短路的

Simulation results prove that so long as both busbar stray capacitance and sampling frequency satisfy a certain condition, the proposed scheme can judge the fault accurately under various fault conditions. The proposed scheme possesses good selectivity and strong ability of anti-transition resistance, besides, it is more sensitive to the fault occurred at the end of transmission line.

仿真试验表明，只要母线杂散电容和采样频率满足一定的条件，该方法在各种故障条件下均能准确判断故障，具有很好的选择性，并且有很强的抗过渡电阻能力，对末端短路故障的反应灵敏度更高。

Because of the features of current of breaker: the range is wide , the signal of short circuit containing the direct circuit that is attenuation signal, when CT is saturation, the signal of current is aberrational, improved Fourier algorithm and maximum slope algorithm are chosen to calculate the current on the base of theoretic analysis.

根据断路器开断电流信号变化范围宽、短路电流信号含有直流衰减分量、当电流互感器深度饱和时，电流信号发生畸变的特点，在理论推导和分析的基础上，综合采用了并联补偿傅氏算法和最大斜率算法作为监测单元中不同范围内的电流信号的处理算法。

The results can be expressed as follows:(1) With the increase of water phase content, the amine salt aggregated orderly in different forms such as W/O micro-emulsion, nodus-knot catenulate aggregates, layer liquid crystal and O/W micro-emulsion.(2) In layer liquid crystal, SO〓 mainly combined with amine salt cation by two oxygen atoms in bridge.(3) In UV-VIS spectrum of layer L. C., there is an absorption about 500 nm and "light short circuit"appeared about 430 nm. These phenomena may be very important for measuring the distance between the layers of the L.

研究发现该体系随水相含量的增加，胺盐发生不同形式的有序缔合，分别形成了W/O型微乳液、&节-结&型链状缔合体、层状液晶和O/W型微乳液：在层状液晶中，SO〓主要以桥式双齿配位形式存在，中性胺分子有利于体系中液晶的形成；层状液晶于500nm波长处有一吸收峰，在430nm附近发生&光短路&现象，该现象可能对测定层状液晶的层间距有重要意义。

This design is aims at the situation of Qianjiaying Mine existing protective device electivity leakage protection malfunction, development the high voltage intelligence switch has the protection function of leakage, overload, short circuit and monitor, thus reduces the breakdown power cut scope,and it is advantageous for the troubleshooting, reduces the power cut time, enhances the reliability of power supply.

本设计是针对钱家营矿现有的保护装置选择性漏电保护功能失效的情况，开发具有漏电、过载、短路和监视等保护功能的高压智能开关，用以减小故障停电范围，便于寻找故障，缩短停电时间，提高供电的可靠性。

A new solution is put forward for the irrecognizability of transformer stable state circuit equation model. Simulation and test indicate the method rational and effective.

电力变压器绕组变形是指在电动力和机械力的作用下，绕组的尺寸和形状发生不可逆的变化，包括轴向和径向尺寸的变化、器身位移、绕组扭曲、鼓包、匝间短路等。

At present,the analytic tools used for the power signals in microcomputer protection include FFT,Kalman filter and finitely shock response filter,etc.They are effective to analyze stationary signals but localizable for unstationary signals analysis.Especially it is difficult to identify nonlinear fault,e.g,the nonlinear high impedance short trouble is along-term unsolved problem of power system.

目前，用于微机保护中的电力信号分析工具有FFT、Kalman滤波器、有限冲激响应滤波器等，它们对于平稳信号的分析是高效的，但在分析非平稳信号中有其局限性；尤其对非线性故障识别困难，如探测高阻抗非线性短路故障便是电力系统一个长期没有很好解决的问题。

The transient and dynam ic process of breaking step before and after interconnection,and the behavior of breaking step protection and splitting device are also analyzed.

建立了福建电力系统及其与华东电网互联的模型，通过 EEAC直接法研究了系统主网架线三相短路极限切除时间，通过仿真算法研究了联网前后系统失步的类型和暂态、动态过程，并分析了失步保护和失步解列装置的行为，提出了设置防止灾变的安全自动化系统方案建议。

A new method is described for determining the microwave dielectric properties of solid materials,for example agricultural products,mineral,of known densities from the dielectric properties of pulverized samples measured by employing the short circuited waveguide principle at a few different bulk densities.

本文介绍一个测定不能进行机械加工的&坚实材料&的微波介电特性的新方法。将这类材料研碎，成为&空气－粒子&混合物。应用短路波导方法，在几个不同的混合物&松密度&上测量其介电特性。

Too low an inductance gives rise to a very high short circuiting current and consequently high pinching rate.

一个太低的电感引起非常高的短路电流和从而高的折磨的比率。

The main research work focused on is as followed: The mechanism of short circuiting process has been seriously investigated. The different control modes with different range of specification are adopted from the point of view of process stability and characteristic of the range. It has been proved to be reasonable and effective.

论文主要进行了以下几个方面的研究：在对短路过渡过程的机理进行深入研究后，从改善不同规范区间过程稳定性入手，根据大小规范区间的不同特点设计波形，提出了分规范波控的思想。

This paper discusses design and realizable methods of remote test output interface from logical design angle.

本文从逻辑设计的角度讨论遥测输出接口的设计及实现方法。

This also 星体投射plies to buildings, structures and geological features.

这也适用于建筑物和地质特征。