直径的

The research on the conditions of chlamydospore production for the liquid fermentation showed that, the better single factors were oat liquid media, 30℃, 120r/min surge culture, sucrose as carbon source,(NH_4)_2SO_4 as nitrogen source and the ratio of 20 to 1 for C/N. Under the better single factors mentioned above, the largest quantity of chlamydospore, i.e.3.05×10~7spores/ml, was obtained on the 10th day after culture.

木霉T-33菌株产生厚垣孢子的发酵条件研究表明，采用燕麦粉培养液、30℃、120r/min振荡培养、250ml三角瓶装入80ml培养液、接种5片活化2d的5mm直径的菌片，碳氮源选择蔗糖和硫酸铵，C/N为20/l，足适合T-33菌株产孢的最佳单因素条件(碳氮源实验基于Czapek培养基)；用这些最佳单因素组合(不包括碳氮源和C/N结果)培养木霉T-33绘制了产孢曲线，发现在培养第10d得到最大的厚垣孢子产量3.05×10~7个/ml。

At suitable intervals there were regular salutes of laughter, which might have been referred indifferently to the last-uttered or the forth-coming jest. We made many a "bran new" theory of life over a thin dish of gruel, which combined the advantages of conviviality with the clear-headedness which philosophy requires.

啊，我们有这等的谈话，隐士和哲学家、还有我说起过的那个老移民，——我们三个，——谈得小屋子扩大了，震动了：我不敢说，这氛围有多少磅的重量压在每一英寸直径的圆弧上；它裂开的缝，以后要塞进多少愚钝才能防止它漏；——幸亏我已经拣到了不少这一类的麻根和填絮了。

In a spouted bed made of stainless steel with internal diameter 92 mm and height 1000 mm ,by adding five kind powder particle s through intermittent inlet samples, the powder elutriation with temperate air was studied by changing such parameters as bed temperature, bed height, bed particle diameter, spouting velocity, aerating velocity.

在一内径92mm，高1000mm的不锈钢充气喷动床反应器内，以三种不同直径的玻璃珠为惰性粒子，采用五种不同的粉末物料为微细粒子，以空气为充气和喷动气体对微细粒子进行淘洗，综合考察了设备结构，物性，以及操作方式等对充气喷动床内微细粒子的析出率的影响。

In addition, a negative temperature coefficient of resistance can be observed in Sb nanowire arrays with diameter of 40nm while applying a 7T magnetic field perpendicular to nanowire axis.

研究了电参数变换对Sb纳米线的结晶态、择优生长方向、晶体生长速度的影响，研究了不同直径的单晶Sb纳米线的获得条件，探讨了这种方法对其它金属纳米线生长的普适性，讨论了脉冲电沉积控制晶体生长的机理。

By contrasting the experimental, simulated and theoretical value of the load-bearing capacity of three experiment objects, this paper intercepts pictures of destroy shape of the specimens and stresses and strain nephogram of steel tube, inner and outer concrete, and studies on them.

对3个不同钢管直径的T形钢管混凝土芯柱进行试验研究，在选择合理的材料本构模型的基础上，利用有限元软件建立3个试件的有限元模型并对其做轴压下的模拟。

In this research, five media, including extracts of rye and carrot in different combinations, were compared for colony diameter and sporangium production, which were investigated at intervals after inoculation in a complete randomized design.

本文采用完全随机设计，将晚疫病菌接种到黑麦与胡萝卜不同混合比例的5种培养基上，通过隔日调查的方法，比较其菌落生长直径的大小和产孢量的多少，以此作为衡量5种培养基培养效果的指标。

The dark sky leaving the area shows a three-foot diameter water lily with new collected water.

黑暗的天空留下的面积显示一个3英尺的直径的睡莲和新收集的水。

Zirconium containing MCM-41 molecular sieves with high surface area, good crystallinity and Si / Zr ratio from 20 -∞ were synthesized in a near neutral condition by using a sodium silicate as silicon source and a zirconyl nitrite as zirconium source.

MCM - 41与传统分子筛比较，最突出的特点是具有 1～ 5nm直径的孔道和 1 0 0 0m2 ·g- 1 左右的比表面，如此宽孔道尺寸的固体材料对于大分子的吸附和催化具有潜在的应用前景[1 - 3] 。

The experimental results are shown that the microstructure of QT600-3 by CO_2 laser quenching is Aphanitic Martensite+Graphite,and residual stresses are all compressive,which is above 120 MPa,they increase with laser power.

结果表明：经CO_2激光淬火后QT600-3的显微组织为隐晶马氏体+石墨，残余应力均为压应力，其值在120 MPa以上，且随着功率的增大而增加；相变层深度随着扫描速率和光斑直径的增加而减小，且随着功率的增大而增加；激光淬火后的材料组织结构比较均匀，有利于提高凸轮轴的使用寿命。

Next the discussion in this study, about an ellipse with an angle of attack and two circular cylinders with different diameters in the flow, the aim of this study is investigated for the ability of the present numerical method by solving the suppression of the vortex shedding flow behind the two-cylinder system which was kind of difficult to reach by a Cartesian grid method. In this study, the suppression of the vortex shedding flow is tested to solve a uniform flow past through two different diameter cylindrical in the flow field with Fractional Step Method and Immersed Boundary Method.The numerical method which we investigated is showed that the results of the problem is appropriable in other literatures.

接著探讨流过具攻角之椭圆柱体流场及流过圆柱抑制涡漩逸出之流场，目的是要研究利用控制圆柱来抑制下游涡流的流场行为，本文采用分步法配合内嵌边界法数值解析一均匀流流经两不同直径的圆柱流场，来测试抑制涡流逸出的问题，根据现有的数值结果发现试验运用了合适的方法且得到令人满意的结果。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。