电阻的

The nagetive removal of breakdown potential and decrease of polarization resistance indicate that stress plays an important role in the localized corrosion of LY12CZ.

破裂电位的负移知极化电阻的降低说明应力对LY12CZ的局部腐蚀有明显的影响。

In traditional, the working probe naturally sustaining repeated bending actions and wear, absolutely needs a mechanism to prevent it from being damaged, caused by the change of the probe's geometry and the increase of the contact resistance. Therefore, in this study, we develop a CMOS-based chip in connection with the electroformed probes to detect each of their counterforce, contact resistance to evaluate if their contact force and coplanarity are controlled within safe range.

传统上，探针常因为弯曲作动和磨耗，使几何形状产生改变，进而电阻值提升，使过大的电流通过探针而烧毁，或因共面度不佳部分探针未能确实接触IC焊垫误判成断路，故晶片的制作重点在於监测探针卡上个别探针的回馈力量，当探针量测IC时，可进行即时探针反作用力、接触电阻的检测，进而了解探针卡工作时受力是否均匀、平坦度是否符合要求等性质。

The sense FET provides a much more efficient way to measure current than conventional resistance methods.

场效应管的意识提供了一个更为有效的方法来测量电阻的方法比传统的电流。

When the sensor is forward biased at a current of 2 mA, the range of positive temperature coefficient of the sensor resistance is extended up to +300 C as a result of the minority current discontinuity and majority carrier injection.

当传感器在2mA的正向偏置电流下，由于少数载流子的不连续性以及多数载流子的注入，传感器电阻的正温度系数区拓宽到573K（＋300℃）以上。

It is inadvisable, therefore, to rely on the stability of high VALUE RESISTOR s for the performance of a SYSTEM .

因此，让系统的性能依赖于高阻值电阻的稳定性的做法是不可取的。

The results show that the overvoltage on substation equipments will increase with increases of the pole height,the pole surge ground-resistance in incoming lines and the distance between the position of lightning arrester and substation equipment.

仿真结果表明：随着进线段杆塔高度的增加、冲击接地电阻的增大以及避雷器与被保护设备间距离的增长，设备所遭受的过电压值随之增大。

Furthermore, the low-resistance metallic mirror layer of the mirror glass of the exterior mirror is subdivided into mutually electrically insulated segments by a grid structure, for example.

此外，将外视镜的镜面玻璃的低电阻的金属镜面层例如用一种网格结构分成相互之间电绝缘的部分。

However, the following example illustrates the technique for measuring the channel resistance of a two-pole Form A card.

然后，以下的例子举例说明测量一个双刀A型开关卡的通道电阻的方法。

After heattreatment, the surfactant removal causes the formation of ZnO nanorod-bundle structures. In addition, the addition of F_(127) could improve their gas-sensing property.Fourthly, Zn-W-O nano-composite materials were fabricated by sol-gel and surface-coated methods, respectively, and their gas-sensing property to VOCs was discussed.

第四，本文分别采用sol-gel方法与表面修饰技术制备了Zn-W-O体系纳米复合材料并讨论了气敏性能。X射线衍射、场发射扫描电镜以及气敏测试结果表明，采用这两种方法制备的Zn-W-O体系纳米复合材料中，均出现了具有白钨矿结构的高电阻的ZnWO_4相。

The major problems met in the CdTe solar cell development have been the difficulty of forming of stable low resistance ohmic coniacts to p-CdTe.

在CdTe太阳电池的制备过程中存在的最主要问题是：很难在p-CdTe上获得一稳定低电阻的欧姆接触。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。