界面

The four sets of stator bars including those retired from three large generators and the standby bar subjected to Dynamic Mechanical Analysis, Scanning Electron Microscopic and optical microscope observation. It was revealed from DMA that the peak value tan d m of mechanical loss thermogram tan d ~ T shift toward a higher temperature and a lower amplitude, indicating that the amount of movement monomers diminished greatly in the insulation aging process, the tan d 195, increased very slightly with the service time of insulation, showing the degrading of bonding properties at interface, and the presence of more defects in insulation. The observation of SEM and optical microscope showed that more and more voids appears in insulation, and delamination was formed due to development of voids in aging process.

对不同运行年数的线棒进行了 DMA 、 SEM 、光学显微镜等微观分析试验，动态力学分析发现(参见 Hao et al， CEIDP， 2002：404)，力学损耗温度谱 tan d ~ T 的峰值 tan d m 随老化时间向高温、低值方向移动，表明促成环氧发生玻璃化转变的活性侧基或发生局部运动的活性链段减少，分子链的刚性增强；195℃的力学损耗 tan d 195随老化时间有缓慢增大的趋势，表明有更多的能量耗散在界面处，界面的粘合性变差，甚至由于界面粘结不良出现微观缺陷； SEM 和光学显微分析发现(参见 Hao et al-2， IEEE DEI， 2003)，老化后的绝缘气隙增多，随着老化时间气隙不断扩展或相互连通，绝缘逐渐分层。

C Supports both Firmware Hub and LPC Memory Read and Write Cycles Auto-detection of FWH and LPC Memory Cycles C Can Be Used as FWH for Intel 8xx, E7xxx, and E8xxx Series Chipsets C Can Be Used as LPC Flash for Non-Intel Chipsets Flexible, Optimized Sectoring for BIOS Applications C 16-Kbyte Top Boot Sector, Two 8-Kbyte Sectors, One 32-Kbyte Sector, Three 64-Kbyte Sectors C Or Memory Array Can Be Divided Into Four Uniform 64-Kbyte Sectors for Erasing Two Configurable Interfaces C FWH/LPC Interface for In-System Operation C Address/Address Multiplexed Interface for Programming during Manufacturing FWH/LPC Interface C Operates with the 33 MHz PCI Bus Clock C 5-signal Communication Interface Supporting Byte Reads and Writes C Two Hardware Write Protect Pins: TBL for Top Boot Sector and WP for All Other Sectors C Five General-purpose Input Pins for System Design Flexibility C Identification Pins for Multiple Device Selection C Sector Locking Registers for Individual Sector Read and Write Protection A/A Mux Interface C 11-pin Multiplexed Address and 8-pin Data Interface C Facilitates Fast In-System or Out-of-System Programming Single Voltage Operation C 3.0V to 3.6V Supply Voltage for Read and Write Operations Industry-Standard Package Options C 32-lead PLCC C 40-lead TSOP

0第0页，本页显示记录0-0，共0条记录分0页显示C支持两种固件中心和LPC内存读取和写入周期自动的FWH和LPC的记忆圈C检测可以用于英特尔8xx系列，E7xxx，E8xxx系列芯片组和C可以用作FWH与至于非英特尔芯片组的BIOS应用柔性优化扇区开放16字节热门引导扇区，两个8 - Kbyte的，一个32字节部门，3个64 - Kbyte的C或存储阵列，线性预测编码闪光可分为四个统一为两个可配置的接口擦除的FWH / LPC接口为64 - Kbyte的行业，系统运行C地址/地址多路复用在制造过程中用于编程接口的FWH /线性预测编码界面C与33 MHz的PCI总线时钟 5信号通信接口进行操作，支持字节读取和写入引导扇区的顶部和WP C两硬件写保护引脚：任务型为所有其他部门 5个通用输入的系统设计的灵活性识别的多种设备选型部门登记销锁定为个别部门读取和写保护的A /阿复用界面C 11引脚复用引脚地址和8引脚的数据界面C促进快速系统内或外的系统编程的单电压3.0V至3.6V的操作供应的读取和写入操作业界标准的封装选项电压 32 -引脚PLCC 40引脚的TSOP

With the ubiquitousness of the web, many cmss ? are now classified as web cmss ?, either because they have a web-based interface or because they focus on a web-based delivery system over the internet or an intranet. plone provides a web management interface and web-based delivery system.

使用普遍存在的web，很多cms系统现在被分类为web cms，因为他们要么由一个web界面，或者因为他们主要集中于一个通过内部网或者因特网的web发布系统。plone提供了一个web管理界面和一个web发布界面。

Details of communications between the hardware,PLC programming control,virtual touch screen interface design and user interface design,and so,after running showed that the control system user-friendly and stable operation,the system design portability,and is worthy of promotion and use.

详述了硬件间的通讯、PLC控制程序设计、虚拟界面设计和触摸屏用户界面设计等，经过运行表明，该控制系统界面友好、运行稳定，系统设计方法可移植性强，值得推广运用。

Then the weak formulation of the control equations considering the contact constraint conditions has been developed. Combined the Lagrange multiplier and penalty function methods, the augmented Lagrangian method is used to treat the contact constraint and solved the non-linear and non-smooth problems of the mechanical response perfectly. A finite element model has been applied for the test project of the reinforced slope and to study the mechanism of the interaction of the soil and reinforced material.

本文在Lagrangian网格的控制方程中引入接触界面条件，并采用了经典的Coulomb摩擦模型作为界面切向面力的本构模型，继而发展了考虑接触约束条件的控制方程的弱形式；在求解方法上，综合了Lagrange乘子法与罚方法的优点，采用增广的Lagrangian方法处理接触界面约束，很好地解决了接触问题中的高度非线性和响应不平滑性。

The research overcomes the shortcomings of primers in common use, and breaks through the traditional astriction of absence of chemical bond between new and old concrete.

本研究克服了以往的界面剂仅能改善界面层宏观或微细观结构的缺点，突破了新老混凝土粘结层主要依靠范德华力提供界面粘结力而几乎不存在化学键作用的缺点。

In Chapter 3 relaxation in growth with a conservation law is studied, and reduced roughness of the surface due to the effect of relaxation is found. The last chapter includes discussions of point defects in conservational surface growth.

第三章研究了守恒界面生长中界面弛豫效应的影响，发现弛豫作用使得守恒生长的界面粗糙程度下降；第四章研究了杂质点缺陷的存在对生长表面的影响，发现存在于生长的活跃表面层中的点缺陷会使表面的局域粗糙度增加。

The dispersion of particles are also related to the interactionbetween nanosilver and polymer. Nanosilver dispersed well in PS, while form larger branchedclusters in PMMA, and polymers could prevent nanoparticles from aggregation. The interaction between nanosilver and polymers depends on the properties of polymers and treatment. XPS results indicated that no obvious interaction between nanosilver and PS was foundbefore and after heat treatment; for AS matrix, there exists a interaction between nanosilver and AN,moreover AN on the nanosilver surface could cyclize and lose N after heat treatment at 150℃ for1h; for PMMA matrix, there exists a interaction between nanosilver and O atoms, heat treatment at150℃ for 1h could lead to the reaction between Ag, S and O in the interlayer of composite andchange the interface interaction.

纳米银粒子的加入改变了聚合物体系对激光能量的吸收和转换方式，导致其激光离解方式的变化，通常此种粒子会促进聚合物的炭化，且在界面可能有诱导石墨化的作用；而银粒子自身的离解及其对基体激光离解的作用都受两相的界面相互作用的影响，即与聚合物基体的性质、后处理等有关，热处理后两相界面的变化对PS和AS体系的炭化影响不大，但PS体系中银团簇的最大原子聚集数减小；而对PMMA体系则基本上消除了激光炭化。

It is shown that nanoscale pyramid cone shapes are found on the metal film interface (100), serrate steps are found on the metal film interface (111), and cystiform shapes with terrace structure are found on the cross-section near the catalyst. Other faults have brittleness fracture characteristic with nanoscale clusters are found on the fault surface.

结果表明：包膜(100)界面有纳米级的棱锥状突起，包膜(111)界面上分布着锯齿状的台阶；金属包膜近触媒侧的界面断面表层分布着台阶形貌的胞状突起；断面其它断层断口呈现脆性断裂特征，断层表面分布着团簇状的纳米颗粒。

On the basis of identifying boundaries, the depositional cycles and spatial distribution of boundaries in the study area are analyzed.

在界面识别的基础上，对研究区沉积旋回及界面的空间配置进行了分析，认为不同级次界面的识别是高精度层序地层研究的核心，对于油田勘探和开发具有至关重要的作用。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。