石墨

A new method using microwave digestion technique was developed for the determination of cadmium, chromium and lead in Lycoris radiata by graphite furnace atomic absorption spectrometry.

采用微波消解技术处理样品，用石墨炉原子吸收光谱法测定，对消解试剂和微波消解条件进行了筛选和优化，研究了石墨炉原子吸收的测定条件。

Finally, the article discussed the possible mechanism of multi-phase electrochemical degradation of wastewater through the XPS spectrum of the used catalysts surface: In the acid solutions, the electro-generated O_2 may get electrons on the porous graphite cathode and then form H_2O_2, H_2O_2 may diffused to the surface of catalyst and reacted with its active part to produce OH, which in turn can destruct organics. The catalyst functioned as both the catalyst to decompose H_2O_2 and the flocculants to sedimentate the degraded waste.

最后全文结合研究反应后催化剂表面的XPS光电子能谱推断了该体系降解污废水可能的反应机理：在酸性条件下，石墨双阳极产生的O_2被多孔扩散性石墨阴极还原成H_2O_2，并通过扩散传质作用在催化剂的表面活性中心分解为强氧化性中间产物·OH，强氧化性攻击有机物，使其降解为小分子有机物或CO_2和H_2O，催化剂在体系中即起催化作用也起吸附、絮凝作用。

The surface of natural scale graphite was modified by wet chemical method using sulfanilic acid and sodium nitrite as raw materials,which could remarkably elevate the hydrophilicity of natural scale graphite.

以对氨基苯磺酸、亚硝酸钠为原料，对天然石墨鳞片表面进行了接枝改性处理，显著提高了天然石墨鳞片的亲水性。

Provided are carbide derived carbon materials prepared by thermochemically reacting carbide compounds and a halogen containing gas and extracting all atoms of the carbide compounds except carbon atoms, wherein the intensity ratios of the graphite G band at 1590 cm -1 to the disordered-induced D band at 1350 cm-1 are in the range of 0.3 through 5 when the carbide derived carbon is analyzed using Raman peak analysis, wherein the BET surface area of the carbide derived carbon is 1000 m 2 /g or more, wherein a weak peak or wide single peak of the graphite (002) surface is seen at 2 = 25 DEG when the carbide derived carbon is analyzed using X-ray diffractometry, and wherein the electron diffraction pattern of the carbide derived carbon is the halo pattern typical of amorphous carbon when the carbide derived carbon is analyzed using electron microscopy.

提供了得自碳化物的碳，其通过热化学反应碳化物化合物和含卤族元素的气体并提取除了碳原子之外的碳化物化合物的全部原子制备，其中当使用拉曼峰分析法分析该得自碳化物的碳时，在1590cm -1 的石墨G波段与在1350cm -1 的无序引发的D波段的强度比为0.3至5，其中该得自碳化物的碳的BET表面积是1000m 2 /g或更大，其中当使用X射线衍射法分析该得自碳化物的碳时，在2θ＝25°观察到石墨(002)面的弱峰或宽单峰，以及其中当使用电子显微法分析该得自碳化物的碳时，得自碳化物的碳的电子衍射图是代表无定形碳的晕图案。该发射体具有良好的均匀性和长寿命。可以使用比用于生产常规碳纳米管的方法更廉价的方法制备发射体。

The carbons in explosives are decomposed into gas-like carbon atoms in the detonation reaction zone, then unoxidized carbon atoms coagulate into carbon liquid droplets and finally consolidate into solid diamonds The new mechanism differs from one conclusion that carbons of explosives are at first transformed into solid graphites, then into diamonds, and also differs from the conclusion that gaseous carbons coagulate into liquid droplets in the reaction zone, then crystalize into diamonds in Taylor rarefaction wave zone.

修正了有关炸药中的碳在反应区内先转变为石墨，然后石墨再发生相变生成金刚石的论点以及认为在反应区内气态碳凝聚为碳液滴，液滴在Taylor稀疏波区凝固成金刚石的论点。

SiC nanowires grew at the surface of liquid ball and formed villiform nano wire-balls. During the cooling stage in some cases, the SiO reacted with the CO in the furnace to form SiO_2 which then deposited on the surface of SiC nanowires, forming the SiC/SiO_2 nanocable with SiC as the core and SiO_2 as the wrapping layer.

由于Ni-Si化合物跟石墨的浸润性较差，在仅比化合物熔点高出小于200℃的温度区域内，Ni-Si化合物熔体不能在石墨板上熔敷而是形成合金熔球，最后在熔球表面上生长出SiC纳米线形成形状独特的SiC纳米线绒球。

It was described in this paper the effect of vinylene carbonate as additive on rechargeable lithium cell with carbon anode.

本文仅对碳阳极的锂离子二次电池添加剂做探讨。1添加剂的引入及作用锂离子在电解液中和溶剂分子形成溶剂化物，这些分子和锂离子一起插入石墨层，并在石墨层中发生电化学分解引起它的脱落。

With the material of synthetic graphite and natural graphite, the product has high absorption rate and speed after high temperature graphtized treatment. It can be used to add carbon to melted steel or iron whilie smelting.

本产品采用人工或天然石墨，经高温石墨化处理而成，具有吸收率高、吸收速度快的特点，适用于钢、铁冶炼时，钢水的电炉内增碳。

Based on above work, theGET—500 integral graphite electrodes abrading tool is designed.

在上述工作的基础上，设计了&GET—500整体石墨电极研磨机&，并对其制造装配精度、工作控制及动态特性进行了系统的理论分析和实验研究，成功地研制了我国第一台石墨电极研磨机。

An unconventional form lapping based on rapid prototyping technology has been studied to solve this problem and a graphite electrode abrading machine is successfully developed.

为了解决复杂型面石墨电极的加工问题，一种基于快速成形技术的非传统的成形研磨方法已被研究开发，并在此基础上成功研制了石墨电极研磨成形机。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。