癸二酸的
- 与 癸二酸的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Produce trimellitic acid octyl three main export products and domestic production for enterprises supporting materials, production, domestic sales volume the first in the industry; trusted by the user as the quality of products, octyl sebacate export volume has .
所生产的偏苯三酸三辛酯主要与国内生产出口产品企业合作配套作原料,产量、销量居国内同行业之首;被用户誉为质量信得过产品,癸二酸二辛酯有批量出口。
-
On the basis of above works, dibutyl sebacate and 1、2-cyclohexanedicarboxylic acid diisobutyl ester were chosen to be absorbents of MA according to the solubility and property of solvents.
第二:在前一部分工作基础上,考虑了溶解度测定结果和溶剂本身性质选择有机溶剂癸二酸二丁酯和溶剂六氢化邻苯二甲酸二异丁酯作为吸收顺酐的吸收剂。
-
Transesterification between dimethyl sebacate and 1,2,2,6,6-pentamethyl-4-piperidinol was studied with tetraisopropyl orthotitanate ,lithium amide and di-n-octyltin oxide used separately as catalysts.
对癸二酸二甲酯与1,2,2,6,6-五甲基哌啶醇的酯交换反应进行了研究;分别考察了四异丙基钛酸酯、氨基锂、氧化二辛基锡3种催化剂的性能;采用氢核磁共振确定了产物的结构;考察了以四异丙基钛酸酯为催化剂时反应温度、反应时间、原料配比和催化剂用量对反应的影响。
-
Three plasticizers were used: namely dioctyl phthalate, di n butyl phthalate and di(-2-ethyl-hexyl)sebacate.
研究中采用的增塑剂为邻苯二甲酸二辛酯、邻苯二甲酸二正丁酯和癸二酸二辛酯。
-
The density, binding energy and radical distribution function of HTPB/plasticizers blends and binder hydroxyl-terminated polybutadiene, and plasticizer dioctyl sebacate, dioctyl adipate, dibutyl phthalate, dioctylphthalate were calculated by molecular dynamics simulation for evaluating compatibility of HTPB and plasticizers.
为评价端羟基聚丁二烯与增塑剂相容性的优劣,采用分子动力学模拟方法对纯HTPB、增塑剂癸二酸二辛酯、己二酸二辛酯、邻苯二甲酸二丁酯、邻苯二甲酸二辛酯及HTPB与增塑剂组成的共混物的密度、结合能和径向分布函数等进行了计算。
-
About 30 tons wastewater will be discharged for each ton production of sebacic acid in the present industrial process.
在目前的工业生产工艺中,每生产1吨癸二酸,需排放约30吨废水,废水中含有的主要成分为硫酸钠、苯酚、癸二酸以及其它一些脂肪酸等。
-
The influences of ratio of liquid to solid, concentration of ethanol in solvent and leaching time on recovery of phenol and caustic soda and yield of fatty acid and sebacic acid were investigated.
在癸二酸传统生产工艺中的裂解工序后增加浸取工序回收游离碱和苯酚,通过正交试验,考察了液固比、浸取剂浓度和浸取时间对氢氧化钠和苯酚回收及对脂肪酸和癸二酸产率的影响,确定最佳回收工艺条件为:液固比2.5,浸取剂为95%的乙醇水溶液,浸取时间为15min。
-
The air-dried unsaturated polyester putty was synthesized by linseed oil which is a cheap and regenerable material instead of expensive adipic acid and sebacic acid.
用廉价的可再生资源-亚麻油代替价格昂贵的己二酸、癸二酸合成原子灰用不饱和聚酯。
-
The results showed that intermidiate 1, 2-propanediol-sebacate of low relative molecular mass was synthesized with toluene-p-sulfoinc acid as catalyst, benzene as watercarrying agent, and of mole ratio of sebacic acid to 1, 2-propanediol of 1:4. The glass-transition temperatures of PPSC were below 0 ℃ which confirmed that PPSC would be in a high-elastic state of ambient temperature and human body temperature. PPSC was a elastomer with moderate crosslinkage, low module and high elongation, and had rapid degradation ratio (degradation degree more than 50%) in phosphate (pH value 7.4) at 37℃.
结果表明,以对甲苯磺酸为催化剂、苯为带水剂,在酸醇比为1,4的条件下可合成较低相对分子质量的中间体癸二酸聚酯二元醇;PPSC弹性体的玻璃化转变温度在0℃以下,于室温及人体温度下处于高弹态;PPSC为适度交联的、低模量高伸长的弹性体,其在37℃、pH值为7.4的磷酸盆缓冲溶液中具有较快的降解性(降解度超过50%)。
-
A series of PVC membrane electrodes with nicotine containing different plasticizeres such as octyl phthalate, nonyl phthalate and di octyl dicaproate, and electric active substances such as association of nicotine-tetraphenyl borane, nicotine-silicotungstic acid, nicotine-phospho-wolframic acid and nicotine-Reineckate ammonium were prepared.
以尼古丁为研究对象,研制了一系列含有不同增塑剂(苯二甲酸二辛酯、苯二甲酸二壬酯和癸二酸二辛酯)和电活性物质(尼古丁四苯硼缔合物、尼古丁硅钨酸缔合物、尼古丁磷钨酸缔合物和尼古丁雷氏盐缔合物)的PVC膜电极。
- 推荐网络例句
-
The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.
主要做了如下几个方面的工作:对伸臂位于顶部的单层框架—筒体模型进行分析,提出了等效转动约束的概念和转动约束刚度的表达式。
-
Male cats normally do not need aftercare with the exception of the night after the anesthetic.
男猫通常不需要善后除了晚上的麻醉。
-
Its advantage is that it can be used in smaller units.
其优点在于可以在较小的单位中应用。