直角轴

At least one through-bore in each of the drill guide arms guides a drill bit at right angles into the work piece, with each through bore (17, 18) having an axial length sufficient for guiding a hand held drill to drill a work piece bore at right angles to the joint surface.

在每个钻孔导向臂中至少有一个通孔，用于以直角将钻头导向到工件中，每个通孔（17，18）都在轴向上足够长，以在与连接表面大致成直角的方向导引手持钻头来钻出工件孔。

In view of the general relationship between corporate income tax burden and scale of enterprises, in a rectangular coordinate system, suppose that ordinate axis stands for tax burden and abscissa axis stands for scale of enterprises, then the curve of tax burden of three cities' enterprises is like a flat S. that's to say, tax burden of the smallest enterprises is relatively high, that of enterprises scaled from 5 million to 10 million yuan is the lowest, and then tax burden increases with the scale going up. The trend continues until the scale of enterprises is beyond 100 million yuan and the top point appears. When the scale of enterprises expands to 800 million yuan, the tax burden starts to turn down and is lower than that when the scale of enterprises is beyond 100 million yuan.

就企业所得税负担与企业规模的一般关系看，如果以直角坐标系的纵轴表示税负，横轴表示企业规模，那么随着企业规模的变大，三城市企业的税负曲线呈一个平躺着的S形状，即规模最小的企业税负较高，500到1，000万元企业的税负率最低，然后企业的税负率开始随规模的增加而提高，这种趋势一直延续到企业规模超过1亿元时达到最高点，待企业规模继续扩张到8亿元左右时，税负开始回落，并将低于原先超过1亿元时的水平。

Rossi can offer a wide range of products including parallel, right angle and coaxial shaft gear reducers and gear motors, worm and planetary ones.

公司可以提供的产品范围非常广阔，其中包括：平行轴，直角轴，同轴减速机及减速电机，蜗轮蜗杆及行星系列。

Unfasten the Decl. clamp and turn the optical tube until it is nearly at right angles to the polar axis. If you do not do this, the polar axis scope will be shaded with the Decl. axis and can not be used.

松开赤纬制动钮并转动望远镜镜筒直到它与极轴镜的角度接近直角，如果你不如此做，极轴望远镜将被赤纬轴遮挡而无法使用。

If you have a spinning gyroscope and you try to rotate its spin axis, the gyroscope will instead try to rotate about an axis at right angles to your force axis; this is precession.

如果您有纺纱陀螺仪和您尝试旋转，其旋转轴，陀螺反而会尝试旋转约一轴成直角，以您的力量轴；这是岁差。

To produce an isometric projection, it is necessary to view an object such that its principal edges are equally inclined to the viewer and hence are foreshortened equally.

当空间的直角坐标轴向轴测投影面倾斜的角度相同时，用正投影法得到的投影图称为正等轴测图。

Prism series:Triangular prism, right-angled prism、Four prisms, pentagonal prism, half pentagonal prism ,polyhedron prism, Rotor drum prism, Simite roof prism,right-angled roof prism,Amici Frisms,Four pyramid reflectors,pyramid,V- prism, Wedge Prism/ Folds the axis Prism, Wedge-shaped prism ,Trapezius prism, Cube prism,Reference prism,Target, Changes the prism, Trapezius roof prism,V- roof prism,Compound/Abbe prismAnd other combination prism and so on

棱镜系列：三棱镜、直角棱镜、四棱镜、五角棱镜、半五角棱镜、多面体棱镜、转鼓棱镜、斯密特屋脊棱镜、直角屋脊棱镜、五角屋脊棱镜、分光棱镜、四棱锥反射镜、角锥、道威棱镜、楔角镜/折轴棱镜、楔形棱镜、斜方棱镜、立方棱镜、参考棱镜、靶标、转向棱镜、斜方屋脊棱镜、道威屋脊棱镜、复合/阿贝棱镜及其他组合棱镜等。

Pipe heat causes linesr expansion and rurtherresult in tensile stress in the direction of pipe xale to make cracks in direction perpendicular to the axle,in the case ,the stress value is obtained by ormula=E,and if ,it is estimated with 15mm LG PEX-A Pipe as base,the sectional breaking rorce is estimated approx.7.6kg/cm2,being much more little comparing with the concrete bearing force=1,536kg/cm2and its not needed to be anxious to concrete cracking rising.

由于管子的线性热膨而使管子受轴向伸长力，从人在与管轴成直角的方向上产生裂缝，这时的应力接计算，PEX－A按直径15mm标准计算进断面破坏强度约为7.6kg/cm2，比混凝土的支持力1.58kg/cm2小得多，所以不需要考虑管子对混凝土的破坏作用。

Wherein said first yoke axle is coupled at a right angle to a hinge line of said first one of said controllable devices; wherein said second yoke axle is coupled at a right angle to a hinge line of said second one of said controllable devices; and wherein said hinge line of said first one of said controllable devices is skewed relative to said hinge line of said second one of said controllable devices.

其中，第一枷锁轴耦合在一个直角的铰链线表示，第一个表示可控装置；其中第二枷锁轴耦合在一个直角的铰链线第二之一说，可控装置；和其中说铰线说，第一个说，可控器件倾斜相对说铰线第二之一说，可控设备。

An axis system is composed of an origin point and three orthogonal axes.

一个坐标轴系统是由一个原点和三条直角轴组成。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。