直径的

The experimental results show that 1 the charge density coefficient used in the experiment is suitable; 2 the power of explosion is balanced and fully used; 3 the diameter of broken strip of the long hole standing shot in kaolin mine is about 100~150 mm and the rock bodies in the broken circle are debris; and 4 the diameter of the crack strip is about 700~800 mm.

结果表明：试验采用的装药密集系数的确定较适宜，均衡充分利用了爆炸能；高岭土深孔松动爆破孔的破碎带直径大约在100~150 mm，圈内岩体呈碎屑状，裂隙带直径约在700~800 mm；采用加强松动爆破可解决高岭土机械化开采存在的难题。

The onset temperature (T0), peak temperature, conclusion temperature and gelatinization enthalpy in DSC thermogram of rice starch were higher for the samples of high temperature regime than for the samples of optimum temperature.

不同品种类型间虽然存在着一定的差异，但变化规律基本一致；灌浆结实期温度明显影响淀粉粒的粒径大小，表现为高温处理下，直径大于7协m的大淀粉粒明显增多，而直径小于4林m的小淀粉粒明显减少。

According to the corneal thickness measured, a 7.0mm Hessburg-Barron corneal trephine was used to incise cornea into different deep defect in respective experimental group and placed 7.75mm SIS implant over the corneal defect.The implant was continuous sutured over the defect.The reaction of white rabbit corneal was observed and recorded everyday within postoperative observation period constituted 105 days.

根据所测量的家兔角膜厚度，使用直径7mm的HessBurg-Barron负压环钻分别对三组实验家兔的角膜植床取不同的深度，植入直径为7.75mm猪小肠黏膜下层，并将其连续缝合于植床上。

The allowable processing length of the wooden sticks is 60mm to 1800mm, the allowable diameter is 15mm to 120mm and the length and diameter can be customized according to the requirements of the customers. For instance, we can deal with the drilling, processing of the round wood, American-style screw thread and Italian-style screw thread to meet the different demands by the customers.

木柄类产品可加工的长度是60 MM-1800 MM ，可加工的直径是15 MM-120 MM，长度和直径都可以根据客户的要求定做，例如钻孔、加工圆头、美式螺纹、意大利式螺纹等，满足客户的众多需求。

In the design of the cavity mould, the diameter of the ejector pin is usually determined based on one's experience or according to analogism.

在型腔模设计中，推杆直径大小的确定一般是根据经验或依据类比法确定，这样确定的推杆往往与生产实际有一定的差距，通过对推杆的受力状况进行分析，从理论计算角度对推杆直径进行确定。

Study of applied anatomy of the infrarenal abdominal aorta will supplement the domestic data of abdominal aortic anatomy.

根据影像学资料得到的数据分析得出：肾动脉下腹主动脉的前后径为15.53±2.39mm，左右径为15.03±2.09mm；左髂总动脉终端的直径为8.47±1.05mm，右髂总动脉终端的直径为8.59±1.17 mm。

In the past decades, the precipitation behavior of transitional metals or their effects on electrical properties in monocrystalline silicon with small diameter have been exhaustively investigated, while the precipitation behavior of transitional metals in large-diameter Cz silicon or cast multicrystalline silicon are still poorly understood.

在过去的几十年中，虽然对小直径单晶硅中过渡族金属沉淀规律及其对材料的电学性质做了大量的研究，但是很少人研究大直径单晶硅以及铸造多晶硅中这些过渡族金属的沉淀规律。

The calculating results are compared with the test data in available literatures and FEM results. The research results show that the plastic hinge model is precise and correct, which can satisfy with the actual engineering demands. The collapse pressure of perforated liner casing decreases with phrase angle, initial ovalization and diameter-thickness ratio increasing, and increases with the yield stress. The phrase angle and initial ovalization have greatly influence on the collapse pressure. The collapse pressure of perforated liner casing is slightly changed with the diameter and density of perforation when the diameter and density are smaller than 12mm and 120 shots per meter, respectively.

计算结果表明：筛管抗挤强度的塑性铰模型具有很高的计算精度和准确度，可以满足工程实际需要；筛管抗挤强度随着射孔相位角、径厚比和初始椭圆度的增加而降低，随着屈服强度的增加而增加，相位角和椭圆度对筛管抗挤强度影响比较显著；在射孔直径小于12 mm、射孔密度小于120 孔/ m 时，筛管抗挤强度随射孔直径和射孔密度增加变化不明显。

Methods The surgical methods to resect pathologically confirmed parotid mixed tumor in 60 cases from January 1998 to December 2002 was analyzed retrospectively. Resection of tumor combined with partial parotidectomy was applied to 58 cases with maximal tumor diameter less than 4cm and total parotidectomy for 2 cases with maximal tumor diameter greater than 4cm.

对我院及上海第二军医大学附属长征医院1998年1月~2002年12月收治的60例经病理诊断的腮腺混合瘤患者行手术切除的方式进行分析。58例肿瘤最大直径小于4cm、患者行肿瘤及周围部分腮腺切除术；对2例最大直径超过4cm的肿瘤患者行腮腺全切除术。

XRD measurements indicated that the product powders are mainly the skutterudite with the cell parameter α=7. 768-7. 803〓. From the ED patterns of the whiskers and nanowires, we can find that the whiskers and nanowires are single crystals.

采用自行设计的水热-还原-合金化的方法以白磷、氢氧化钠和三氯化铁为原料分别在200-240℃和160-180℃制备了直径为0.5-4μm长径比为10-20的Na〓Fe〓P〓晶须材料和直径是20-80nm长度是500-4000nm的NaFe〓P〓纳米棒。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。