矩

On the basis of the concept of space vector, the basic theory of DTC is analyzed. Also a representative DTC strategy improving operation performance of induction motors, which is called DSVM, is introduced.

在阐述空间矢量概念的基础上，分析了传统两电平逆变器异步电机直接转矩控制的基本原理，并引入了一种典型的直接转矩控制改进算法DSVM。

Experiment results show that binary tree SPIHT suits to true bidimensional wavelet decomposition and it is testified that in true bidimensional wavelet decomposition, the compression effect is comparable between image decomposed by wavelet FB with low order VMs but good interpolating characteristic and that with higher order VMs.

实验证实了二叉树的编码更适合纯二维小波分解，同时也证实了在纯二维小波分解中内插性能好的低阶消失矩的小波滤波器能够产生与高阶消失矩的小波滤波器相同或更好的压缩效果。

Good performance of the electromagnetic torque is dependent upon reliable operation ofthe feedback sensors such as position sensors, current sensors and voltage sensors. In event ofsensor failures, HEVs may accept permanently reduced drive performance and even bringabout fatal traffic accidents. In practical applications, the most common failure of controlsystems is sensor faults. Therefore, it is also necessary to develop a torque control system ofinduction motor for HEVs with sensor failures.

电机转矩控制精度依赖于位置、电流及电压传感器精度，一旦这些传感器出现故障，轻者造成车辆性能永久下降，重者引发严重安全事故；在实际应用中，控制系统传感器出现故障频率最高，因此对传感器故障状态下的车用电机转矩控制研究具有同样重要的意义。

Collared device for reducing stress shielding of calcar should be recommended for osteoporosis patients.

因此，骨质正常者应该选用非骨水泥假体，以减少大转子与股骨矩区域的应力遮挡；而骨质疏松者最好选用有肩托的假体，以减少股骨矩处的应力遮挡作用。

Results: The BMD decreased fastest in the first year after operation, as the postoperative time prolonged, the BMD decreased markedly at the medial part of the stem especially at the calcar and under calcar part, and at the medial part of the stem and the large trochanter, the BMD at the lateral lower part of the stem decreased at a lower extent, the femur shaft part under the tip of the stem lost the lest bone.

结果：术后第一年骨丢失多，随术后时间延长，假体柄内侧尤其是股骨矩及矩下R7、R6区、假体尖内侧R5和大粗隆区R1区骨丢失最明显，假体柄外侧中、下R2、3区端次之，假体柄尖远端股骨干处R4区骨丢失相对较少。

The light intensity distribution was characterized by Fraunhofer diffraction when the projection of light source located in the symmetry center of rectangular aperture and the size of aperture is small enough .

根据菲涅尔-基尔霍夫衍射积分得出矩孔菲涅尔衍射的光强分布表达式，对该表达式作了数值计算，分析了矩孔尺寸对衍射光强分布的重要影响。

The modified double weight function method is to introduce new weight functions doing subtraction between two negative exponential-type functions. For a Pearson type three probability distribution, the MDWF is able to make estimations of the Standard Deviation and Coefficient of Skewness C(subscript S from the second-order weighted central moments reduced to the first-order weighted central moment estimations.

修改的双权函数法是将两个负指数型函数之差所构成的函数类取作权函数，对于皮尔逊Ⅲ型分布，它能使σ和Cs的估计由原权函数法的二阶加权中心矩降低为一阶加权中心矩估计。

In this paper, on the basis on analyzing of asynchronous motor, DTC principle and torque ripple characteristic, the vector subdivision method is studied particularly, and at the same time, an improved optimized switch stable method is proposed.

在分析了异步电机数学模型、直接转矩控制原理以及转矩脉动特性的基础上，对基于空间电压矢量的矢量细分法进行了详细的研究，并在此基础上提出了一种改进优化开关表法。

A higher moment method with the basis of Chebyshev polynomial ｛T_k｝ is presented,which is used in the reliability analysis of engineering structures.

1引言在工程结构的可靠性分析中，一次二阶矩法(包括中心点法、JC法、映射变换法和实用分析法)以及二次二阶矩法得到了广泛应用[1，2]。

A new calculation method of dynamic torque of coiler is introduced. The method simplifies calculation process of dynamic torque and improves calculation accuracy of inertia moment, and it does not need the parameters given by coiler designers.

本文介绍了一种卷取机动态转矩计算的新方法，该方法不但简化了动态转矩的计算过程，提高了转动惯量的计算精度，而且计算过程的参数不再依赖于设备设计者所给出的参数。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。