界面

Except for three hilts, which have dislocated G interface and extended down to the bottom interface (whose depth is about 10km) of the upper crust, the other faults have ended above G interface at 3 to 5km depth, or have converged at G interface.

其中，除3条断裂错断结晶基底并向下延伸至上地壳底界面外，其他断裂均在深度3~15km以上终止或收敛于G界面之上。

Orientation method for the determination of grain boundary character distribution, single section trace method for the analysis of low??index grain boundary plane and five parameter method for the measurement of grain boundary plane character distribution are discussed significantly.

重点讨论了基于EBSD技术的晶界特征分布测定取向差法、低指数晶界面测定单一截面迹线法和晶界面特征分布测定五参数法。

Only when the fountain solution surface tension and ink are equal, the surface tension of the interface of diffusion pressure to zero, ink fountain solution and keep on the interface and to each other for invasion, Business card printing and membership card making effect is more desirable.

只有在润版液的暗地不抬力和油墨的暗地不抬力不等时，界面上的清除不抬为不整，润版液与油墨在界面上保留不绝对不均而互不浸润，制卡和会员卡制作成果才较为抱负。

If you are in an ideal balance between State-and-ink printing plate empty part of the attachthemselves fountain solution, such as graphic part attachthemselves ink, fountain solution surface tension and the surface tension of the ink of equal, both on the interface with the spread of pressure to zero, ink fountain solution and in the interface to maintain relative balance, non-infiltrante, in which case the business card printing and membership card making effect is desired.

如果在抱负的火不朱不均状况下，印版的空缺局部附着润版液，图文局部附着油不朱，只有当润版液的暗不天不抬力和油不朱的暗不天不抬力不等时，两者的界面上的清除不抬为不整，润版液与油不朱在界面上保留相差不均、互不浸润，这种环境下制卡和会员卡制息成果才抱负。

If you are in an ideal balance between State-and-ink printing plate empty part of the attachthemselves fountain solution, such as graphic part attachthemselves ink, fountain solution surface tension and the surface tension of the ink of equal, both on the interface with the spread of pressure to zero, ink fountain solution and in the interface to maintain relative balance, non-infiltrante, in which case the business card printing and membership card making effect is desired.

如果在抱负的火不朱不均状况下，印版的空缺局部附着润版液，图文局部附着油不朱，只有当润版液的暗不天不抬力和油不朱的暗不天不抬力不等时，两者的界面上的清除不抬为不整，润版液与油不朱在界面上保留相差不均、互不浸润，这种环境下制卡和会员卡制作成果才抱负。

The affects of crystal absorption for heat radiation on crystal growth,which include:the heat loss of the hot grower,the chara cteristic of temperature time of crystal growth,the pattern of fluid flow and the shape of interface,the interface inversion of crystal,the temperature distribution and the thermal stress distribution,are reviewed in this paper.

本文综述了晶体对熔体热辐射吸收对晶体生长的影响，包括对热腔热耗散的影响；对晶体生长温度时间特性的影响；对液流形态和固液界面形状的影响；对晶体界面反转的影响；对晶体中温度分布和应力分布的影响。

AgCuTi active filler metal exhibits a good wettability to brazing cBN, joint interface between filler metal and cBN is compact, and a reaction layer is formed between them.

AgCuTi 活性钎料对cBN的润湿性较好，界面结合紧密，并在界面处形成反应层。

Ag-Cu-Ti active filler metal exhibits a good wettability to brazing c-BN, joint interface between filler metal and c-BN is compact, and a reaction layer is formed between them.

Ag-Cu-Ti活性钎料对c-BN的润湿性较好，界面结合紧密，并在界面处形成反应层。

Ti element is found to aggregate, forming an ultra-fine reaction layer in the active filler metal-ceramic joint after 260℃/24hr aging treatment. Two different-color intermetallic compounds are observed in the interface of active filler metal-copper. One is Cu6Sn5 , which is closer to active filler metals;the other is Cu3Sn, which is closer to the copper substrate.

接合后之试片，经260℃/24hr时效反应后，发现Ti元素聚集於焊料与陶瓷界面处形成一层极薄的反应层且发现在焊料与铜之反应界面有了明显颜色不同之两层介金属层生成，靠近焊料端的介金属层为Cu6Sn5，Cu片端的是Cu3Sn；而Cu6Sn5化合物从原本未时效10μm成长为25μm。

It is most likely that only a part of the karst caves could be detected if the boundary of the karsts cave has a certain horizontal extension respectively to measurement layout, but the interface of the karsts caves is not completely smooth plane, and its normal direction is not perpendicular to the tunnel axis.

如果溶洞的边界相对于TSP测量布线有一定的横向延伸性，其边界面不一定是完全平滑的表面，但其法线方向与隧道轴线不完全垂直，这类溶洞有可能被部分探测，但探测精度还与溶洞界面两侧的波阻抗差、对地下水的探测、操作人员的数据采集经验和数据处理水平等有关。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。