盖螺栓

In the assembly of freight train wheels, bolts are assembled onto the axletree in-group with the bolt lid.

1引言铁路货车轮对的轴承采用的是组合螺栓端盖压紧结构，即采用三个紧固螺栓通过前端盖压紧轴承的内圈来紧固轴承。

Check the bolt and nut and filling press cover, it it become flexible during the transport or store, screw down it.

内腔进行去湿处理并检查各连接部位的螺栓、螺母和填料压盖等是否在运输和存放过程中产生松动，如发现应均匀拧紧。

The head block is made from duralumin, and the back block is made from bronze. Heat-treated high strength chromium manganese steel bolts were used for binding the PZT elements.

为了获得高速和大推力，驱动头选用硬铝材料，后端盖选用黄铜，压紧螺栓选用镀铬高强度钢材料。

4 Components in the guide ring seat surface, and to maintain stem vertically in a clean work surface; 4.5 Lubrication and installed on top of the spring washer bearings and bearing connecting rings, and lubricating the bottom of the spring washers, valve cover and gasket components will be placed in position inside the valve cover; 4.6 will regulate the bolt lock nut bolt screw to adjust the top.

4.4 将组件座于导环面上，并保持阀杆垂直地处于清洁的工作面上； 4.5 润滑并在顶部弹簧垫圈上安装轴承和轴承连接环，和润滑底部弹簧垫圈，将阀盖及垫圈组件放在阀盖内的位置上； 4.6 将调节螺栓锁紧螺母拧到调节螺栓的顶部。

Connect joint of mechanical seal with shaft seal water pipeline (For newly installed shaft seal water pipelines, please clean up or rinse out sundries such as welding dregs, sand which are remnant in pipelines in advance). Start shaft seal pump, unclose shaft seal pipeline valve and turn pump shaft by manpower, if leakage, that indicates dunghill exist on shaft seal end-cover, here gland bolts should be loosened to wash mechanical seal with clean water and then impact gland.

将机械密封的接口连通轴封水管路(新安装的轴封水管路应事先将残存在管路内的焊渣，泥沙等杂物清理或清洗干净)，启动轴封泵，打开轴封水管路阀门，人工转动泵轴，如有滴漏现像说明轴封端面有脏物存在，应将压盖螺栓松开用清水冲洗机械密封后，再将压盖压紧。

Connect joint of mechanical seal with shaft seal water pipeline (For newly installed shaft seal water pipelines, please clean up or rinse out sundries such as welding dregs, sand which are remnantin pipelines in advance). Start shaft seal pump, unclose shaft seal pipeline valve and turn pump shaft by manpower, if leakage, that indicates dunghill exist on shaft seal end-cover, here gland bolts should be loosened to wash mechanical seal with clean water and then impact gland.

将机械密封的接口连通轴封水管路（新安装的轴封水管路应事先将残存在管路内的焊渣、泥沙等杂物清理或清洗干净），启动轴封泵、打开轴封水管路阀门，人工转动泵轴，如有滴漏现像说明轴封端面有脏物存在，应将压盖螺栓松开用清水冲洗机械密封后，再将压盖压紧。

Please fasten the cap bolt.

请紧固压盖螺栓。

The key position bolt of the engine include Connecting rod, Crankshaft, Main bearing , Cylinder head , Flywheel and shock absorber bolt, all of which belong to bolt fastening.

发动机关键工位螺栓包括连杆螺栓、曲轴螺栓、主轴承盖螺栓、气缸盖螺栓、飞轮螺栓和减振器螺栓等均属螺纹联接。

The tuning hand wheel is connected to spindle of drive bevel gear. The tuner joint is inside case. The worm wheel is fixed on stepped shaft fixed by nut. The worm engage to the worm wheel is fixed inside case. The upper end of worm is connected to the driven bevel gear. The spindle of drive bevel gear across the hole on the upper cover is connected to the hand wheel.

其特征在于：壳体上有一槽体，调音手轮与主动锥齿轮的轴相连接，调音器接头安装在壳体相应调孔内，蜗轮固定在调音器接头后端的阶梯轴上，用螺母固定，与蜗轮相啮合的蜗杆固定在壳体相应的孔内，用空心螺栓将其固定，蜗杆上端与从动锥齿轮连接，从动锥齿轮与壳体之间有垫片，主动锥齿轮的轴穿过壳体上盖的孔内，并且与手轮连接，用固定螺栓固定上盖。

Included in the complete filling of the following letter of component parts inside the part or all of the combination of: packing, packing gland, packing nuts, rings, packing spring, packing flange, packing flange stud or single-head bolt , packing flange nuts, packing ring, packing isolated loop, blankets isolation ring, BeIIev Sichuan e springs and anti-extrusion ring.

包括在完整的填料函组件里的是下列零部件的部分或全部的组合：填料、填料压盖、填料螺母、套环、填料弹簧、填料法兰、填料法兰双头螺栓或单头螺栓、填料法兰螺母、填料环、填料隔离圈环、毛毡隔离圈、BeIIev川e弹簧和抗挤压环。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了