然而，最关键的要求还是那么简单：稳健的双手、强有力的肩膀、柔韧的肌肉、犀利的眼睛和钢铁一般的神经。

The structure shown in the figure : The governing body received direct or roller drying cylinder, as the main components of the rotation; After finishing the outside of the sphere, Bottom Cover and soak spherical carbon graphite seal ring joint seal reliable seal friction deputy, Sealing ring in the spherical shell of its annular space sliding, in addition to oil-free bearings and with the close cooperation of Shell, Rotating connector so that the free support, and therefore do not require a high level of accuracy installed; Spherical seal ring wear, Spring means of pressure at any time in advance to receive compensation, compensation for the shell slowly moved backward, accessible through the tube outside the inscription on the line to observe the seals wear; When steam, Oil flows through the media or other spherical sealing ring and oil-free bearings, the formation of thin liquid film, sealing and lubrication, thereby reducing friction and wear, extending the service life.

其结构如图所示：外管体直接接到辊子或烘筒上，为主要的旋转部件；经过精加工的外管本球面、底盖和浸泡碳石墨球面密封环共同组成密封可靠的动密封磨擦副，球面密封环在其壳体内的环形空间中滑动，加之无油轴承与壳体的密切配合，使旋转接头自由支撑，故对装机精度要求不高；球面密封环磨损后，借助于弹簧的预压力随时得到补偿，补偿时壳体缓缓向后移动，并可通过外管体上的刻线观察到密封件的磨损程度；当蒸汽、油或其它介质流经球面密封环和无油轴承时，形成一层很薄的液膜，提供密封和润滑，从而减轻了摩擦和磨损，延长了使用寿命。

The exchange of the electrovalence of the cupric ion has been testified by XPS-ESCA.Graphite and chloride in the stage structure,seem to be the conductor and insulator,which form the "sandwich" structure.This special structure produced a weak chemical bond belt and provided the carrier space in the perpendicular direction to the c-axis.These factors in and vertical to the direction of c-axis together increased the electrical properties.

GICs将良导体的石墨层与绝缘体的氯化物层在分子尺度上结合起来，所形成的阶结构相当于许多导体和绝缘体层组成的&三明治&结构，产生化学键薄弱的通道，提供了垂直c轴方向的载流子通道，隧道效应和格架空间提供了载流子活动空间，这些因素共同作用使得GICs的电导率成倍增加

By the OM and SEM observation of solidification microstructure, the interfacial reaction between TiAl alloy and Al2O3 crucible was serious, and a large number of α-Al2O3 inclusion formed in the solidification microstructure. The interfacial reaction between TiAl alloy and ZrO2 crucible occurred only on the sample surface, but the crucible was not stable at high temperature and a tack coating was formed, clinging tightly with TiAl alloy. C element in the graphite crucible changed the original solidification path of TiAl alloy, and club-shaped γ-TiAl phases formed.

通过用光学显微镜和扫描电镜对凝固组织观察发现，TiAl合金与氧化铝坩埚之间的界面反应较为严重，在凝固组织中形成了大量氧化铝夹杂；TiAl合金与氧化锆坩埚的界面反应仅发生在试样表面，但该坩埚在高温下不稳定，并在试棒表面形成一层无法剥离的粘结层；石墨坩埚中的C元素改变了原有TiAl合金的凝固路径，生成了棒状的γ-TiAl相。

For the second part, the damping behavior of Mg matrix composite was studied. It is found that the graphite fiber achieves better damping capacity than other reinforcements. The phase transformation happened in the Mg matrix can improve damping capacity and with the increase of reinforcement damping capacity can also be improved at high temperature.

其次，对镁基复合材料的阻尼行为的研究，发现石墨纤维比其它增强物具有更好的阻尼效果，基体镁合金的相变过程能提高复合材料的阻尼性能，增加增强物含量能增加复合材料的阻尼且高温下的效果更好。

For this process,the free-standing diamond thick films were dipped in a saturated iron chloride solution and dried in atmospheric ambient.

其工艺为：自支撑的金刚石厚膜浸入饱和的三氯化铁水溶液中，然后平放在大气环境中干燥，将处理过后的金刚石膜放入MPCVD装置中，先用氢等离子体将氯化铁还原成铁，然后在800℃左右的温度下，利用铁对金刚石的催石墨化作用及氢等离子体的刻蚀作用将其表面刻蚀。

If nitrogen is present as single atoms, it would hint that the diamonds were produced rapidly and at relatively low temperature - as might happen if the diamonds formed from pockets of graphite in the zircons in a single, rapid event. That would make the diamonds young.

如果氮元素被证实是以单个原子的形式存在，这意味着钻石是在相对低温的环境下快速形成的——对那些由锆石中的石墨矿囊转变成形的钻石来说，如果单一而快速的条件具备，这种情况就很可能会发生，并将证明这些钻石的年代并不久远。

In this paper, a turbostratic CN precursor was prepared by means of pyrolysis of melamine, then it was treated by high temperature and high pressure. The pyrolysis process of melamine, mechanism of hydrogen elimination and the effect of catalysts on pyrolysis of melamine were studied. The crystal structures, bonding states and chemical compositions of CN precursor obtained by pyrolyzing melamine are analyzed by X ray diffraction, burning spectrum, scanning elecron microscope and Fourier transform infrared Spectroscopy.

本文采用三聚氰胺热解法制备了乱层石墨结构的碳氮前驱物并进行了探索性的高温高压实验；研究了三聚氰胺热解的工艺、去氢机理以及催化剂对三聚氰胺热解过程的影响规律；借助 X 射线衍射、燃烧谱、透射电镜和红外光谱等手段，对获得的碳氮前驱物进行了成分、晶体结构、价键结构的分析。

Because of the disadvantages in the electrolysis of rare earth metals, a new kind of electrode material called non-carbon anode is studied, and the corrosion mechanism is reseached.

针对稀土金属Nd的氟化物体系熔盐电解中石墨阳极所存在的一系列不足，研制了一种新型的电极材料，称其为非碳阳极；并对其在电解过程中的腐蚀机理进行了较详细的探讨，提出了还原反应、氧化反应、电解质渗透、电极组分溶解、析氧膨胀等几种可能的腐蚀原因。

The development of the lead free cutting brass containing bismuth and graphite/copper composite was summarized.It can be concluded that the key points for cutting brass containing no lead are the choices of elements which can form brittle but not hard intermetallics and procedure which can make the intermetallics distr...

详细介绍国外无铅易切削铋黄铜研究开发的一些成果和石墨/铜合金复合材料的研究情况，总结国内无铅易切削铜合金的研究情况，结合自己的研究结果，指出无铅易切削铜合金的研究方向是采用适当的元素形成脆而不硬的金属间化合物，并采用一定的加工手段使其呈弥散分布。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。