直径的

In this paper, model experiment research was carried, of which was based upon the forced settlement and rectification measure of some buildings on self-weight collapse loess area. At the same time, some conclusions are drawn: 1 the relationship between the soil stress deliquesce and quantity of slope, quantity of settlement of buildings and stress variety of soil body; 2 the relationship between the superimposed stress and quantity of slope, quantity of settlement of buildings and stress variety of soil body; 3 the relationship between quantity of slope, quantity of settlement of buildings and water injection quantity in hole; 4 the relationship between quantity of slope, quantity of settlement of buildings and diameter and interval of hole; 5 the relationship between stress variety of soil body and water injection quantity in hole and interval of hole.

本论文针对地处自重湿陷性黄土地区的建筑物和构筑物的迫降纠倾进行了模型试验研究，给出了自重湿陷性黄土地区建筑物迫降纠倾时1地基应力解除、附加应力与建筑物倾斜量、沉降量及土体应力变化的关系；2附加应力与建筑物倾斜量、沉降量及土体应力变化的关系；3建筑物倾斜量、沉降量与孔内注水量的关系；4建筑物倾斜量、沉降量与孔径和孔间距的关系；5土体应力变化与孔内注水量、孔直径的关系。

A critical need therefore remains for a rotary sealing device which reliably compensates for longitudinal and diametral expansion and contraction of the rotating dram, to reliably prevent the intrusion of unwanted air into the interior of the rotating dram of the kiln.

因此重要需要为可靠地补尝转动的微量的纵向和直径的扩展和收缩的一个转台式海豹捕猎设备依然是，可靠地防止不需要的空气闯入入窑的转动的微量的内部。

In chapter three, we study the lower orientable strong radius and strong diameterof the Cartesian product of graphs and prove that: srad(G_1×G_2)= 2r(G_1×G_2),sdiam(G_1×G_2)≤min{sdiam(G_1)+sdiam(G_2), 2(G_1×G_2), 4r(G_1×G_2)}. Furthermore,we establish three sufficient conditions for sdiam(G_1×G_2)= 2d(G_1×G_2)holds and determine the values of the lower orientable strong diameters of somespecial graphs. Moreover, we give the exact value of SDIAM, a lowerbound for SDIAM, an upper and lower bound for SRAD andSRAD, respectively.

在第三章，研究了笛卡尔乘积图G_1×G_2的最小强半径，证明了如下结果：srad(G_1×G_2)=2r(G_1×G_2)，sdiam(G_1×G_2)≤min{sdiam(G_1)+sdiam(G_2)，2d(G_1×G_2)，4r(G_1×G_2)；给出sdiam(G_1×G_2)=2d(G_1×G_2)成立的三个充分条件，并由所给出的充分条件确定了一些特殊笛卡尔乘积图的最小强直径的值；确定了SDIAM的确切值，SDIAM的下界，SRAD和SRAD的上、下界。

The septum (34) is further preferably configured to minimize or eliminate the negative pressure deflection normally associated with the withdrawal of the large diameter luer cannula (32) from an enclosed fluid filled lumen or chamber, by substantially isolating the lumen or chamber from the septum material displacement resultant from luer (30)insertion.

上述隔垫(34)的结构最好设计成能通过把空腔或腔室与因路厄氏连接器(30)插入后所造成的隔垫材料的移动隔离开来，以便减小或消除通常与大直径的路厄氏套管(32)的抽出联系在一起的，因负压而引起的变形。

We prepared the ordered porous alumina membrane by a two-step anodization method in oxalic or sulfuric acids, which is a self-ordered hexagonal array of cells with an adjustable pore diameter of 20-150nm and a different pore structures (i.e. Y-branched, dendriform, toothed and torous ones). Furthermore, the template-electrodeposition, vapor-catalytic growth, and controlled chemical etching were developed for well-aligned carbon nanotubes and oxide nanopillars with adjustable diameter, Al2O3-AlN one-dimensional heterojunction, Y-junction and dendriform metal nanowires, as well as Y-junction, and torous carbon nanotubes. The resultant one-dimensional junctions were characterized by XRD, SEM, TEM,HRTEM, and STM, and the field emission of the well-aligned carbon nanotubes and the luminescence of ZnO nanopillar array have also been mearsured.

完善和发展了阳极腐蚀法制备多孔氧化铝膜的方法，制备出了孔径在20-150nm之间可调和具有不同孔结构（如Y形、树枝状、锯齿状）的系列多孔氧化铝模板，在此基础上，利用电化学沉积、气相催化生长和化学控制腐蚀等方法，成功地生长出具有可调直径的碳纳米管和氧化物纳米柱有序阵列、Al2O3-AlN异质结纳米线、Y形和树枝状的金属纳米线以及Y形、藕节形和锯齿形的碳纳米管等多种一维结纳米材料及其阵列体系，探索了基于模板孔壁内沿生长一维结纳米材料的机制，较系统的研究了碳纳米管阵列的场发射性能和氧化锌纳米柱的发光性能，为低维纳米材料器件化提供了实验基础。

Electrophysciological indexes: in the experimental group ,the tardy rate of induced motorius action potential ,recovery rates of the amplitude of compound muscle action potential and twitch tension and tetanic tension of triceps surae muscle ,were significantly higher than in the control group.(4) Compared with the control group ,the triceps surae muscle wet weight was significantly greater in the experimental group.(5) histomorphological indexes: the count of myelinated nerve fibers ,diameter of regenerated axon,thickness of nerve myelin sheath and area of capillary were much more in the experimental group than in the control group.(6) observation of ultrastructure with the transmission election microscope: more abundant organella and maturer myelin sheath lay in the injured peripheral nerve of the experimental group, while not lay in the control group.

分别在术后第2、4、6周时进行各项指标的检测，结果发现：（1）实验组SD大鼠在整个实验过程中，其精神、毛发、体重，运动灵活性等一般情况优于对照组；（2）实验组的坐骨神经功能指数恢复率显著优于对照组，P＜0.01；（3）神经电生理指标：实验组运动神经诱发电位潜伏期的延迟率显著优于对照组，P＜0.05；复合肌肉动作电位振幅的恢复率显著高于对照组，两组比较第2周时P＜0.01，第4、6周时，P＜0.05；小腿三头肌单收缩力和强直收缩力的恢复率实验组显著高于对照组，P＜0.01；（4）小腿三头肌湿重的恢复率，第2、4周时实验组高于对照组，差异非常显著，P＜0.01；第6周时，差异仍显著，P＜0.05；（5）组织形态学指标：有髓神经轴突计数、再生轴突直径的恢复率，毛细血管面积，实验组均显著大于对照组，P＜0.01、P＜0.05、P＜0.001；实验组髓鞘厚度的恢复率也显著高于对照组，第2周时P＜0.01，第4、6周时，P＜0.05；（6）透射电镜超微结构观察：实验组再生轴突中细胞器丰富，髓鞘结构成熟，神经再生情况优于对照组。

A hotwire anemometer was used to measure the jet velocity at the exit of the precessing jet nozzle and the power spectrum density was obtained afterwards in order to analyze the precessing feature of the jet. It is shown that an obvious precession motion is generated in a nozzle even with a large expansion ratio E=10 and a small length-to-diameter ratio LD=2. The precessing frequency is mainly dependent on the nozzle diameter and the intake flow rate, increasing with the enhancement of the flow rate and with the reduction of nozzle diameter.

采用热线风速仪测量旋进喷嘴出口射流的速度，并对该射流进行功率谱分析以研究其旋进特性，结果表明，实验所用的膨胀比E=10、长径比L/D=2的喷嘴同样能产生明显的旋进射流，旋进频率主要取决于喷嘴的尺寸和射流的流速，并随流速的增大和喷嘴直径的减小而增大。

Exterior changes include redesigned 18-inch diameter aluminum-alloy wheels, bold new front and rear bumper fascias, Acura's signature design front grille, revised headlights and taillights, new exhaust tips and satin trim accents.

外部变化包括重新设计的18英寸直径的铝合金轮毂，新的大胆的前后保险杠，讴歌的签名设计的前格栅，前灯和尾灯的修订，新的排气管和缎装饰口音。

Feed aprons and stock guide plates with different angles and spacing are being equipped inside the cylinder, the structure can ensure that the material being dried runes along the direction of screwing under the impact of gravitation and keeps for a sufficient maintaining times and dispersity in the cylinder to make the material has sufficient heat exchange with the heat airflow from air heating furnace inside of the cylinder.

三筒烘干机是引进欧洲先进技术，由三个不同直径的同心圆筒彼此相嵌组合而成的。筒内装有不同角度和间距的扬料板和导料板，这种结构能够保证被烘干物料在重力作用下沿着螺旋的运动方向运动，在筒内保持足够的停留时间和充分的分散度，使被烘干物料在筒内与来自热风炉内的热气流进行充分的热交换。

It was demonstrated that the actin could be polymerized into discrete filaments of tree-like branch structure, random coil filaments cluster and long filaments with different diameters in F-buffer besides random aggregates. These polymerized filaments clearly exhibited the structural polymorphism and showed obvious difference from those assembled under the regulation by actin binding proteins or phalloidin.

研究发现，actin在体外通过自装配过程除了形成无序的蛋白堆积物之外，还能够聚合形成复杂的离散结构，包括树状分支的纤维丛、无规卷曲的纤维簇以及具有不同直径的长纤维等；这些大尺度纤维复合物明显不同于在ABPs或过量F-actin稳定剂参与下形成的由单根微丝和微丝束构成的聚合结构。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。