瞬时的

In this dissertation,an investigation is made involving 95 verbs and 450 sentences with reduplicated verb.

本文调查了95个动词共450个动词重叠句，就及物性的十个参数：参与者、动作性、体貌、瞬时性、意愿性、肯定性、语态、施动力、宾语的影响性和宾语的个体性对这些句子进行及物性计算，得出结论：动词重叠句较基式动词句及物性低，进而对450个动词重叠句出现的语篇环境进行考察，证明了其作为背景句的假设。

When two axes make the synchronized reverse rotation, on each instantaneous two axis eccentric qualities produce the centrifugal force of inertia, always mutually counterbalances along x-x force component, but always mutually superimposes along Y-Y force component, this has formed the sole this direction simple harmonics strength.

两轴作同步反向回转时，每一瞬时两轴上偏心质量所产生的离心惯性力，沿x-x方向的分力总是互相抵消，而沿Y-Y方向的分力总是相互叠加，这就形成了单一的该方向的简谐力。该力作用在筛箱上，驱动筛箱作轨迹为直线的往复振动。

The dynamics equation is established using Lagrange method, and the formula of free frequency is deduced according to modality analysis of general viscous damp. Instantaneous wallops are applied to X, Z dimension respectively, observing the movement of the moving platform, and use ADAMS software to validate the free frequency of the system.

采用Lagrange方程建立了系统动力学方程，根据一般粘性阻尼系统的模态分析法，推导了求解固有振型的公式；分别在X、Z方向上施加一定的瞬时冲击力，观察动平台的运动情况，并采用ADAMS软件验证系统的固有频率。

Research on cone/bit speed ratio simulation model of tri-cone bit s;2. In this paper, the kinematics simulation model of tri-cone bit s was established according to the roller cone bit geometry and kinematics.

根据钻头几何学和运动学建立起了随钻运动的三牙轮钻头的计算机运动学仿真模型，该仿真模型既表示出了钻头上各牙齿的形状、大小和在钻头上的分布情况，又可真实反映钻头钻进过程中各牙齿的瞬时位置和相互关系。

The article introduces two arithmetic of partial differential,and analyses the method of using compare the current vector of coupler breaker,and provides sampling arithmetic and vector arithmetic.

母线微机保护装置已发展的比较成熟，装置通用的选择故障母线的方法是利用总差动和分差动相配合；文中介绍了利用分差动选择故障母线时的两种算法，分析了利用母联电流方向比较元件选择故障母线的方法，并从瞬时值方面和向量值方面提供了两种算法。

Based on the previous results, the method to derive creep constructive model from the indoor experiment data is studied, and these study works are also finished: the reasonable method to determine instance elasto-plastic deformation according to experiment curve, the optimization method to perform curve fitting based on experiment data, the universal method to derive creep constructive model from experiment results.

4在已有研究成果的基础上，对从室内试验数据成果导出流变本构模型的方法进行探讨，研究从室内流变试验曲线上确定瞬时弹塑性变形的合理方法，以及对流变试验数据进行曲线拟合的最优化方法，探讨由室内试验数据成果导出流变本构模型的一般性方法。

In the case of loadingalong curved strain path,the author discovered that the instability mentioned aboveoccured only if the curvature changed from large to small.The drop and recovery instress obviously depend on the curvature and its rate.

对曲线应变路径的情形，本文发现只有在曲率由大向小变化时才出现上述瞬时软化响应，且曲率改变变化趋势时曲率的大小及路径弧长对应力大小的降低和重新强化的程度及变化率的影响较为明显。

The conditions for the existence of crank for Watt's mechanism, a basic type of one-degree-of-freedom planar six-bar mechanism,are investigated with the triangular dividing method and the method of instantaneous fixing of the driving bar.

本文采用平面杆机构的三角形划分法及主动杆瞬时凝结法探讨了单自由度平面六杆机构的一种基本型式——Watt型机构的曲柄存在条件；并用取极限的方法得到了其诱导机构的曲柄存在条件。

Except the single leave average area, various dissection values in seedling time are lower than canopy leave in mature phase. This is the same results compared to leaf dissection between higher layer and lower layer under ex-situ conservation.

迁地成年阶段望天树的冠层叶通过一系列的生理机制来适应冠层空间高温、强光和低湿的环境，而林下幼苗的叶片也通过另外的一套生理机制来适应林下低温、弱光、瞬时光斑和潮湿的环境。

Then a numerical method, called Stepping Impulse Method, is introduced in the thesis to solve the percussion problem on hypothesises of instantaneity and Poisson's coefficients of restitution.

为处理复杂多体系统的斜碰撞问题，我们根据Poisson给出的冲量恢复系数的定义和碰撞的瞬时假定，给出了用于解决多体系统单点碰撞冲击问题的数值求解方法：步进冲量法。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。