石墨

Several amorphic carbon film s with different thickness were deposited on single crystal silicon by means of pulse laser ablating graphet target at room temprature.

在室温下，用激光烧蚀石墨靶方法在单晶硅衬底表面沉积了不同厚度的非晶碳膜。

The polycrystalline or amorphic diamond thin films may have three ways of field emission:"antenna effect", the emission site of quasi-n-type and low work function, the field emission of graphite particles.

多晶或非晶金刚石薄膜可能存在三种场发射方式：&天线效应&，准n型低功函数发射点和石墨微粒场发射。

It is shown that the samples produced in (H2+ Ar) contains α,while the samples produced in CH4 contains α, Fe3C, Cr3C2, graphite, amorphic cabon, and no oxide appears.

发现（H2+Ar）气氛下制备的不锈钢纳米粒子主要为α；甲烷气氛下制备的粒子由α、Fe3C、Cr3C2、石墨及无定形碳等组成，未发现氧化物。

In this research,a novel anticoagulative biomaterial which was prepared from modified graphite oxide and silicone rubber through solution intercalated reaction was synthesized.

利用溶液插层法合成了新型的硅橡胶/氧化石墨-十六烷基三甲基溴化铵-肝素抗凝血纳米复合材料。

A novel anticoagulative biomaterial which was prepared from modified graphite oxide and silicone rubber through solution intercalated reaction was synthesized, The excellent properties of the new type nanocomposites, such as good mechanical strength and b

摘要利用溶液插层法合成了新型的硅橡胶／氧化石墨－十八烷基二甲基－2-羟乙基溴化铵－肝素纳米抗凝血复合膜材料，并通过机械性能测试、X射线衍射、血小板黏附试验和肝素扩散速率测定实验对复合膜材料的力学性能和血液相容性进行了表征。

A novel anticoagulative biomaterial which was prepared from modified graphite oxide and silicone rubber through solution intercalated reaction was synthesized, The excellent properties of the new type nanocomposites, such as good mechanical strength and blood compatibility, have been characterized by XRD, mechanical properties, adhesion of blood platelet test and the heparin release rate test.

摘要利用溶液插层法合成了新型的硅橡胶／氧化石墨－十八烷基二甲基－2-羟乙基溴化铵－肝素纳米抗凝血复合膜材料，并通过机械性能测试、X射线衍射、血小板黏附试验和肝素扩散速率测定实验对复合膜材料的力学性能和血液相容性进行了表征。

Kinetic equation in the baking process of purifying aphanitic graphite were researched.

研究了隐晶质石墨的提纯工艺中焙烧动力学方程。

Kinetic equation in the baking process of purifying aphanitic graphite were researched.

讨论了玄武岩纤维的性能以及我国玄武岩纤维生产技术存在的一些主要问题。4。研究了隐晶质石墨的提纯工艺中焙烧动力学方程。

The ultrafine aphanitic graphite particles with uniform size distribution was fabricated by stirred mill with simple process and high efficiency.

用搅拌磨制备了-lμm、粒度分布均匀的隐晶质石墨超细粉体，工艺简单、效率高。

The experimental results are shown that the microstructure of QT600-3 by CO_2 laser quenching is Aphanitic Martensite+Graphite,and residual stresses are all compressive,which is above 120 MPa,they increase with laser power.

结果表明：经CO_2激光淬火后QT600-3的显微组织为隐晶马氏体+石墨，残余应力均为压应力，其值在120 MPa以上，且随着功率的增大而增加；相变层深度随着扫描速率和光斑直径的增加而减小，且随着功率的增大而增加；激光淬火后的材料组织结构比较均匀，有利于提高凸轮轴的使用寿命。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。