相界

The author creates the AutomaticallyDiscriminational Model for the Classification of Sandstones System, thatis to say, people can complete the vastly sample s classification of sandstonesaccurately and swiftly, meantime, diminish the possibility of mortal mistake. Based on the study of the basic sandstone component before embedding, the typeof authigenic mineral, and the forming mechanism of porosity in Upper Paleozoicreservoirs in Ordos basin, the author selects the reasonable experiment objects forWater-Rock Interaction modeling study, designs the relatively reactant and resultantduring the diagenesis period, builds the solid-liquid thermodynamics model with theprinciple of thermodynamic phase equilibrium for kinds of primary minerals (potashfeldspar, albite, anorthite, and pyroxene, hornblende) which dissolve in acidic media,and forms the corresponding thermodynamics test database.

在对鄂尔多斯盆地上古生界储层砂岩埋藏前组成、自生矿物类型和孔隙构成研究的基础之上，确定合理的沉积盆地水—岩相互作用模拟研究的实验对象，设计了埋藏成岩过程有关反应的反应物和可能的生成物，并通过热力学相平衡原理，建立了碎屑岩在埋藏成岩过程中各种骨架颗粒(钾长石、钠长石、钙长石以及铁镁暗色矿物中的辉石、角闪石等)在酸性介质条件下发生溶解的固体—流体相化学反应热力学计算模型，并获得了相应的热力学数据库，在此基础上对储层砂岩中主要造岩矿物(钾长石、钠长石、钙长石以及铁镁暗色矿物中的辉石、角闪石等)在埋藏成岩过程的酸性介质条件下发生溶解的热力学习性进行了论述。

Sb can combine with Cu and P to form a low melting point compound which lowers the melting point of binary Cu-8P eutectic alloy by nearly 200℃. Bi and Cu can create compounds with low melting point(270℃) distributing at the boundaries and that is the reason why the melting point of (Cu-8P)-Bi is lower than that of binary Cu-8P eutectic alloy. The eutectic cluster can be refined with the addition of Fe, and that is the reason why the addition of Fe can decrease the melting point of Cu-8P alloy. Two means of decreasing the melting point of Cu-8P are found.

一定量的Sb与Cu， P形成低熔点相，从而大幅降低了Cu-8P合金的熔点，使其熔点降低近200℃；加入少量Bi后， Bi与Cu在共晶团晶界上形成熔点为270℃左右的低熔点化合物，且Bi的加入明显细化Cu-8P合金共晶团，从而使Cu-8P合金的熔点降低；加入Fe能明显细化Cu-8P合金的共晶团，使层片间距由8μm减为2μm以下，并使共晶团由层片状向短棒状转变，虽然Fe与Cu形成熔点为806℃的高温相，但Fe的细化作用使得Cu-8P合金的熔点降低，但降低幅度不大。

Thermal exposured at 175 ℃ for 100 h and 500 h, the yield strength decreases by 5.5% and 14%, and the elongation decreases by 4% and 9.3%, respectively. The fact that S′(Al2CuMg) precipitates get coarsen and the precipitate-free-zones get wider are responsible for the decline of the tensile properties of 2124-T851 aluminum alloy under thermal exposure condition.

于175 ℃热暴露500 h屈服强度和伸长率就分别降低14%和9%；于热暴露条件下，2124-T851合金拉伸性能衰退的主要原因是合金固溶体基体内主要强化相S′(Al2CuMg)相粗化以及晶界无沉淀析出带的宽化。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100℃ for 24 h, retrogression at 200℃ for 7 min, and reaging at 100℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5% H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the micro- structure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa，767 MPa和9.1%，显示优越的综合性能。

Thermal exposured at 175℃ for 100 h and 500 h, the yield strength decreases by 5.5% and 14%, and the elongation decreases by 4% and 9.3%, respectively. The fact that S'(AI2CuMg) precipitates get coarsen and the precipitate-free-zones get wider are responsible for the decline of the tensile properties of 2124-T851 aluminum alloy under thermal exposure condition.

于175℃热暴露500h屈服强度和伸长率就分别降低14%和9%；于热暴露条件下，2124-T851合金拉伸性能衰退的主要原因是合金固溶体基体内主要强化相S'(Al2CuMg)相粗化以及晶界无沉淀析出带的宽化。

To β-Si3N4 transformation and β′-Si3N4 grain growth as well as the devitrification and crystallization of amorphous phase may induce the fiber reinforcing effect, which affects the flow behavior of superplasticity for Si3N4 ceramics.

在Si3N4和Sialon陶瓷的超塑性变形中，α→β-Si3N4的相变以及β-Si3N4的长大和晶界玻璃相的析晶引起的纤维强化，将影响Si3N4陶瓷超塑性的流变特性。

Chapter Three gives a textual interpretation of siting Yinyangzhai, including the map of the diagonal dividing line of South Chen and North Xu, and the directions of punishments and rewards of Yinyangzhai and the relation between the heavenly circulation and the lucky days for building Yinyangzhai, and analyses the popular citing methods of the whole series.

第三章解读阴阳宅相宅术，包括阴阳宅的辰南戌北斜分一界之图，阴阳宅的刑祸福德方，天道运行与阴阳宅修造吉日的关系、太岁与修造忌日的关系等，剖析当时流行的阴阳宅经的一整套相宅手法。

The error between the calculation and the test was approximately 10% in FeAl at room temperature.

在Orowan理论基础上，仔细考虑了取向变化，超位错组态能量（部分位错弹性能，相互作用能和反相畴界能）对超位错线张力的影响，推出了超位错绕过弥散相粒子时屈服应力增量的计算方法。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。