石墨的

The results show that properties of the copper-coated graphite/silver matrix composites have lower resistivity and coefficent of friction, higher hardness, bending strength and wear resistance.

结果表明，镀铜石墨－银基复合材料具有低的电阻率和摩擦因数，以及高的硬度、抗弯强度和耐磨性。

This paper deals with the preparation of synthetic diamond single crystal with boron at high temperature and high pressure from Fe-Ni-C-B system.

1前言石墨转变为金刚石是碳的同素异构体转变，由于触媒的参与使之合成压力与温度大幅度降低。

Specially designed seals are used for all kinds of rotating equipment such as centrifugal compressors, autoclaves, filters, centrifuges, and mixers. In the same time, products like cyclone separators, coolers, entire sealing systems, packing, gaskets, magnetic couplings and so on are also produced.

并为所有旋转机械设备提供特殊设计的密封，如：离心式压缩机、高压釜、滤清器、离心机和搅拌器等，同时还生产用于密封系统的过滤器、分离器、冷却器以及填料、柔性石墨等静密封材料、伸缩节、磁力驱动联轴器等。

Specially designed seals are used in all kinds of rotating equipments, such as centrifugal compressors, autoclaves, filters, centrifuges and mixers. In addition, products like cyclone separators, coolers, entire sealing systems, packing, gaskets, magnetic couplings are also produced.

并为所有旋转机械设备提供特殊设计的密封，如：离心式压缩机、高压釜、滤清器、离心机和搅拌器等，同时还生产用于密封系统的过滤器、分离器、冷却器以及填料、柔性石墨等静密封材料、伸缩节、磁力驱动联轴器等。

And now,it has three branchers: graphite lead plant,color lead plant,and pencil plant.

企业简介济南明泉笔业有限公司是专业制作铅笔芯及铅笔的生产型民营企业，自1989年建厂以来，全体员工本着&以质量求生存，以创新求发展&的企业宗旨，齐心协力，精益求精，不断地发展壮大；现已拥有三个分厂：石墨铅芯厂、彩色铅芯厂、铅笔厂。

Jinan Mingquan Writing Instrument Co.,Ltd is a professional corporation in producing pencils lead and pencils since it was built in 1989.Sticking to the principle of "existing by quality,developing by innovation",we are making concerted effort,so that the scope of the enterprise is becoming more broader.And now,it has three branchers: graphite lead plant,color lead plant,and pencil plant.

济南明泉笔业有限公司是专业制作铅笔芯及铅笔的生产型民营企业，自1989年建厂以来，全体员工本着&以质量求生存，以创新求发展&的企业宗旨，齐心协力，精益求精，不断地发展壮大；现已拥有三个分厂：石墨铅芯厂、彩色铅芯厂、铅笔厂。

It can make carburized layer on titanium alloys by electrospark deposition, and the carburized depth is about 40～50 μm.

用电火花渗碳技术可在钛合金表面形成一层40～50μm厚的渗碳层，分析显示渗碳层中主要是由石墨电极与基体反应生成的TiC相组成。

Fujikura Co. to develop a specific Shaft with high elasticity graphite fiber of 40t rolled in the total

司共同开发的NV-F专用杆身-MOTORE，以40t的高韧性石墨纤维绕织而成，令杆身

The carbonized fiber yarn is treated with graphite particles ,and then is braided to form packing Its surface is coated with an high temperature-proof lubricant

GB-203 碳素纤维盘根：它是用碳素纤维线经石墨粒子处理过，再编织而成的盘根。表面再以耐高温的润滑剂处理之。

In this work, we use AFM and ElectroChemical Scanning Tunnelling Microscopy to study the mature fibrils on Highly Oriented Pyrolytic Graphite .

用AFM和ECSTM研究了在高定向热解理石墨表面上成熟的纤维的结构形态。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。